- 您現在的位置：買賣IC網 > PDF目錄98285 > TPS62676YFDR (TEXAS INSTRUMENTS INC) SWITCHING REGULATOR, PBGA6 PDF資料下載
參數資料
| 型號： | TPS62676YFDR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, PBGA6 |
| 封裝： | 0.40 MM HEIGHT, DSBGA-6 |
| 文件頁數： | 9/28頁 |
| 文件大小： | 750K |
| 代理商： | TPS62676YFDR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
www.ti.com
SLVS952 – APRIL 2010
DETAILED DESCRIPTION
OPERATION
The TPS6267x is a synchronous step-down converter typically operates at a regulated 6-MHz frequency pulse
width modulation (PWM) at moderate to heavy load currents. At light load currents, the TPS6267x converter
operates in power-save mode with pulse frequency modulation (PFM).
The converter uses a unique frequency locked ring oscillating modulator to achieve best-in-class load and line
response and allows the use of tiny inductors and small ceramic input and output capacitors. At the beginning of
each switching cycle, the P-channel MOSFET switch is turned on and the inductor current ramps up rising the
output voltage until the main comparator trips, then the control logic turns off the switch.
One key advantage of the non-linear architecture is that there is no traditional feed-back loop. The loop response
to change in VO is essentially instantaneous, which explains the transient response. The absence of a traditional,
high-gain compensated linear loop means that the TPS6267x is inherently stable over a range of L and CO.
Although this type of operation normally results in a switching frequency that varies with input voltage and load
current, an internal frequency lock loop (FLL) holds the switching frequency constant over a large range of
operating conditions.
Combined with best in class load and line transient response characteristics, the low quiescent current of the
device (ca. 17mA) allows to maintain high efficiency at light load, while preserving fast transient response for
applications requiring tight output regulation.
Using the YFD package allows for a low profile solution size (0.4mm max height, including external components).
The recommended external components are stated within the application information. The maximum output
current is 500mA when these specific low profile external components are used.
SWITCHING FREQUENCY
The magnitude of the internal ramp, which is generated from the duty cycle, reduces for duty cycles either set of
50%. Thus, there is less overdrive on the main comparator inputs which tends to slow the conversion down. The
intrinsic maximum operating frequency of the converter is about 10MHz to 12MHz, which is controlled to circa.
6MHz by a frequency locked loop.
When high or low duty cycles are encountered, the loop runs out of range and the conversion frequency falls
below 6MHz. The tendency is for the converter to operate more towards a "constant inductor peak current" rather
than a "constant frequency". In addition to this behavior which is observed at high duty cycles, it is also noted at
low duty cycles.
When the converter is required to operate towards the 6MHz nominal at extreme duty cycles, the application can
be assisted by decreasing the ratio of inductance (L) to the output capacitor's equivalent serial inductance (ESL).
This increases the ESL step seen at the main comparator's feed-back input thus decreasing its propagation
delay, hence increasing the switching frequency.
POWER-SAVE MODE
If the load current decreases, the converter will enter Power Save Mode operation automatically (does not apply
for TPS62674). During power-save mode the converter operates in discontinuous current (DCM) single-pulse
PFM mode, which produces low output ripple compared with other PFM architectures.
When in power-save mode, the converter resumes its operation when the output voltage trips below the nominal
voltage. It ramps up the output voltage with a minimum of one pulse and goes into power-save mode when the
inductor current has returned to a zero steady state. The PFM on-time varies inversely proportional to the input
voltage and proportional to the output voltage giving the regulated switching frequency when in steady-state.
PFM mode is left and PWM operation is entered as the output current can no longer be supported in PFM mode.
As a consequence, the DC output voltage is typically positioned ca. 0.5% above the nominal output voltage and
the transition between PFM and PWM is seamless.
Copyright 2010, Texas Instruments Incorporated
17
Product Folder Link(s): TPS6267x
相關PDF資料 |
PDF描述 |
|---|---|
| TPS62677YFDR | SWITCHING REGULATOR, PBGA6 |
| TPS62677YFDT | SWITCHING REGULATOR, PBGA6 |
| TPS62690YFFR | 0.5 A SWITCHING REGULATOR, 4400 kHz SWITCHING FREQ-MAX, BGA6 |
| TPS62691YFFT | 0.6 A SWITCHING REGULATOR, 4400 kHz SWITCHING FREQ-MAX, BGA6 |
| TPS62751DSKR | 1.8 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS62679ZYFMR | 功能描述:直流/直流開關轉換器 500mA,6MHz Hi-Eff Step-Down Converter RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| TPS62679ZYFMT | 功能描述:直流/直流開關轉換器 500mA,6MHz Hi-Eff Step-Down Converter RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| TPS62684YFFR | 功能描述:Buck Switching Regulator IC Positive Fixed 2.85V 1 Output 1.6A 6-UFBGA, DSBGA 制造商:texas instruments 系列:- 包裝:剪切帶（CT） 零件狀態:有效 功能:降壓 輸出配置:正 拓撲:降壓 輸出類型:固定 輸出數:1 電壓 - 輸入（最小值）:3.25V 電壓 - 輸入（最大值）:5.5V 電壓 - 輸出（最小值/固定）:2.85V 電壓 - 輸出（最大值）:- 電流 - 輸出:1.6A 頻率 - 開關:5.5MHz 同步整流器:是 工作溫度:-40°C ~ 85°C（TA） 安裝類型:表面貼裝 封裝/外殼:6-UFBGA，DSBGA 供應商器件封裝:6-DSBGA 標準包裝:1 |
| TPS62690EVM-076 | 功能描述:電源管理IC開發工具 TPS62690 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS62690YFFR | 功能描述:直流/直流開關轉換器 500mA,4MHz,2.85Vout Hi-Eff St-Dwn Cnvrtr RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。