- 您現在的位置：買賣IC網 > PDF目錄98273 > TPA3120D2PWP (TEXAS INSTRUMENTS INC) 20 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO24 PDF資料下載
參數資料
| 型號： | TPA3120D2PWP |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 20 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO24 |
| 封裝： | GREEN, PLASTIC, HTSSOP-24 |
| 文件頁數： | 7/29頁 |
| 文件大?。?/td> | 952K |
| 代理商： | TPA3120D2PWP |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
www.ti.com
Output Filter and Frequency Response
LOUT /ROUT
L
filter
C
filter
LOUT
L
filter
C
filter
L
filter
C
filter
ROUT
Power-Supply Decoupling, CS
BSN and BSP Capacitors
SLOS507E – MARCH 2007 – REVISED SEPTEMBER 2007
For the best frequency response, a flat-passband output filter (second-order Butterworth) may be used. The
output filter components consist of the series inductor and capacitor to ground at the LOUT and ROUT pins.
There are several possible configurations, depending on the speaker impedance and whether the output
configuration is single-ended (SE) or bridge-tied load (BTL). Table 4 lists the recommended values for the filter
components. It is important to use a high-quality capacitor in this application. A rating of at least X7R is required.
Table 4. Recommended Filter Output Components
Output Configuration
Speaker Impedance (
)
Filter Inductor (
μH)
Filter Capacitor (nF)
4
22
680
Single Ended (SE)
8
47
390
4
10
1500
Bridge Tied Load (BTL)
8
22
680
Figure 25. BTL Filter Configuration
Figure 26. SE Filter Configuration
The TPA3120D2 is a high-performance CMOS audio amplifier that requires adequate power-supply decoupling
to ensure that the output total harmonic distortion (THD) is as low as possible. Power-supply decoupling also
prevents oscillations for long lead lengths between the amplifier and the speaker. The optimum decoupling is
achieved by using two capacitors of different types that target different types of noise on the power-supply leads.
For higher-frequency transients, spikes, or digital hash on the line, a good low equivalent-series-resistance (ESR)
ceramic capacitor, typically 0.1
μF to 1 μF, placed as close as possible to the device VCC lead works best. For
filtering lower frequency noise signals, a larger aluminum electrolytic capacitor of 470
μF or greater placed near
the audio power amplifier is recommended. The 470-
μF capacitor also serves as local storage capacitor for
supplying current during large signal transients on the amplifier outputs. The PVCC terminals provide the power
to the output transistors, so a 470-
μF or larger capacitor should be placed on each PVCC terminal. A 10-μF
capacitor on the AVCC terminal is adequate. These capacitors must be properly derated for voltage and
ripple-current rating to ensure reliability.
The half H-bridge output stages use only NMOS transistors. Therefore, they require bootstrap capacitors for the
high side of each output to turn on correctly. A 220-nF ceramic capacitor, rated for at least 25 V, must be
connected from each output to its corresponding bootstrap input. Specifically, one 220-nF capacitor must be
connected from LOUT to BSL, and one 220-nF capacitor must be connected from ROUT to BSR.
The bootstrap capacitors connected between the BSx pins and their corresponding outputs function as a floating
power supply for the high-side N-channel power MOSFET gate-drive circuitry. During each high-side switching
cycle, the bootstrap capacitors hold the gate-to-source voltage high enough to keep the high-side MOSFETs
turned on.
Copyright 2007, Texas Instruments Incorporated
15
Product Folder Link(s): TPA3120D2
相關PDF資料 |
PDF描述 |
|---|---|
| TPA3120D2PWPG4 | 20 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO24 |
| TPA3120D2PWPRG4 | 20 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO24 |
| TPA3121D2PWPG4 | AUDIO AMPLIFIER, PDSO24 |
| TPA3121D2PWPRG4 | AUDIO AMPLIFIER, PDSO24 |
| TPA3121D2PWP | AUDIO AMPLIFIER, PDSO24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA3120D2PWP | 制造商:Texas Instruments 功能描述:Audio Power Amplifiers |
| TPA3120D2PWPG4 | 功能描述:音頻放大器 25W Stereo Class D Aud Pwr Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA3120D2PWPR | 功能描述:音頻放大器 25-W Stereo Class-D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA3120D2PWPRG4 | 功能描述:音頻放大器 25W Stereo Class D Aud Pwr Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA3121D2 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:15-W STEREO CLASS-D AUDIO POWER AMPLIFIER |
發布緊急采購，3分鐘左右您將得到回復。