- 您現在的位置：買賣IC網 > PDF目錄382675 > TPS3103H15DVBR (Texas Instruments, Inc.) MB 11C 11#16 SKT PLUG PDF資料下載
參數資料
| 型號： | TPS3103H15DVBR |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | MB 11C 11#16 SKT PLUG |
| 中文描述： | 超低電源電流/電源電壓監控電路 |
| 文件頁數： | 17/22頁 |
| 文件大?。?/td> | 361K |
| 代理商： | TPS3103H15DVBR |
SLVS363B AUGUST 2001 REVISED SEPTEMBER 2004
www.ti.com
17
APPLICATION INFORMATION
The TPS310x family has a quiescent current in the 1-
μ
A to 2-
μ
A range. When RESET, triggered by the voltage
monitored at V
DD
, is active, the quiescent current increases to about 20
μ
A (see electrical characteristics).
In some applications it is necessary to minimize the quiescent current even during the reset period. This is
especially true when the voltage of a battery is supervised and the RESET is used to shut down the system or
for an early warning. In this case the reset condition will last for a longer period of time. Especially when the
battery is discharged, the current drawn from the battery should almost be zero.
For this kind of applications the TPS3103 or TPS3106 are a good fit. To minimize current consumption it must
be assured to select a version where the threshold voltage is lower than the voltage monitored at V
DD
. The
TPS3106 has two reset outputs. One output (RSTVDD) is triggered from the voltage monitored at V
DD
. The
other output (RSTSENSE) is triggered from the voltage monitored at SENSE. In the application shown in
Figure 13, the TPS3106E09 is used to monitor the input voltage of two NiCd or NiMH cells. The threshold
voltage (V
(th)
= 0.86 V) was chosen as low as possible to ensure that the supply voltage is always higher than
the threshold voltage at V
DD
. The voltage of the battery is monitored using the SENSE input. The voltage divider
was calculated to assert a reset using the RSTSENSE output at 2 x 0.8 V = 1.6 V.
R1
R2
V
TRIP
V
IT(S)
1
Where:
V
TRIP
is the voltage of the battery at which a reset is asserted
V
IT(S)
is the threshold voltage at SENSE = 0.551 V.
R1 was chosen for a resistor current in the 1-
μ
A range.
With V
TRIP
= 1.6 V:
R1
≈
1.9
×
R2
R1 = 820 k, R2 = 430 k
TPS3106E09DBV
MR
SENSE
GND
R1
R2
VDD
RSTVDD
RSTSENSE
R3
2 Cell
NiMH
Reset Output
Figure 13. Battery Monitoring With 3-
μ
A Supply Current for Device and Resistor Divider
相關PDF資料 |
PDF描述 |
|---|---|
| TPS3103H16DVB | MB 11C 11#16 ASKT RECP |
| TPS3103H16DVBR | MB 11C 11#16 SKT PLUG |
| TPS3103H20DVB | MB 32C 32#20 SKT PLUG |
| TPS3103H20DVBR | MB 32C 32#20 SKT PLUG |
| TPS3103K09DVB | 5015 RR 37#16 PIN PLUG |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS3103H16DVB | 制造商:TI 制造商全稱:Texas Instruments 功能描述:ULTRALOW SUPPLY CURRENT/SUPPLY VOLTAGE SUPERVISORY CIRCUITS |
| TPS3103H16DVBR | 制造商:TI 制造商全稱:Texas Instruments 功能描述:ULTRALOW SUPPLY CURRENT/SUPPLY VOLTAGE SUPERVISORY CIRCUITS |
| TPS3103H20 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:UltraLow-Supply Current/Supply-Voltage Supervisory Circuit |
| TPS3103H20DBVR | 功能描述:監控電路 Current/Supply-Volt Supervisory RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| TPS3103H20DBVRG4 | 功能描述:監控電路 Current/Supply-Volt Supervisory RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。