- 您現在的位置：買賣IC網 > PDF目錄98267 > TMS3637D (TEXAS INSTRUMENTS INC) INFRARED, TRANSMITTER/RECEIVER IC, PDSO8 PDF資料下載
參數資料
| 型號： | TMS3637D |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 搖控器 |
| 英文描述： | INFRARED, TRANSMITTER/RECEIVER IC, PDSO8 |
| 封裝： | PLASTIC, MS-012AA, SOIC-8 |
| 文件頁數： | 11/54頁 |
| 文件大小： | 384K |
| 代理商： | TMS3637D |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁
5–2
5.5 V
OSCC
OSCR
(clock in)
VCC
OUT
C01
C02
C03
C04
C22
CA
CI
4 Reset Pulses
5 V
tsu2
C01 – C22
22 Security Bits
CA – C1
9 Configuration Bits
tw4
tw5
Figure 5–1. EEPROM Read Mode
5.2.2
Program Write Mode
The procedure to write the 31 security code and configuration bits to memory is described below (see
Section 3 for timing diagram):
1.
Set VCC to 5 V.
2.
Apply VCC + 0.5 V to OSCC. This voltage on OSCC forces the device into the program mode,
and the terminals are in the following configuration:
OSCR: program/read external clock input
OSCC: input for high-voltage programming pulse used to permanently store data in memory
(see Figure 5–2).
OUT: serial output of 31 data bits currently stored in EEPROM
IN: serial input for 31 bits of data to be stored
3.
After applying VCC + 0.5 V to OSCC (step 2), wait at least 50 ms to allow device to go into the
program mode.
4.
Apply exactly four clock reset pulses to OSCR (clock input). These reset pulses are applied
before clock input pulses for the 31 data bits that contain the security code and configuration bits.
The minimum duration of the clock reset pulses must be tw6 = tw7 = > 5 s, which equates to a
clock frequency <100 kHz.
5.
Apply exactly 31 clock input pulses to OSCR. This serves to clock in the 31 data bits that should
be applied to IN (C01,C02,...C22, and CA,CB,...CI). Each of the 31 data bits must be present
on the falling edges of the clock input pulses applied to OSCR with the setup and hold times being
1
s minimum.
6.
The data at OUT is previous data that was stored in EEPROM before this operation. If the device
has never been programmed, this data is a random factory test code. The newly programmed
data can be read only after it is loaded.
7.
Apply a logic low to OSCR for at least 10
s.
相關PDF資料 |
PDF描述 |
|---|---|
| TMS57014ADWBLE | DUAL, SERIAL INPUT LOADING, 18-BIT DAC, PDSO28 |
| TMX320C6474ZUN | SPECIALTY CONSUMER CIRCUIT, PBGA561 |
| TN5D01A | 5 A SWITCHING REGULATOR, 180 kHz SWITCHING FREQ-MAX, ZFM5 |
| TN5D41A | 5 A SWITCHING REGULATOR, 180 kHz SWITCHING FREQ-MAX, ZFM5 |
| TN5D41 | 5 A SWITCHING REGULATOR, 180 kHz SWITCHING FREQ-MAX, PZFM5 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TMS3705A1DRG4 | 功能描述:RFID應答器 Transponder base station IC RoHS:否 制造商:Murata 存儲容量:512 bit 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| TMS3705ADR | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| TMS3705BDRG4 | 功能描述:RFID應答器 LF Reader IC RoHS:否 制造商:Murata 存儲容量:512 bit 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| TMS3705DDRQ1 | 功能描述:IC RFID BASE STATION LF 16SOIC 制造商:texas instruments 系列:- 包裝:剪切帶（CT） 零件狀態:在售 類型:RFID 閱讀器 頻率:134.2kHz 標準:- 接口:- 電壓 - 電源:5V 工作溫度:-40°C ~ 85°C 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商器件封裝:16-SOIC 標準包裝:1 |
| TMS3705DR | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。