- 您現在的位置：買賣IC網 > PDF目錄98279 > TPS2340APFPRG4 (TEXAS INSTRUMENTS INC) 2-CHANNEL POWER SUPPLY SUPPORT CKT, PQFP80 PDF資料下載
參數資料
| 型號： | TPS2340APFPRG4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 電源管理 |
| 英文描述： | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PQFP80 |
| 封裝： | GREEN, PLASTIC, HTQFP-80 |
| 文件頁數： | 1/29頁 |
| 文件大小： | 578K |
| 代理商： | TPS2340APFPRG4 |
當前第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
TPS2340A
SLUS528A MARCH 2002 REVISED AUGUST 2002
DUALSLOT PCI HOT PLUG
POWER CONTROLLER
1
www.ti.com
FEATURES
D 12-V, 12-V, 3.3-V, 5-V Main Power Switching
and Auxiliary 3.3-V Power Switching
D 12-V, 12-V And Auxiliary 3.3-V Power FETs
D Hot-Swap Protection and Control of All
Supplies
D Overcurrent Protection for All Supplies
D Isolation of Any Load Fault in One Slot from
Any Other Slot
D Undervoltage Monitoring for the Main 12-V,
3.3-V, 5-V and Auxiliary 3.3-V Supplies
D Power Fault Latching
D Overtemperature Shutdown
D Slot Status Readout with Open-Drain LED
Drivers
D Mechanical Switch Inputs for Attention
Request and Electrical Interlock
D Serial Interface for Power Control, Power
Status, Slot Control and Slot Status
D Compatible With 33-MHz, 66-MHz, and
133-MHz Bus Speeds
D Compliant To PCI And PCI-X Hot Plug
Specifications
D One TPS2340A Supports Two Slots
DESCRIPTION
The TPS2340A contains main supply power
control, auxiliary supply power control, power
FETs for 12 V, 12 V and auxiliary 3.3 V supplies,
and a serial interface for communications with and
control of slots. Each TPS2340A contains supply
control and switching for two slots.
The main power control circuits start with all
supplies off and hold all supplies off until power to
the TPS2340A is valid on all positive supplies.
When power is requested via the serial interface,
the control circuit applies constant current to the
gates of the power FETs, allowing each FET to
ramp load voltage linearly. Each supply can be
programmed for a desired ramp rate by selecting
a gate capacitor for the power FET for that supply.
The power control circuits also monitor load
current and latch off that slot if the load current
exceeds a programmed maximum value. In
addition, once the 12-V, the 5-V, and the 3.3-V
FETs are fully enhanced, the load voltage is
monitored.
If
load
voltage
drops
out
of
specification after these FETs are fully enhanced,
the slot latches off. This provides another level of
protection from load fault.
The auxiliary power control circuit switches,
ramps, and monitors 3.3-V auxiliary power to each
slot. The auxiliary control circuit also controls data
switches that connect slot interrupts (power
management event [PME] outputs) to the main
interrupt PME bus after 3.3-V auxiliary supply is
connected. PME is disconnected when a board is
turned off or faulted.
Each TPS2340A contains power FETs for 12 V at
500 mA, 12 V at 100 mA, and auxiliary 3.3 V at
375 mA for each slot. These power FETs are
short-circuit protected, slew rate controlled, and
over-temperature protected.
The serial interface communicates with a slot
controller using a synchronous serial protocol.
The interface communicates with the slot, status
LEDs, and mechanical switches with individual,
dedicated lines. The interface operates from 3.3-V
power but inputs are 5-V tolerant. Status LED
drivers are capable of driving 24-mA LEDs via
integrated open-drain MOSFETs. Mechanical
switch inputs have internal pull-up and hysteresis
buffers. The serial interface controls slot power,
bus connection, and LED outputs, and monitors
board capability, power fault, and switch input
status.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.
Copyright
2002, Texas Instruments Incorporated
相關PDF資料 |
PDF描述 |
|---|---|
| TPS2341PHPR | 4-CHANNEL POWER SUPPLY SUPPORT CKT, PQFP48 |
| TPS2343DDPG3 | 6-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO80 |
| TPS2343DDPR | 6-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO80 |
| TPS2345PWNRND | 4-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO24 |
| TPS2346PWG4 | 4-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS2341PHP | 功能描述:IC DUAL SLT PCI PWR CTLR 48HTQFP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:100 系列:- 類型:熱插拔開關 應用:通用 內部開關:是 電流限制:可調 電源電壓:9 V ~ 13.2 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-TDFN-EP（3x3） 包裝:管件 |
| TPS2341PHPR | 制造商:Texas Instruments 功能描述:PCI HOT PLG PWR CNTRLR 48HTQFP - Tape and Reel |
| TPS2342PFP | 功能描述:熱插拔功率分布 Hot Plug Power Controller RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| TPS2342PFPG4 | 功能描述:熱插拔功率分布 Hot Plug Power Controller RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| TPS2342PFPR | 功能描述:熱插拔功率分布 Hot Plug Power Controller RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。