- 您現在的位置：買賣IC網 > PDF目錄98269 > TPA1517NEE4 (TEXAS INSTRUMENTS INC) 6 W, 2 CHANNEL, AUDIO AMPLIFIER, PDIP20 PDF資料下載
參數資料
| 型號： | TPA1517NEE4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 6 W, 2 CHANNEL, AUDIO AMPLIFIER, PDIP20 |
| 封裝： | ROHS COMPLIANT, PLASTIC, DIP-20 |
| 文件頁數： | 4/22頁 |
| 文件大小： | 540K |
| 代理商： | TPA1517NEE4 |
www.ti.com
V
MID +
V
CC
2
MUTE/STANDBY OPERATION
NORMAL
MUTE
STANDBY
Undetermined State
22
9.3
8.2
3.5
2
0
-Input
V
oltage
on
M/SB
-
V
I(M/SB)
SLOS162D – MARCH 1997 – REVISED FEBRUARY 2007
APPLICATION INFORMATION (continued)
The audio outputs are biased to a midrail voltage which is shown by the following equation:
The audio inputs are always biased to 2.1 V when in mute or normal mode. Any dc offset between the input
signal source and the input terminal is amplified and can seriously degrade the performance of the amplifier. For
this reason, it is recommended that the inputs always be connected through a series capacitor (ac coupled). The
power outputs, also having a dc bias, must be connected to the speakers via series capacitors.
The TPA1517 has three modes of operation; normal, mute, and standby. They are controlled by the voltage on
the M/SB terminal as described in Figure 24. In normal mode, the TPA1517 amplifies the signal applied to the
two input terminals providing low impedance drive to speakers connected to the output terminals. In mute mode,
the amplifier retains all bias voltages and quiescent supply current levels but does not pass the input signal to
the output. In standby mode, the internal bias generators and power-drive stages are turned off, thereby
reducing the supply current levels.
Figure 24. Standby, Mute, and Normal (On) Operating Conditions
The designer must take care to place the control voltages within the defined ranges for each desired mode,
whenever an external circuit is used to control the input voltage at the M/SB terminal. The undefined area can
cause unpredictable performance and should be avoided. As the control voltage moves through the undefined
areas, pop or click sounds may be heard in the speaker. Moving from mute to normal causes a very small click
sound. Whereas moving from standby to mute can cause a much larger pop sound. Figure 25 shows external
circuitry designed to help reduce transition pops when moving from standby mode to normal mode.
12
相關PDF資料 |
PDF描述 |
|---|---|
| TPA1517DWPG4 | 6 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO20 |
| TPA1517Y | 6 W, 2 CHANNEL, AUDIO AMPLIFIER, UUC8 |
| TPA152DR | 0.075 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
| TPA152D | 0.075 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
| TPA152DRG4 | 0.075 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA1517NEEVM | 功能描述:音頻 IC 開發工具 TPA1517NE Eval Mod RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| TPA152 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:75-mW STEREO AUDIO POWER AMPLIFIER |
| TPA152_06 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:75-mW STEREO AUDIO POWER AMPLIFIER |
| TPA152D | 功能描述:音頻放大器 75mW RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA152DG4 | 功能描述:音頻放大器 Hi-Fi Stereo Headphone RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。