- 您現在的位置：買賣IC網 > PDF目錄98266 > TMS3637P (TEXAS INSTRUMENTS INC) INFRARED, TRANSMITTER/RECEIVER IC, PDIP8 PDF資料下載
參數資料
| 型號： | TMS3637P |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 搖控器 |
| 英文描述： | INFRARED, TRANSMITTER/RECEIVER IC, PDIP8 |
| 封裝： | PLASTIC, DIP-8 |
| 文件頁數： | 10/54頁 |
| 文件大小： | 384K |
| 代理商： | TMS3637P |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁
5–1
5 Principles of Operation
5.1
Power-On Reset
The power-on reset function starts when VCC rises above 2.7 V and is completed after four clock periods.
After power-on reset, the nine configuration bits contained in the EEPROM memory are loaded into the logic
circuits, which determine the device mode and configuration of operation. For correct enabling of the
power-on reset operation, it is necessary for VCC to first fall below 2.3 V and remain in this condition for at
least 0.5 ms.
5.2
EEPROM Memory (31 Bits)
The EEPROM memory contains a total of 31 bits. The first 22 of the 31 bits contain the security code. These
22 bits are named C01, C02,...C22, and are user definable. The last 9 bits of the total 31 bits are
configuration bits named CA,CB,...CI, and are also user definable to select the mode of operation for the
device.
5.2.1
Program Read Mode
The procedure described in the following steps is used to read the current contents of the EEPROM memory.
This can verify that the correct 22 security codes and 9 configuration bits are stored in memory (see
Figure 5–1):
1.
Set VCC to 5 V.
2.
Apply VCC + 0.5 V to OSCC. Wait at least 50 ms to allow the device to assume the read mode
(tsu2 > 50 ms). This voltage on OSCC forces the device into the read mode, and the terminals
are in the following configuration:
OSCR: program/read external clock input
OUT: serial output of 31 data bits currently stored in EEPROM
3.
Apply four reset pulses to OSCR (tw4 = tw5 = 10 s). This only needs to be done once during each
read operation.
4.
Apply 31 clock pulses to clock input OSCR (tw4 = tw5 = 10 s min). This clocks out the 31 data
bits (C01,C02,...C22, and CA,CB,...CI) that are stored in memory. Output data changes state
only on falling edge of clock pulses, except on data bit C01. If used, data bit C01 goes high on
the rising edge of the clock pulse.
NOTE:
Each succeeding group of 31 clock pulses, when applied, clocks out the data again
without any reset pulses required.
相關PDF資料 |
PDF描述 |
|---|---|
| TMS3637DR | INFRARED, TRANSMITTER/RECEIVER IC, PDSO8 |
| TMS3637D | INFRARED, TRANSMITTER/RECEIVER IC, PDSO8 |
| TMS57014ADWBLE | DUAL, SERIAL INPUT LOADING, 18-BIT DAC, PDSO28 |
| TMX320C6474ZUN | SPECIALTY CONSUMER CIRCUIT, PBGA561 |
| TN5D01A | 5 A SWITCHING REGULATOR, 180 kHz SWITCHING FREQ-MAX, ZFM5 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TMS3705A1DRG4 | 功能描述:RFID應答器 Transponder base station IC RoHS:否 制造商:Murata 存儲容量:512 bit 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| TMS3705ADR | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| TMS3705BDRG4 | 功能描述:RFID應答器 LF Reader IC RoHS:否 制造商:Murata 存儲容量:512 bit 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| TMS3705DDRQ1 | 功能描述:IC RFID BASE STATION LF 16SOIC 制造商:texas instruments 系列:- 包裝:剪切帶（CT） 零件狀態:在售 類型:RFID 閱讀器 頻率:134.2kHz 標準:- 接口:- 電壓 - 電源:5V 工作溫度:-40°C ~ 85°C 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商器件封裝:16-SOIC 標準包裝:1 |
| TMS3705DR | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。