- 您現在的位置：買賣IC網 > PDF目錄98284 > TPS62110MRSAREP (TEXAS INSTRUMENTS INC) 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16 PDF資料下載
參數資料
| 型號： | TPS62110MRSAREP |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16 |
| 封裝： | GREEN, PLASTIC, QFN-16 |
| 文件頁數： | 9/25頁 |
| 文件大小： | 630K |
| 代理商： | TPS62110MRSAREP |
f
L
I
V
O
V
O
V
L
I
-
=
D
1
2
m
a x
m
a x
L
I
O
I
L
I
D
+
=
(3)
OUTPUT CAPACITOR SELECTION
www.ti.com .............................................................................................................................................................. SLVS630C – APRIL 2007 – REVISED MAY 2008
Table 2. Advantages and Disadvantages When Designing the Inductor and Output Capacitor
INFLUENCE ON STABILITY
ADVANTAGE
DISADVANTAGE
Less output voltage ripple
Increase Cout (>22 F)
Uncritical
None
Less output voltage overshoot /
undershoot during load transient
Higher output voltage ripple
Critical
High output voltage overshoot /
Decrease Cout (<22 F)
Increase inductor value >6.8 H
None
undershoot during load
also
transient
Less gain and phase margin
Less inductor current ripple
More energy stored in the
inductor
→ higher voltage
overshoot during load transient
Higher dc output current possible if
Smaller current rise
→ higher
Increase L (>6.8 H)
Uncritical
operated close to the current limit
voltage undershoot during load
transient
→ do not decrease the
value of Cout due to these
effects
Critical
High inductor current ripple
Small voltage overshoot / undershoot
especially at high input voltage
Decrease L (<6.8 H)
Increase output capacitor value >
during load transient
and low output voltage
22 F also
As it is shown in Table 2, the inductor value can be increased to higher values. For good performance, the
peak-to-peak inductor current ripple should be less than 30% of the maximum dc output current. Especially at
input voltages above 12 V, it makes sense to increase the inductor value to keep the inductor current ripple low.
In such applications, the inductor value can be increased to 10 H or 22 H. Values above 22 H should be
avoided to keep the voltage overshoot during load transient in an acceptable range.
After choosing the inductor value, two additional inductor parameters should be considered:
1. current rating of the inductor
2. dc resistance
The dc resistance of the inductance directly influences the efficiency of the converter. Therefore, an inductor with
lowest dc resistance should be selected for highest efficiency. To avoid saturation of the inductor, the inductor
should be rated at least for the maximum output current plus the inductor ripple current which is calculated as:
Where:
f = Switching frequency (1000 kHz typical)
L = Inductor value
ΔIL = Peak-to-peak inductor ripple current
IL(max) = Maximum inductor current
The highest inductor current occurs at maximum VI. A more conservative approach is to select the inductor
current rating just for the maximum switch current of the TPS6211x, which is 2.4 A (typically). See Table 1 for
recommended inductors.
A 22
F (typical) output capacitor is needed with a 6.8 H inductor. For an output voltage greater than 5 V, a 33
F (minimum) output capacitor is required for stability. For best performance, a low ESR ceramic output
capacitor is needed.
The RMS ripple current is calculated as:
Copyright 2007–2008, Texas Instruments Incorporated
17
相關PDF資料 |
PDF描述 |
|---|---|
| TPS62110RSAT | 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS62113RSAT | 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS62110RSAR | 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS62111RSATG4 | 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS62111RSAR | 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS62110QRSAREP | 功能描述:IC REG BUCK SYNC ADJ 1.5A 16QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:20 系列:SIMPLE SWITCHER® 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:12V 輸入電壓:4 V ~ 60 V PWM 型:電壓模式 頻率 - 開關:52kHz 電流 - 輸出:1A 同步整流器:無 工作溫度:-40°C ~ 125°C 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 包裝:管件 供應商設備封裝:16-DIP 其它名稱:*LM2575HVN-12LM2575HVN-12 |
| TPS62110QRSARQ1 | 功能描述:直流/直流開關轉換器 AC Adj,1.5A,17V Vin Step-Down Converter RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| TPS62110RSA | 制造商:Texas Instruments 功能描述: |
| TPS62110RSAR | 功能描述:直流/直流開關調節器 Adj 1.5-A 17-V Vin Step-Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS62110RSARG4 | 功能描述:直流/直流開關轉換器 Adj 1.5-A 17-V Vin Step-Down Converter RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。