- 您現在的位置：買賣IC網 > PDF目錄98269 > TPA2000D4DAP (TEXAS INSTRUMENTS INC) 2 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO32 PDF資料下載
參數資料
| 型號： | TPA2000D4DAP |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 2 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO32 |
| 封裝： | PLASTIC, HTSSOP-32 |
| 文件頁數： | 11/27頁 |
| 文件大小： | 579K |
| 代理商： | TPA2000D4DAP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
TPA2000D4
STEREO 2W CLASSD AUDIO POWER AMPLIFIER
WITH STEREO HP AMPLIFIER
SLOS337B DECEMBER 2000 REVISED NOVEMBER 2005
19
WWW.TI.COM
APPLICATION INFORMATION
input capacitor, CI
In the typical application an input capacitor, CI, is required to allow the amplifier to bias the input signal to the
proper dc level for optimum operation. In this case, CI and the input impedance of the amplifier, ZI, form a
high-pass filter with the corner frequency determined in equation 5.
f
c(highpass) +
1
2
pZ
I
C
I
3 dB
fc
(5)
The value of CI is important as it directly affects the bass (low frequency) performance of the circuit. Consider
the example where ZI is 20 k and the specification calls for a flat bass response down to 80 Hz. Equation 5
is reconfigured as equation 6.
C
I +
1
2
pZ
I fc
(6)
In this example, CI is 0.1 F, so one would likely choose a value in the range of 0.1 F to 1 F. If the gain is known
and is constant, use ZI from Table 1 to calculate CI. A further consideration for this capacitor is the leakage path
from the input source through the input network (CI) and the feedback network to the load. This leakage current
creates a dc offset voltage at the input to the amplifier that reduces useful headroom, especially in high gain
applications. For this reason a low-leakage tantalum or ceramic capacitor is the best choice. When polarized
capacitors are used, the positive side of the capacitor should face the amplifier input in most applications as
the dc level there is held at VDD/2, which is likely higher than the source dc level. Note that it is important to
confirm the capacitor polarity in the application.
CI must be 10 times smaller than the bypass capacitor to reduce clicking and popping noise from power on/off
and entering and leaving shutdown. After sizing CI for a given cutoff frequency, size the bypass capacitor to 10
times that of the input capacitor.
(7)
CI ≤ CBYP / 10
switching frequency
The switching frequency is determined using the values of the components connected to ROSC (pin 18) and
COSC (pin 19) and is calculated with the following equation:
fs +
6.6
R
OSC
C
OSC
(8)
The switching frequency was chosen to be centered on 250 kHz. This frequency represents the optimization
of audio fidelity due to oversampling and the maximization of efficiency by minimizing the switching losses of
the amplifier. The recommended values are a resistance of 120 k
and a capacitance of 220 pF. Using these
component values, the amplifier operates properly by using 5% tolerance resistors and 10% tolerance
capacitors. The tolerance of the components can be changed, as long as the switching frequency remains
between 200 kHz and 300 kHz. Within this range, the internal circuitry of the device provides stable operation.
相關PDF資料 |
PDF描述 |
|---|---|
| TPA2000D4DAPG4 | 2 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO32 |
| TPA2000D4GQC | 2 W, 2 CHANNEL, AUDIO AMPLIFIER, PBGA32 |
| TPA2001D1GQCR | 1 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA48 |
| TPA2001D1GQC | 1 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA48 |
| TPA2001D1PWRG4 | 1 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA2000D4DAPG4 | 功能描述:音頻放大器 Stereo Filter-Free Class-D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA2000D4DAPR | 功能描述:音頻放大器 Stereo Filter-Free Class-D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA2000D4DAPRG4 | 功能描述:音頻放大器 Stereo Filter-Free Class-D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA2000D4EVM | 功能描述:音頻 IC 開發工具 TPA2000D4 Eval Mod RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| TPA2000D4GQC | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:AUDIO AMPLIFIER|DUAL|CMOS|BGA|48PIN|PLASTIC |
發布緊急采購，3分鐘左右您將得到回復。