- 您現在的位置：買賣IC網 > PDF目錄98267 > TNY266GNTL (POWER INTEGRATIONS INC) 0.56 A SWITCHING REGULATOR, 140 kHz SWITCHING FREQ-MAX, PDSO7 PDF資料下載
參數資料
| 型號： | TNY266GNTL |
| 廠商： | POWER INTEGRATIONS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.56 A SWITCHING REGULATOR, 140 kHz SWITCHING FREQ-MAX, PDSO7 |
| 封裝： | LEAD FREE, PLASTIC, SMD-8/7 |
| 文件頁數： | 3/24頁 |
| 文件大小： | 1212K |
| 代理商： | TNY266GNTL |
11
TNY263-268
G
4/05
2. A secondary output of 5 V with a Schottky rectier diode.
3. Assumed efficiency of 77% (TNY267 & TNY268),
75% (TNY265&TNY266)and73%(TNY263&TNY264).
4. The parts are board mounted with SOURCE pins soldered
to sufcient area of copper to keep the die temperature at
or below 100 °C.
In addition to the thermal environment (sealed enclosure,
ventilated, open frame, etc.), the maximum power capability
of TinySwitch-II in a given application depends on transformer
core size and design (continuous or discontinuous), efciency,
minimum specied input voltage, input storage capacitance,
output voltage, output diode forward drop, etc., and can be
different from the values shown in Table 1.
Audible Noise
The TinySwitch-II practically eliminates any transformer audio
noiseusingsimpleordinaryvarnishedtransformerconstruction.
No gluing of the cores is needed. The audio noise reduction
is accomplished by the TinySwitch-II controller reducing the
current limit in discrete steps as the load is reduced. This
minimizes the ux density in the transformer when switching
at audio frequencies.
Worst Case EMI & Efciency Measurement
Since identical TinySwitch-II supplies may operate at several
different frequencies under the same load and line conditions,
care must be taken to ensure that measurements are made under
worstcaseconditions.WhenmeasuringefciencyorEMIverify
that the TinySwitch-II is operating at maximum frequency and
that measurements are made at both low and high line input
voltages to ensure the worst case result is obtained.
Layout
Single Point Grounding
Use a single point ground connection at the SOURCE pin for
the BYPASS pin capacitor and the Input Filter Capacitor
(see Figure 17).
Primary Loop Area
The area of the primary loop that connects the input lter
capacitor, transformer primary and TinySwitch-II together
should be kept as small as possible.
Primary Clamp Circuit
A clamp is used to limit peak voltage on the DRAIN pin at
turn-off. This can be achieved by using an RCD clamp (as
shown in Figure 14). A Zener and diode clamp (200 V) across
the primary or a single 550 V Zener clamp from DRAIN to
SOURCE can also be used. In all cases care should be taken
to minimize the circuit path from the clamp components to the
transformer and TinySwitch-II.
Thermal Considerations
Copper underneath the TinySwitch-II acts not only as a single
point ground, but also as a heatsink. The hatched areas shown
in Figure 17 should be maximized for good heat sinking of
TinySwitch-II
and the same applies to the output diode.
EN/UV pin
If a line under-voltage detect resistor is used then the resistor
should be mounted as close as possible to the EN/UV pin to
minimize noise pick up.
Thevoltageratingofaresistorshouldbeconsideredfortheunder-
voltagedetect(Figure15:R2,R3)resistors. For1/4 Wresistors,
the voltage rating is typically 200 V continuous, whereas for
1/2 W resistors the rating is typically 400 V continuous.
Y-Capacitor
The placement of the Y-capacitor should be directly from the
primary bulk capacitor positive rail to the common/return
terminal on the secondary side. Such placement will maximize
the EMI benet of the Y-capacitor and avoid problems in
common-mode surge testing.
Optocoupler
It is important to maintain the minimum circuit path from
the optocoupler transistor to the TinySwitch-II EN/UV and
SOURCE pins to minimize noise coupling.
The EN/UV pin connection to the optocoupler should be kept
to an absolute minimum (less than 12.7 mm or 0.5 in.), and
this connection should be kept away from the DRAIN pin
(minimum of 5.1 mm or 0.2 in.).
Output Diode
Forbestperformance,theareaoftheloopconnectingthesecondary
winding, the output diode and the output lter capacitor, should
be minimized. See Figure 17 for optimized layout. In addition,
sufcient copper area should be provided at the anode and
cathode terminals of the diode for adequate heatsinking.
Input and Output Filter Capacitors
There are constrictions in the traces connected to the input and
output lter capacitors. These constrictions are present for two
reasons. The rst is to force all the high frequency currents
to ow through the capacitor (if the trace were wide then it
could ow around the capacitor). Secondly, the constrictions
minimizetheheattransferredfromtheTinySwitch-IItotheinput
lter capacitor and from the secondary diode to the output lter
capacitor. The common/return (the negative output terminal
in Figure 17) terminal of the output lter capacitor should be
connected with a short, low impedance path to the secondary
winding. In addition, the common/return output connection
should be taken directly from the secondary winding pin and
not from the Y-capacitor connection point.
相關PDF資料 |
PDF描述 |
|---|---|
| TPA005D02DCA | 2 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO48 |
| TPA005D02DCAR | 2 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO48 |
| TPA005D14DCAR | 2 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO48 |
| TPA005D14DCA | 2 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO48 |
| TPA0102PWP | 1.5 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TNY266GN-TL | 功能描述:交流/直流開關轉換器 9.5W 85-265 VAC 15W/230 VAC RoHS:否 制造商:STMicroelectronics 輸出電壓:800 V 輸入/電源電壓（最大值）:23.5 V 輸入/電源電壓（最小值）:11.5 V 開關頻率:115 kHz 電源電流:1.6 mA 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:SSO-10 封裝:Reel |
| TNY266GTL | 制造商:POWERINT 制造商全稱:Power Integrations, Inc. 功能描述:Enhanced, Energy Efficient, Low Power Off-line Switcher |
| TNY266G-TL | 功能描述:IC OFFLINE SWIT OTP OCP HV 8SMD RoHS:否 類別:集成電路 (IC) >> PMIC - AC-DC 轉換器，離線開關 系列:TinySwitch®-II 標準包裝:1 系列:FPS™ 輸出隔離:隔離 頻率范圍:61kHz ~ 73kHz 輸入電壓:8 V ~ 26 V 輸出電壓:650V 功率（瓦特）:12W 工作溫度:-40°C ~ 115°C 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-MDIP 包裝:Digi-Reel® 其它名稱:FSL206MRBNFSDKR |
| TNY266P | 功能描述:IC OFFLINE SWIT OTP OCP HV 8DIP RoHS:否 類別:集成電路 (IC) >> PMIC - AC-DC 轉換器，離線開關 系列:TinySwitch®-II 標準包裝:1 系列:FPS™ 輸出隔離:隔離 頻率范圍:61kHz ~ 73kHz 輸入電壓:8 V ~ 26 V 輸出電壓:650V 功率（瓦特）:12W 工作溫度:-40°C ~ 115°C 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-MDIP 包裝:Digi-Reel® 其它名稱:FSL206MRBNFSDKR |
| TNY266P_1 | 制造商:POWERINT 制造商全稱:Power Integrations, Inc. 功能描述:4.9W DVD power supply |
發布緊急采購，3分鐘左右您將得到回復。