- 您現在的位置：買賣IC網 > PDF目錄98269 > TPA1517DWPG4 (TEXAS INSTRUMENTS INC) 6 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO20 PDF資料下載
參數資料
| 型號： | TPA1517DWPG4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 6 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO20 |
| 封裝： | GREEN, PLASTIC, SOP-20 |
| 文件頁數： | 6/22頁 |
| 文件大小： | 540K |
| 代理商： | TPA1517DWPG4 |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁
www.ti.com
COMPONENT SELECTION
LEAKAGE CURRENTS
EQUIVALENT SERIES RESISTANCE
% Power in C
O +
ESR
R
L
TEMPERATURE RANGE
TURN-ON POP CONSIDERATION
T
C +
1
2pRC
7500 C
B u 5RLCO u 300000 CI
1
2p60000 C
I
t 10 Hz
SLOS162D – MARCH 1997 – REVISED FEBRUARY 2007
APPLICATION INFORMATION (continued)
Some of the general concerns for selection of capacitors are:
Leakage currents on aluminum electrolytic capacitors
ESR (equivalent series resistance)
Temperature ratings
Leakage currents on most ceramic, polystyrene, and paper capacitors are negligible for this application.
Leakage currents for aluminum electrolytic and tantalum tend to be higher. This is especially important on the
input terminals and the SVRR capacitor. These nodes encounter from 3 V to 7 V, and need to have leakage
currents less than 1
A to keep from affecting the output power and noise performance.
ESR is mainly important on the output coupling capacitor, where even 1
of ESR in C
O with an 8- speaker can
reduce the output drive power by 12.5%. ESR should be considered across the frequency range of interest,
(i.e., 20 Hz to 20 kHz). The following equation calculates the amount of power lost in the coupling capacitor:
The power supply decoupling requires a low ESR as well to take advantage of the full output drive current.
The temperature range of the capacitors are important. Many of the high-density capacitors perform differently at
different temperatures. When consistent high performance is required from the system overtemperature in terms
of low THD, maximum output power, and turn-on/off popping, then interactions of the coupling capacitors and
the SVRR capacitors need to be considered, as well as the change in ESR on the output capacitor with
temperature.
To select the proper input coupling capacitor, the designer should select a capacitor large enough to allow the
lowest desired frequency pass and small enough that the time constant is shorter than the output RC time
constant to minimize turn-on popping. The input time constant for the TPA1517 is determined by the input 60-k
resistance of the amplifier, and the input coupling capacitor according to the following generic equation:
For example, 8-
speakers and 220-F output coupling capacitors would yield a 90-Hz cut-off point for the
output RC network. The input network should be the same speed or faster ( > 90 Hz TC). A good choice would
be 180 Hz. As the input resistance is 60 k
, a 14-nF input coupling capacitor would do.
The bypass-capacitor time constant should be much larger (
×5) than either the input coupling capacitor time
constant or the output coupling capacitor time constants. In the previous example with the 220-
F output
coupling capacitor, the designer should want the bypass capacitor, TC, to be in the order of 18 Hz or lower. To
get an 18-Hz time constant, CB is required to be 1 F or larger because the resistance this capacitor sees is
7.5 k
.
In summary, follow one of the three simple relations presented below, depending on the tradeoffs between low
frequency response and turn-on pop.
1. If depop performance is the top priority, then follow:
2. If low frequency ac response is more important but depop is still a consideration then follow:
14
相關PDF資料 |
PDF描述 |
|---|---|
| TPA1517Y | 6 W, 2 CHANNEL, AUDIO AMPLIFIER, UUC8 |
| TPA152DR | 0.075 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
| TPA152D | 0.075 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
| TPA152DRG4 | 0.075 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
| TPA2000D1GQC | 2 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA1517DWPR | 功能描述:音頻放大器 Stereo Med Power Class-AB RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA1517DWPRG4 | 功能描述:音頻放大器 Stereo Med Power Class-AB RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA1517NE | 功能描述:音頻放大器 6W Stereo Audio RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA1517NEE4 | 功能描述:音頻放大器 Stereo Med Power Class-AB RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA1517NEEVM | 功能描述:音頻 IC 開發工具 TPA1517NE Eval Mod RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
發布緊急采購，3分鐘左右您將得到回復。