- 您現在的位置：買賣IC網 > PDF目錄98271 > TPA2016D2RTJR (TEXAS INSTRUMENTS INC) 2.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC20 PDF資料下載
參數資料
| 型號： | TPA2016D2RTJR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 2.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC20 |
| 封裝： | 4 X 4 MM, GREEN, PLASTIC, QFN-20 |
| 文件頁數： | 9/38頁 |
| 文件大小： | 1216K |
| 代理商： | TPA2016D2RTJR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁
V
-dBV
O
U
T
V
-dBV
IN
MaxGain
= 22dB
MaxGain
= 30dB
1:1
www.ti.com........................................................................................................................................................ SLOS524D – JUNE 2008 – REVISED AUGUST 2009
Figure 33. Output Signal vs. Input Signal State Diagram Showing Different Maximum Gains
A particular application requiring maximum gain of 22dB, for example. Thus, set the maximum gain at 22dB. The
amplifier gain will never have a gain higher than 22dB; however, this will reduce the limiter range.
Attack, Release, and Hold time:
The attack time is the minimum time between gain decreases.
The release time is the minimum time between gain increases.
The hold time is the minimum time between a gain decrease (attack) and a gain increase (release). The hold
time can be deactivated. Hold time is only valid if greater than release time.
Successive gain decreases are never faster than the attack time. Successive gain increases are never faster
than the release time.
All time variables (attack, release and hold) start counting after each gain change performed by the AGC. The
AGC is allowed to decrease the gain (attack) only after the attack time finishes. The AGC is allowed to increase
the gain (release) only after the release time finishes counting. However, if the preceding gain change was an
attack (gain increase) and the hold time is enabled and longer than the release time, then the gain is only
increased after the hold time.
The hold time is only enabled after a gain decrease (attack). The hold time replaces the release time after a gain
decrease (attack). If the gain needs to be increased further, then the release time is used. The release time is
used instead of the hold time if the hold time is disabled.
The attack time should be at least 100 times shorter than the release and hold time. The hold time should be the
same or greater than the release time. It is important to select reasonable values for those variables in order to
prevent the gain from changing too often or too slow.
Figure 34 illustrates the relationship between the three time variables.
Copyright 2008–2009, Texas Instruments Incorporated
17
Product Folder Link(s): TPA2016D2
相關PDF資料 |
PDF描述 |
|---|---|
| TPA2016D2RTJT | 2.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC20 |
| TPA2017D2RTJR | 2.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC20 |
| TPA2017D2RTJT | 2.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC20 |
| TPA2026D2YZHR | AUDIO AMPLIFIER, PBGA16 |
| TPA2026D2YZHT | AUDIO AMPLIFIER, PBGA16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA2016D2RTJT | 功能描述:音頻放大器 1.7-W/Ch St Class-D Audio Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA2016D2V1YZHR | 制造商:Texas Instruments 功能描述: |
| TPA2016D2YZHR | 功能描述:音頻放大器 1.7W/Ch Stereo Class D Aud Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA2016D2YZHT | 功能描述:音頻放大器 1.7W/Ch Stereo Class D Aud Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA2016DYZHT2 | 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。