欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號： TOP250R
英文描述： Up to 290 W Extended power. design flexible.
中文描述： 高達290瓦的擴展能力。設計靈活。
文件頁數： 8/52頁
文件大小： 468K
代理商： TOP250R
TOP242-250
8
K
9/03
General Information & Table of Contents
rating of the MOSFET (700 V), due to the absence of the
reflected voltage and leakage spikes on the drain. A small
amount of hysteresis is provided on the OV threshold to
prevent noise triggering. The OV feature can be disabled
independent of the UV feature as shown in Figures 18 and 32.
Data Sheets 2
reduces power supply output sensitivity to line transients. This
feed forward operation is illustrated in Figure 7 by the
different values of I
(Y, R or F package) or I
(P or G Package).
Note that for the same CONTROL pin current, higher line
voltage results in smaller operating duty cycle. As an added
feature, the maximum duty cycle DC
is also reduced from
78% (typical) at a voltage slightly higher than the UV threshold
to 30% (typical) at the OV threshold (see Figure 11).
Limiting DC
MAX
at higher line voltages helps prevent
Quality and Reliability 6
Package Information 7
DPA-SwitchDC-DC Seminar 8
LinkSwitch & TinySwitch-IIAC-DC Seminar 9
TOPSwitch-GXAC-DC Seminar 10
Sales Representatives and Distributors 11
Figure 10. Synchronization Timing Diagram.
PI-2637-060600
Oscillator
(SAW)
DMAX
Enable from
X, L or M Pin (STOP)
Time
CURRENT LIMIT (X) pin (Y, R or F package) or MULTI-
FUNCTION (M) pin (P or G package) and the rectified DC
high voltage bus, the current limit is reduced with increasing
line voltage, allowing a true power limiting operation against
line variation to be implemented. When using an RCD clamp,
this power limiting technique reduces maximum clamp
voltage at high line. This allows for higher reflected voltage
designs as well as reducing clamp dissipation.
The leading edge blanking circuit inhibits the current limit
comparator for a short time after the output MOSFET is turned
on. The leading edge blanking time has been set so that, if a
power supply is designed properly, current spikes caused by
primary-side capacitances and secondary-side rectifier reverse
recovery time should not cause premature termination of the
switching pulse.
The current limit is lower for a short period after the leading
edge blanking time as shown in Figure 52. This is due to
dynamic characteristics of the MOSFET. To avoid triggering
the current limit in normal operation, the drain current
waveform should stay within the envelope shown.
Line Under-Voltage Detection (UV)
At power up, UV keeps
TOPSwitch-GX
off until the input line
voltage reaches the under voltage threshold. At power down,
UV prevents auto-restart attempts after the output goes out of
regulation. This eliminates power down glitches caused by
the slow discharge of large input storage capacitor present in
applications such as standby supplies. A single resistor
connected from the LINE-SENSE pin (Y, R or F package) or
MULTI-FUNCTION pin (P or G package) to the rectified DC
high voltage bus sets UV threshold during power up. Once the
power supply is successfully turned on, the UV threshold is
lowered to 40% of the initial UV threshold to allow extended
input voltage operating range (UV low threshold). If the UV
low threshold is reached during operation without the power
supply losing regulation the device will turn off and stay off
until UV (high threshold) has been reached again. If the power
supply loses regulation before reaching the UV low threshold,
the device will enter auto-restart. At the end of each auto-
restart cycle (S7), the UV comparator is enabled. If the UV high
threshold is not exceeded the MOSFET will be disabled during
the next cycle (see Figure 8). The UV feature can be disabled
independent of OV feature as shown in Figures 19 and 23.
Line Overvoltage Shutdown (OV)
The same resistor used for UV also sets an overvoltage threshold
which, once exceeded, will force
TOPSwitch-GX
output into
off-state. The ratio of OV and UV thresholds is preset at 4.5 as
can be seen in Figure 11. When the MOSFET is off, the rectified
DC high voltage surge capability is increased to the voltage
Line Feed Forward with DC
Reduction
The same resistor used for UV and OV also
implements line
voltage feed forward which minimizes output line ripple and
相關PDF資料
PDF描述
TOP245P Up to 290 W Extended power. design flexible.
TOPD345-RX5 Optoelectronic
TOPD346-RXMS Optoelectronic
TOPD347-RXB Telecommunication IC
TOPD347-RXBS Optoelectronic
相關代理商/技術參數
參數描述
TOP250R- 制造商:POWERINT 制造商全稱:Power Integrations, Inc. 功能描述:TOPSwitch-GX Family Extended Power, Design Flexible, EcoSmart, Integrated Off-line Switcher
TOP250RN- 制造商:POWERINT 制造商全稱:Power Integrations, Inc. 功能描述:TOPSwitch-GX Family Extended Power, Design Flexible, EcoSmart, Integrated Off-line Switcher
TOP250RN-TL 制造商:POWERINT 制造商全稱:Power Integrations, Inc. 功能描述:TOPSwitch-GX Family Extended Power, Design Flexible, EcoSmart, Integrated Off-line Switcher
TOP250R-TL 功能描述:交流/直流開關轉換器 55 W 85-265 VAC 82 W 230 VAC RoHS:否 制造商:STMicroelectronics 輸出電壓:800 V 輸入/電源電壓（最大值）:23.5 V 輸入/電源電壓（最小值）:11.5 V 開關頻率:115 kHz 電源電流:1.6 mA 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:SSO-10 封裝:Reel
TOP250Y 功能描述:交流/直流開關轉換器 210 W 85-265 VAC 290 W 230 VACX RoHS:否 制造商:STMicroelectronics 輸出電壓:800 V 輸入/電源電壓（最大值）:23.5 V 輸入/電源電壓（最小值）:11.5 V 開關頻率:115 kHz 電源電流:1.6 mA 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:SSO-10 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*
主站蜘蛛池模板： 葫芦岛市| 诏安县| 和硕县| 大余县| 宁陵县| 商河县| 顺平县| 泰兴市| 洛扎县| 河南省| 文安县| 米易县| 呼伦贝尔市| 宕昌县| 邵武市| 江口县| 承德县| 海阳市| 织金县| 贞丰县| 通辽市| 连云港市| 深圳市| 鄯善县| 林芝县| 禄劝| 军事| 新河县| 伊吾县| 成都市| 吉首市| 依安县| 屯留县| 上思县| 塔河县| 新安县| 普兰店市| 白水县| 建阳市| 泾源县| 延寿县|