- 您現在的位置：買賣IC網 > PDF目錄98269 > TPA2000D1PWRG4 (TEXAS INSTRUMENTS INC) 2 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO16 PDF資料下載
參數資料
| 型號： | TPA2000D1PWRG4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 2 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO16 |
| 封裝： | GREEN, PLASTIC, TSSOP-16 |
| 文件頁數： | 2/23頁 |
| 文件大小： | 500K |
| 代理商： | TPA2000D1PWRG4 |
www.ti.com
0 V
–5 V
+5 V
Current
OUTP
OUTN
Differential
Voltage
Across
Load
0 V
–5 V
+5 V
Current
OUTP
OUTN
Differential
Voltage
Across
Load
Output = 0 V
Output > 0 V
EFFICIENCY: WHY YOU MUST USE A FILTER WITH THE TRADITIONAL CLASS-D MODULATION
TPA2000D1
SLOS328F – JUNE 2000 – REVISED MARCH 2004
APPLICATION INFORMATION (continued)
Figure 10. The TPA2000D1 Output Voltage and Current Waveforms Into an Inductive Load
SCHEME
The main reason that the traditional class-D amplifier needs an output filter is that the switching waveform results
in maximum current flow. This causes more loss in the load, which causes lower efficiency. The ripple current is
large for the traditional modulation scheme because the ripple current is proportional to voltage multiplied by the
time at that voltage. The differential voltage swing is 2
× V
DD and the time at each voltage is half the period for
the traditional modulation scheme. An ideal LC filter is needed to store the ripple current from each half cycle for
the next half cycle, while any resistance causes power dissipation. The speaker is both resistive and reactive,
whereas an LC filter is almost purely reactive.
The TPA2000D1 modulation scheme has little loss in the load without a filter because the pulses are short and
the change in voltage is VDD instead of 2 × VDD. As the output power increases, the pulses widen making the
ripple current larger. Ripple current could be filtered with an LC filter for increased efficiency, but for most
applications the filter is not needed.
An LC filter with a cutoff frequency less than the class-D switching frequency allows the switching current to flow
through the filter instead of the load. The filter has less resistance than the speaker that results in less power
dissipated, which increases efficiency.
10
相關PDF資料 |
PDF描述 |
|---|---|
| TPA2000D1PWG4 | 2 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO16 |
| TPA2000D1TPWRG4Q1 | 2 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO16 |
| TPA2000D1TPWRQ1 | 2 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO16 |
| TPA2000D2PWPR | 2 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO24 |
| TPA2000D2PWP | 2 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA2000D1-Q1 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:2-W FILTERLESS MONO CLASS-D AUDIO POWER AMPLIFIER |
| TPA2000D1TPWRG4Q1 | 功能描述:音頻放大器 Mono Filter-Free Class-D Audio Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA2000D1TPWRQ1 | 功能描述:音頻放大器 Auto Cat Mono Filter Free Class D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA2000D2 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:2-W FILTERLESS STEREO CLASS-D AUDIO POWER AMPLIFIER |
| TPA2000D2_07 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:2-W FILTERLESS STEREO CLASS-D AUDIO POWER AMPLIFIER |
發布緊急采購，3分鐘左右您將得到回復。