- 您現在的位置：買賣IC網 > PDF目錄98282 > TPS51211DSCT (TEXAS INSTRUMENTS INC) SWITCHING CONTROLLER, 314 kHz SWITCHING FREQ-MAX, PDSO10 PDF資料下載
參數資料
| 型號： | TPS51211DSCT |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING CONTROLLER, 314 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封裝： | PLASTIC, SON-10 |
| 文件頁數： | 7/26頁 |
| 文件大小： | 674K |
| 代理商： | TPS51211DSCT |
TRIP
V
(mV)
R
(k
)
I
( A)
=
W
m
(
)
f
IND ripple
IN
OUT
TRIP
OCP
DS(on)
SW
IN
I
(V
V
)
V
1
I
8
R
2
8
R
2
L
V
-
÷
=
+
=
+
÷
è
TPS51211
www.ti.com
SLUSAA7 – NOVEMBER 2010
POWER-GOOD
The TPS51211 has powergood output that indicates high when switcher output is within the target. The
powergood function is activated after soft-start has finished. If the output voltage becomes within +10%/–5% of
the target value, internal comparators detect power-good state and the power-good signal becomes high after a
1-ms internal delay. If the output voltage goes outside of +15%/–10% of the target value, the powergood signal
becomes low after a 2-ms internal delay. The powergood output is an open-drain output and must be pulled up
externally.
CURRENT SENSE AND OVER CURRENT PROTECTION
TPS51211 has cycle-by-cycle overcurrent limiting control. The inductor current is monitored during the OFF state
and the controller keeps the OFF state during the inductor current is larger than the overcurrent trip level. To
provide both good accuracy and cost effective solution, the TPS51211 supports temperature compensated
MOSFET RDS(on) sensing. The TRIP pin should be connected to GND through the trip voltage setting resistor,
RTRIP. The TRIP terminal sources ITRIP current, which is 10mA typically at room temperature, and the trip level is
set to the OCL trip voltage VTRIP as shown in Equation 4. Note that VTRIP is limited up to approximately 3 V
internally.
(4)
The inductor current is monitored by the voltage between GND pad and SW pin so that the SW pin should be
connected to the drain terminal of the low-side MOSFET properly. ITRIP has 4700ppm/°C temperature slope to
compensate the temperature dependency of the RDS(on). GND is used as the positive current sensing node so
that GND should be connected to the proper current sensing device, i.e. the source terminal of the low-side
MOSFET.
As the comparison is done during the OFF state, VTRIP sets valley level of the inductor current. Thus, the load
(5)
In an overcurrent condition, the current to the load exceeds the current to the output capacitor thus the output
voltage tends to fall down. Eventually, it crosses the undervoltage protection threshold and shuts down the
controller.
OVER/UNDER VOLTAGE PROTECTION
TPS51211 monitors a resistor divided feedback voltage to detect over and undervoltage. When the feedback
voltage becomes higher than 120% of the target voltage, the OVP comparator output goes high and the circuit
latches as the high-side MOSFET driver OFF and the low-side MOSFET driver ON.
When the feedback voltage becomes lower than 70% of the target voltage, the UVP comparator output goes
high and an internal UVP delay counter begins counting. After a 1-ms delay, TPS51211 latches OFF both
high-side and low-side MOSFETs drivers. This function is enabled after 1.2 ms following EN has become high.
UVLO PROTECTION
TPS51211 has V5IN undervoltage lockout protection (UVLO). When the V5IN voltage is lower than UVLO
threshold voltage, the switch mode power supply shuts off. This is non-latch protection.
THERMAL SHUTDOWN
TPS51211 monitors the die temperature. If the temperature exceeds the threshold value (typically 145°C), the
TPS51211 is shut off. This is non-latch protection.
Copyright 2010, Texas Instruments Incorporated
15
相關PDF資料 |
PDF描述 |
|---|---|
| TPS51211DSCR | SWITCHING CONTROLLER, 314 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS51220ARTVR | DUAL SWITCHING CONTROLLER, 333 kHz SWITCHING FREQ-MAX, PQCC32 |
| TPS51221RTVRG4 | DUAL SWITCHING CONTROLLER, 333 kHz SWITCHING FREQ-MAX, PQCC32 |
| TPS51315RGFR | SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PQCC40 |
| TPS51315RGFT | SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PQCC40 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS51212DSCR | 制造商:Texas Instruments 功能描述:LOW COST SINGLE PHASE DC/DC CONTROLLER |
| TPS51216 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Complete DDR2, DDR3 and DDR3L Memory Power Solution Synchronous Buck Controller, 2-A LDO, Buffered Reference |
| TPS51216MRUKREP | 功能描述:D-CAP? Controller, DDR Voltage Regulator IC 2 Output 20-WQFN (3x3) 制造商:texas instruments 系列:D-CAP?? 包裝:剪切帶（CT） 零件狀態:有效 應用:控制器，DDR 電壓 - 輸入:4.5 V ~ 5.5 V 輸出數:2 電壓 - 輸出:0.7 V ~ 1.8 V 工作溫度:-55°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:20-WFQFN 裸露焊盤 供應商器件封裝:20-WQFN（3x3） 標準包裝:1 |
| TPS51216RUKR | 功能描述:DC/DC 開關控制器 Memory Power Sol Sync Buck Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| TPS51216RUKT | 功能描述:DC/DC 開關控制器 Memory Power Sol Sync Buck Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
發布緊急采購，3分鐘左右您將得到回復。