- 您現在的位置：買賣IC網 > PDF目錄98274 > TPA4861D (TEXAS INSTRUMENTS INC) 1.1 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO8 PDF資料下載
參數資料
| 型號： | TPA4861D |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 1.1 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
| 封裝： | GREEN, PLASTIC, MS-012AA, SOIC-8 |
| 文件頁數： | 5/26頁 |
| 文件大?。?/td> | 623K |
| 代理商： | TPA4861D |
www.ti.com
APPLICATION INFORMATION
BRIDGED-TIED LOAD VERSUS SINGLE-ENDED MODE
Power +
V
(rms)
2
R
L
V
(rms) +
V
O(PP)
2
(1)
RL
2x VO(PP)
VO(PP)
–VO(PP)
VDD
f
(corner) +
1
2 p R
L CC
(2)
TPA4861
SLOS163C – SEPTEMBER 1996 – REVISED JUNE 2004
Figure 34 shows a linear audio power amplifier (APA) in a bridge-tied load (BTL) configuration. A BTL amplifier
actually consists of two linear amplifiers driving both ends of the load. There are several potential benefits to this
differential drive configuration, but initially, let us consider power to the load. The differential drive to the speaker
means that as one side is slewing up the other side is slewing down and vice versa. This, in effect, doubles the
voltage swing on the load as compared to a ground-referenced load. Plugging twice the voltage into the power
equation, where voltage is squared, yields 4 times the output power from the same supply rail and load
impedance (see Equation 1).
Figure 34. Bridge-Tied Load Configuration
In a typical computer sound channel operating at 5 V, bridging raises the power into an 8-
speaker from a
singled-ended (SE) limit of 250 mW to 1 W. In sound power that is a 6-dB improvement, which is loudness that
can be heard. In addition to increased power, frequency response is a concern; consider the single-supply SE
configuration shown in Figure 35. A coupling capacitor is required to block the dc offset voltage from reaching the
load. These capacitors can be quite large (approximately 40 F to 1000 F) so they tend to be expensive,
occupy valuable PCB area, and have the additional drawback of limiting low-frequency performance of the
system. This frequency-limiting effect is due to the high-pass filter network created with the speaker impedance
and the coupling capacitance and is calculated with Equation 2.
For example, a 68-F capacitor with an 8-
speaker would attenuate low frequencies below 293 Hz. The BTL
configuration cancels the dc offsets, which eliminates the need for the blocking capacitors. Low-frequency
performance is then limited only by the input network and speaker response. Cost and PCB space are also
minimized by eliminating the bulky coupling capacitor.
13
相關PDF資料 |
PDF描述 |
|---|---|
| TPA4861DG4 | 1.1 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
| TPA4861DRG4 | 1.1 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
| TPA4861Y | 1.1 W, 1 CHANNEL, AUDIO AMPLIFIER, UUC8 |
| TPA5050RSARG4 | SPECIALTY CONSUMER CIRCUIT, PQCC16 |
| TPA5050RSAR | SPECIALTY CONSUMER CIRCUIT, PQCC16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA4861DG4 | 功能描述:音頻放大器 1W Mono Audio RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA4861DR | 功能描述:音頻放大器 1-W Mono Audio Power Amplifier RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA4861DRG4 | 功能描述:音頻放大器 1-W Mono Audio Power Amplifier RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA-5 | 功能描述:保險絲 TELPOWER ALARM FUSE RoHS:否 制造商:Littelfuse 產品:Surface Mount Fuses 電流額定值:0.5 A 電壓額定值:600 V 保險絲類型:Fast Acting 保險絲大小/組:Nano 尺寸:12.1 mm L x 4.5 mm W 安裝風格: 端接類型:SMD/SMT 系列:485 |
| TPA-5,0-ADV | 制造商:PMK 功能描述:ADVANCED PROBE ACCESSORIES 5, 0MM 制造商:PMK 功能描述:ADVANCED PROBE ACCESSORIES 5, 0MM; Kit Contents:Probe Kit, 18 Piece; Body Diameter:5.0mm; For Use With:5mm PMK Probes; Primary Product 1:220mm Ground Lead with Crocodile Clips; Primary Product 2:Sprung Hook; Primary Product 3:Contact;RoHS Compliant: NA |
發布緊急采購，3分鐘左右您將得到回復。