- 您現在的位置：買賣IC網 > PDF目錄98274 > TPA4860DG4 (TEXAS INSTRUMENTS INC) 1.1 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO16 PDF資料下載
參數資料
| 型號： | TPA4860DG4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 1.1 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO16 |
| 封裝： | GREEN, PLASTIC, MS-012AC, SOIC-16 |
| 文件頁數： | 11/27頁 |
| 文件大小： | 632K |
| 代理商： | TPA4860DG4 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
www.ti.com
SINGLE-ENDED OPERATION
Audio
Input
VDD = 5 V
250-mW
External
Speaker
12
10
15
VO1
VO2
VDD
5
14
13
11
GAIN
IN +
IN
BYPASS
VDD/2
CI
RI
RF
CSE = 0.1 F
RSE = 50
CC
CB
CS
Gain + *
R
F
R
I
(11)
1
C
B
25 k
v
1
C
I RI
1
R
LCC
(12)
OUTPUT COUPLING CAPACITOR, CC
f
c high +
1
2p R
L CC
(13)
TPA4860
SLOS164B – SEPTEMBER 1996 – REVISED JUNE 2004
Figure 38 is a schematic diagram of the recommended SE configuration. In SE mode configurations, the load
should be driven from the primary amplifier output (VO1, terminal 10).
Figure 38. Singled-Ended Mode
Gain is set by the RF and RI resistors and is shown in Equation 11. Because the inverting amplifier is not used to
mirror the voltage swing on the load, the factor of 2 is not included.
The phase margin of the inverting amplifier into an open circuit is not adequate to ensure stability, so a
termination load should be connected to VO2. This consists of a 50- resistor in series with a 0.1-F capacitor to
ground. It is important to avoid oscillation of the inverting output to minimize noise and power dissipation.
The output coupling capacitor required in single-supply SE mode also places additional constraints on the
selection of other components in the amplifier circuit. The rules described earlier still hold with the addition of the
following relationship:
In the typical single-supply SE configuration, an output coupling capacitor (CC) is required to block the dc bias at
the output of the amplifier, thus preventing dc currents in the load. As with the input coupling capacitor, the
output coupling capacitor and impedance of the load form a high-pass filter governed by Equation 13.
The main disadvantage, from a performance standpoint, is that the load impedances are typically small, which
drives the low-frequency corner higher. Large values of CC are required to pass low frequencies into the load.
Consider the example where a CC of 68 F is chosen and loads vary from 8 , 32 , to 47 k. Table 2
summarizes the frequency response characteristics of each configuration.
19
相關PDF資料 |
PDF描述 |
|---|---|
| TPA4860DRG4 | 1.1 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO16 |
| TPA4860Y | 1.1 W, 1 CHANNEL, AUDIO AMPLIFIER, UUC16 |
| TPA4861DR | 1.1 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
| TPA4861D | 1.1 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
| TPA4861DG4 | 1.1 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA4860DR | 功能描述:音頻放大器 1-W Mono Audio Power Amplifier RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA4860DRG4 | 功能描述:音頻放大器 1-W Mono Audio Power Amplifier RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA4860EVM | 功能描述:音頻 IC 開發工具 TPA4860 Eval Mod RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| TPA4861 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:1-W MONO AUDIO POWER AMPLIFIER |
| TPA4861_07 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:1-W MONO AUDIO POWER AMPLIFIER |
發布緊急采購，3分鐘左右您將得到回復。