- 您現在的位置：買賣IC網 > PDF目錄98284 > TPS62400QDRCQ1 (TEXAS INSTRUMENTS INC) SWITCHING REGULATOR, PDSO10 PDF資料下載
參數資料
| 型號： | TPS62400QDRCQ1 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, PDSO10 |
| 封裝： | 3 X3 MM, PLASTIC, SON-10 |
| 文件頁數： | 11/41頁 |
| 文件大小： | 1319K |
| 代理商： | TPS62400QDRCQ1 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁
TPS62400-Q1, TPS62401-Q1
TPS62402-Q1, TPS62403-Q1
www.ti.com
SLVSA67 – FEBRUARY 2010
With decreasing load current, the device automatically switches into pulse skipping operation in which the power
stage operates intermittently based on load demand. By running cycles periodically the switching losses are
minimized and the device runs with a minimum quiescent current, maintaining high efficiency.
Under-Voltage Lockout
The under-voltage lockout circuit prevents the device from malfunctioning at low input voltages, and from
excessive discharge of the battery, and disables the converters. The under-voltage lockout threshold is typically
1.5V; maximum of 2.35V. In case the default register values are overwritten by the Interface, the new values in
the registers REG_DEF_1_High, REG_DEF_1_Low and REG_DEF_2 remain valid as long the supply voltage
does not fall below the under-voltage lockout threshold, independent of whether the converters are disabled.
MODE SELECTION
The MODE/DATA pin allows mode selection between forced PWM Mode and Power Save Mode for both
converters. Furthermore, this pin is a multipurpose pin and provides (besides Mode selection) a one-pin interface
to receive serial data from a host to set the output voltage. This is described in the EasyScale Interface
section.
Connecting this pin to GND enables the automatic PWM and power save mode operation. The converters
operates in fixed-frequency PWM mode at moderate-to-heavy loads, and in the PFM mode during light loads,
maintaining high efficiency over a wide load current range.
Pulling the MODE/DATA pin high forces both converters to operate constantly in the PWM mode, even at light
load currents. The advantage is that the converters operate with a fixed frequency, allowing simple filtering of the
switching frequency for noise-sensitive applications. In this mode, the efficiency is lower compared to the power
save mode during light loads. For additional flexibility, it is possible to switch from power save mode to forced
PWM mode during operation. This allows efficient power management by adjusting the operation of the converter
to the specific system requirements.
In case the operation mode is changed from forced PWM mode (MODE/DATA = high) to Power Save Mode
Enable (MODE/DATA = 0), the Power Save Mode is enabled after a delay time of ttimeout , which is max. 520ms.
The forced PWM Mode operation is enabled immediately with Pin MODE/DATA set to 1.
ENABLE
The device has a separate EN pin for each converter to start up each converter independently. If EN1 and EN2
are set to high, the corresponding converter starts up with soft start as previously described.
Pulling EN1 and EN2 pin low forces the device into shutdown, with a shutdown quiescent current of typically
1.2mA. In this mode, the P and N-Channel MOSFETs are turned-off and the entire internal control circuitry is
switched-off. For proper operation the EN1 and EN2 pins must be terminated and must not be left floating.
DEF_1 PIN FUNCTION
The DEF_1 pin is dedicated to converter 1 and makes the output voltage selection very flexible to support
dynamic voltage management.
Depending on the device version, this pin works either as:
1. Analog input for adjustable output voltage setting (TPS62400):
–
Connecting an external resistor network to this pin adjusts the default output voltage to any value starting
from 0.6V to VIN
2. Digital input for fixed default output voltage selection (TPS62401):
–
In case this pin is tied to low level, the output voltage is set according to the value in register
REG_DEF_1_Low. The default voltage will be 1.575V. If tied to high level, the output voltage is set
according to the value in register REG_DEF_1_High. The default value in this case is 1.1V. Depending
on the level of Pin DEF_1, it selects between the two registers REG_DEF_1_Low and REG_DEF_1_High
for output voltage setting. Each register content (and therefore output voltage) can be changed
individually via the EasyScale interface. This makes the device very flexible in terms of output voltage
setting; see Table 4.
Copyright 2010, Texas Instruments Incorporated
19
Product Folder Link(s) :TPS62404-Q1
相關PDF資料 |
PDF描述 |
|---|---|
| TPS62410DRCTG4 | 1.6 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS62420DRCT | 1.61 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS62420DRC | 1.61 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS62421DRCR | 1.61 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS62510DRCRG4 | 1.5 A SWITCHING REGULATOR, 1700 kHz SWITCHING FREQ-MAX, PDSO10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS62400QDRCRQ1 | 功能描述:直流/直流開關轉換器 AC Dual Adj SD Cnvtr RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| TPS62401DRCR | 功能描述:直流/直流開關調節器 Dual 400mA & 600mA 2.25MHz St-Down RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS62401DRCRG4 | 功能描述:直流/直流開關調節器 Dual 400mA & 600mA 2.25MHz St-Down RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS62401DRCT | 功能描述:直流/直流開關調節器 Dual 400mA and 600mA 2.25MHz Step-Dwn RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS62401DRCTG4 | 功能描述:直流/直流開關調節器 Dual 400mA & 600mA 2.25MHz St-Down RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
發布緊急采購，3分鐘左右您將得到回復。