欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: TLV5510INSR
廠商: TEXAS INSTRUMENTS INC
元件分類: ADC
英文描述: 1-CH 8-BIT FLASH METHOD ADC, PARALLEL ACCESS, PDSO24
封裝: PLASTIC, SOP-24
文件頁數: 6/20頁
文件大小: 330K
代理商: TLV5510INSR
TLV5510
2.7-V TO 3.6-V 8-BIT HIGH-SPEED ANALOG-TO-DIGITAL CONVERTER
SLAS124C– DECEMBER 1997 – REVISED DECEMBER 1999
14
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
PRINCIPLES OF OPERATION
functional description (continued)
The MSB comparator block converts on the falling edge of each applied clock cycle. The LSB comparator blocks
CB-A and CB-B convert on the falling edges of the first and second following clock cycles, respectively. The
timing diagram of the conversion algorithm is shown in Figure 19.
analog input operation
The analog input stage to the TLV5510 is a chopper-stabilized comparator and is equivalently shown below:
VDDA
ANALOG IN
S1
Vref(N)
φ1
φ2
S3
φ1
Cs
To Encoder Logic
φ2
S2
φ1
Cs
To Encoder Logic
φ2
S(N)
φ1
Cs
To Encoder Logic
Figure 20. External Connections for Using the Internal Reference Resistor Divider
Figure 20 depicts the analog input for the TLV5510. The switches shown are controlled by two internal clocks,
φ1 and φ2. These are nonoverlapping clocks that are generated from the CLK input. During the sampling period,
φ1, S1 is closed and the input signal is applied to one side of the sampling capacitor, Cs. Also during the sampling
period, S2 through S(N) are closed. This sets the comparator input to approximately 2.5 V. The delta voltage
is developed across Cs. During the comparison phase, φ2, S1 is switched to the appropriate reference voltage
for the bit value N, i.e., Vref(N). S2 is opened and Vref(N) – VCs toggles the comparator output to the appropriate
digital 1 or 0. The small resistance values for the switch, S1, and small value of the sampling capacitor combine
to produce the wide analog input bandwidth of the TLV5510. The source impedance driving the analog input
of the TLV5510 should be less than 100
across the range of input frequency spectrum.
reference inputs – REFB, REFT, REFBS, REFTS
The range of analog inputs that can be converted are determined by REFB and REFT, REFT being the
maximum reference voltage and REFB being the minimum reference voltage. The TLV5510 is tested with
REFT = 2.5 V or 2 V and REFB = 0.5 V or 0 V producing a 2-V full-scale range. The TLV5510 can operate with
REFT – REFB = 2.4 V, but the power dissipation in the reference resistor increases significantly (49 mW at 3.3 V
nominally). It is recommended that a 0.1
F capacitor be attached to REFB and REFT whether using externally
or internally generated voltages.
相關PDF資料
PDF描述
TLV5510IPW 1-CH 8-BIT FLASH METHOD ADC, PARALLEL ACCESS, PDSO24
TLV5510IPWR 1-CH 8-BIT FLASH METHOD ADC, PARALLEL ACCESS, PDSO24
TLV5510IPWLE 1-CH 8-BIT FLASH METHOD ADC, PARALLEL ACCESS, PDSO24
TLV5535IPWLE 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO28
TLV5535IPWRQ1 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PDSO28
相關代理商/技術參數
參數描述
TLV5510IPW 制造商:TI 制造商全稱:Texas Instruments 功能描述:2.7-V TO 3.6-V 8-BIT HIGH-SPEED ANALOG-TO-DIGITAL CONVERTER
TLV5535 制造商:TI 制造商全稱:Texas Instruments 功能描述:8-BIT, 35 MSPS, LOW-POWER ANALOG-TO-DIGITAL CONVERTER
TLV5535EVM 功能描述:數據轉換 IC 開發工具 TLV5535 Eval Mod RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V
TLV5535IPW 功能描述:模數轉換器 - ADC 8bit 35Msps 1ch 3.3V RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
TLV5535IPWG4 功能描述:模數轉換器 - ADC 8 Bit 35 MSPS Single Ch. Low Pwr RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
主站蜘蛛池模板: 梅河口市| 涿鹿县| 黑山县| 河源市| 阿坝| 金坛市| 枝江市| 瑞昌市| 合肥市| 寿光市| 万年县| 沭阳县| 兴化市| 砚山县| 南江县| 枞阳县| 深水埗区| 纳雍县| 界首市| 金阳县| 辽源市| 兴安县| 汉中市| 朝阳市| 罗江县| 嘉荫县| 山西省| 蓝山县| 红原县| 石林| 内黄县| 张家界市| 巧家县| 普兰县| 论坛| 黔东| 桂林市| 南通市| 忻州市| 高台县| 浦县|