欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: TLV2553IDW
廠商: TEXAS INSTRUMENTS INC
元件分類: ADC
英文描述: 11-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO20
封裝: GREEN, PLASTIC, SOIC-20
文件頁數: 13/29頁
文件大小: 603K
代理商: TLV2553IDW
TLV2553
SLAS354B – SEPTEMBER 2001 – REVISED SEPTEMBER 2002
20
www.ti.com
PRINCIPLES OF OPERATION
detailed description
Initially, with chip select (CS) high, I/O CLOCK and DATA IN are disabled and DATA OUT is in the
high-impedance state. CS going low begins the conversion sequence by enabling I/O CLOCK and DATA IN and
removes DATA OUT from the high-impedance state. The input data is an 8–bit data stream consisting of a 4-bit
address or command (D7–D4) and a 4-bit configuration data (D3–D0). Configuration register 1, CFGR1, which
controls output data format configuration, consists of a 2-bit data length select (D3–D2), an output MSB or LSB
first bit (D1), and a unipolar or bipolar output select bit (D0) that are applied to any command (from DATA IN)
except for command 1111b. The I/O CLOCK sequence applied to the I/O CLOCK terminal transfers this data
to the input data register. During this transfer, the I/O CLOCK sequence also shifts the previous conversion
result from the output data register to DATA OUT. I/O CLOCK receives the input sequence of 8, 12, or 16 clock
cycles long depending on the data-length selection in the input data register. Sampling of the analog input
begins on the fourth falling edge of the input I/O CLOCK sequence and is held after the last falling edge of the
I/O CLOCK sequence. The last falling edge of the I/O CLOCK sequence also takes EOC low and begins the
conversion.
converter operation
The operation of the converter is organized as a succession of three distinct cycles: 1) the data I/O cycle, 2)
the sampling cycle and 3) the conversion cycle. The first two are partially overlapped.
data I/O cycle
The data I/O cycle is defined by the externally provided I/O CLOCK and lasts 8, 12, or 16 clock periods,
depending on the selected output data length. During the I/O cycle, the following two operations take place
simultaneously. An 8-bit data stream consisting of address/command and configuration information is provided
to DATA IN. This data is shifted into the device on the rising edge of the first eight I/O CLOCK clocks. DATA
INPUT is ignored after the first eight clocks during 12- or 16-clock I/O transfers. The data output, with a length
of 8, 12, or 16 bits, is provided serially on DATA OUT. When CS is held low, the first output data bit occurs on
the rising edge of EOC. When CS is toggled between conversions, the first output data bit occurs on the falling
edge of CS. This data is the result of the previous conversion period, and after the first output data bit, each
succeeding bit is clocked out on the falling edge of each succeeding I/O CLOCK.
sampling cycle
During the sampling cycle, one of the analog inputs is internally connected to the capacitor array of the converter
to store the analog input signal. The converter starts sampling the selected input immediately after the four
address/command bits have been clocked into the input data register. Sampling starts on the fourth falling edge
of I/O CLOCK. The converter remains in the sampling mode until the eighth, twelfth, or sixteenth falling edge
of the I/O CLOCK depending on the data-length selection.
After the 8-bit data stream has been clocked in, DATA IN should be held at a fixed digital level until EOC goes
high (indicating that the conversion is complete) to maximize the sampling accuracy and minimize the influence
of external digital noise.
相關PDF資料
PDF描述
TLV2553IPWG4 11-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO20
TLV2553IPW 11-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO20
TLV2553IDWR 11-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO20
TLV2553IDWRQ1 11-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO20
TLV2556IDWRG4 11-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO20
相關代理商/技術參數
參數描述
TLV2553IDWG4 功能描述:模數轉換器 - ADC 12-Bit 200 KSPS 11 Ch Lo-Pwr RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
TLV2553IDWR 功能描述:模數轉換器 - ADC 12bit 200kSPS ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
TLV2553IDWRG4 功能描述:模數轉換器 - ADC 12-Bit 200 KSPS 11 Ch Lo-Pwr RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
TLV2553IDWRQ1 功能描述:模數轉換器 - ADC Auto Cat 12B 200KSPS 11Ch Low-Pwr Ser ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
TLV2553IPW 功能描述:模數轉換器 - ADC 12-Bit 200 KSPS 11 Ch Lo-Pwr RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
主站蜘蛛池模板: 永城市| 潼南县| 龙口市| 洛川县| 垦利县| 北川| 瑞安市| 威远县| 金山区| 曲靖市| 沂南县| 隆林| 招远市| 巴林左旗| 郴州市| 丹寨县| 太仆寺旗| 城市| 德惠市| 临颍县| 长汀县| 哈巴河县| 清徐县| 泗水县| 绥中县| 枞阳县| 曲靖市| 辽阳市| 乐清市| 县级市| 宁海县| 锡林郭勒盟| 盐亭县| 许昌县| 依兰县| 安国市| 麻栗坡县| 八宿县| 同江市| 武功县| 大足县|