- 您現在的位置：買賣IC網 > PDF目錄98252 > TLV2556IDW (TEXAS INSTRUMENTS INC) 11-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO20 PDF資料下載
參數資料
| 型號： | TLV2556IDW |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | ADC |
| 英文描述： | 11-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO20 |
| 封裝： | GREEN, PLASTIC, SOIC-20 |
| 文件頁數： | 19/37頁 |
| 文件大小： | 729K |
| 代理商： | TLV2556IDW |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
TLV2556
SLAS355A – DECEMBER 2001 – REVISED SEPTEMBER 2002
26
www.ti.com
PRINCIPLES OF OPERATION
Initially, with chip select (CS) high, I/O CLOCK and DATA IN are disabled and DATA OUT is in the
high-impedance state. CS going low begins the conversion sequence by enabling I/O CLOCK and DATA IN and
removes DATA OUT from the high-impedance state. The input data is an 8-bit data stream consisting of a 4-bit
address or command (D7–D4) and a 4-bit configuration data (D3–D0). There are two sets of configuration
registers, configuration register 1 – CFGR1 and configuration register 2 – CFGR2. CFGR1, which controls
output data format configuration, consists of a 2-bit data length select (D3–D2), an output MSB or LSB first bit
(D1), and a unipolar or bipolar output select bit (D0) that are applied to any command (from DATA IN) except
for command 1111b. CFGR2, which provides configuration information other than data format, consists of a 2-bit
reference select (D3–D2), an EOC/INT program bit (D1), and a default mode select bit (D0) that are applied to
command 1111b. The I/O CLOCK sequence applied to the I/O CLOCK terminal transfers this data to the input
data register. During this transfer, the I/O CLOCK sequence also shifts the previous conversion result from the
output data register to DATA OUT. I/O CLOCK receives the input sequence of 8, 12, or 16 clock cycles long
depending on the data-length selection in the input data register. Sampling of the analog input begins on the
fourth falling edge of the input I/O CLOCK sequence and is held after the last falling edge of the I/O CLOCK
sequence. The last falling edge of the I/O CLOCK sequence also takes EOC low (if pin 19 = EOC) and begins
the conversion.
converter operation
The operation of the converter is organized as a succession of three distinct cycles: 1) the data I/O cycle,
2) the sampling cycle and 3) the conversion cycle. The first two are partially overlapped.
data I/O cycle
The data I/O cycle is defined by the externally provided I/O CLOCK and lasts 8, 12, or 16 clock periods,
depending on the selected output data length. During the I/O cycle, the following two operations take place
simultaneously. An 8-bit data stream consisting of address/command and configuration information is provided
to DATA IN. This data is shifted into the device on the rising edge of the first eight I/O CLOCK clocks. Data input
is ignored after the first eight clocks during 12- or 16-clock I/O transfers. The data output, with a length of 8, 12,
or 16 bits, is provided serially on DATA OUT. When CS is held low, the first output data bit occurs on the rising
edge of EOC. When CS is toggled between conversions, the first output data bit occurs on the falling edge of
CS. This data is the result of the previous conversion period, and after the first output data bit, each succeeding
bit is clocked out on the falling edge of each succeeding I/O CLOCK.
sampling period
During the sampling period, one of the analog inputs is internally connected to the capacitor array of the
converter to store the analog input signal. The converter starts sampling the selected input immediately after
the four address/command bits have been clocked into the input data register. Sampling starts on the fourth
falling edge of I/O CLOCK. The converter remains in the sampling mode until the eighth, twelfth, or sixteenth
falling edge of I/O CLOCK depending on the data-length selection.
After the 8-bit data stream has been clocked in, DATA IN should be held at a fixed digital level until EOC goes
high or INT goes low (indicating that the conversion is complete) to maximize the sampling accuracy and
minimize the influence of external digital noise.
相關PDF資料 |
PDF描述 |
|---|---|
| TLV2556IPWG4 | 11-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO20 |
| TLV2556MPWREP | 11-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO20 |
| TLV2556MPWREPG4 | 11-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO20 |
| TLV320ADC3001IYZHT | 2-CH 16-BIT PROPRIETARY METHOD ADC, SERIAL ACCESS, PBGA16 |
| TLV320ADC3001IYZHR | 2-CH 16-BIT PROPRIETARY METHOD ADC, SERIAL ACCESS, PBGA16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLV2556IDWG4 | 功能描述:模數轉換器 - ADC 12-Bit 200 KSPS 11 Ch Lo-Pwr RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| TLV2556IDWR | 功能描述:模數轉換器 - ADC 12-Bit 200 KSPS 11 Ch Lo-Pwr RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| TLV2556IDWRG4 | 功能描述:模數轉換器 - ADC 12B 200 KSPS 11Ch Lo Pwr Serial ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| TLV2556IPW | 功能描述:模數轉換器 - ADC 12-Bit 200 KSPS 11 Ch Lo-Pwr RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| TLV2556IPW | 制造商:Texas Instruments 功能描述:12BIT ADC 200KSPS 2556 TSSOP20 制造商:Texas Instruments 功能描述:12BIT ADC, 200KSPS, 2556, TSSOP20 制造商:Texas Instruments 功能描述:12BIT ADC, 200KSPS, 2556, TSSOP20; Resolution (Bits):12bit; Sampling Rate:200kSPS; Supply Voltage Type:Single; Supply Voltage Min:2.7V; Supply Voltage Max:5.5V; Supply Current:3mA; Digital IC Case Style:TSSOP; No. of Pins:20; Input ;RoHS Compliant: Yes |
發布緊急采購，3分鐘左右您將得到回復。