- 您現在的位置：買賣IC網 > PDF目錄98285 > TPS65131RGERG4 (TEXAS INSTRUMENTS INC) 2.2 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PQCC24 PDF資料下載
參數資料
| 型號： | TPS65131RGERG4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 2.2 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PQCC24 |
| 封裝： | 4 X 4 MM, GREEN, PLASTIC, QFN-24 |
| 文件頁數： | 16/34頁 |
| 文件大小： | 785K |
| 代理商： | TPS65131RGERG4 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
www.ti.com
APPLICATION INFORMATION
Design Procedure
Programming the Output Voltage
R1 + R2
V
POS
V
REF
* 1
(1)
VPOS
VNEG
Q1
L1
D1
C1
4.7 mF
U1
C2
4.7 mF
C3
0.1 mF
VPOS
FBP
VREF
FBN
VNEG
OUTN
CP
CN
PGND
INP
BSW
INN
VIN
ENP
PSP
ENN
PSN
GND
TPS65130
R1
R2
C4
4x4.7 mF
R4
R3
D2
C8
0.22 mF
L2
4.7 mH
C7
C6
R7
4.7 mH
R8
C9
R9
C10
VIN
C5
4x4.7 mF
TPS65130, TPS65131
SLVS493B – MARCH 2004 – REVISED SEPTEMBER 2004
The TPS65130/1 dc-dc converter is intended for systems typically powered by a single-cell Li-ion or Li-polymer
battery with a terminal voltage between 2.7 V up to 4.2 V. Because the recommended input voltage goes up to
5.5 V, the device is also suitable for 3-cell alkaline, NiCd, or NiMH batteries, as well as any regulated supply
voltages between 2.7 V and 5.5 V. It provides two independent output voltage rails which are programmed as
follows.
Boost Converter
The output voltage of the TPS65130/1 boost converter stage can be adjusted with an external resistor divider
connected to the FBP pin. The typical value of the voltage at the FBP pin is the reference voltage, which is 1.213
V. The maximum recommended output voltage at the boost converter is 15 V. To achieve appropriate accuracy,
the current through the feedback divider should be about 100 times higher than the current into the FBP pin.
Typical current into the FBP pin is 0.05 A, and the voltage across R2 is 1.213 V. Based on those values, the
recommended value for R2 should be lower than 200 k in order to set the divider current at 5 A or higher.
Depending on the needed output voltage (VPOS), the value of the resistor R1 can then be calculated using
Equation 1:
As an example, if an 8-V output is needed, and a resistor of 180 k
has been chosen for R
2, a 1-M resistor is
needed to program the desired output voltage.
Inverting Converter
The output voltage of the TPS65130/1 inverting converter stage can also be adjusted with an external resistor
divider. It must be connected to the FBN pin. In difference to the feedback divider at the boost converter, the
reference point of the feedback divider is not GND; it is VREF. So the typical value of the voltage at the FBN pin is
0 V. The minimum recommended output voltage at the inverting converter is –15 V. Feedback divider current
23
相關PDF資料 |
PDF描述 |
|---|---|
| TPS65136RTE | 1.12 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS65136RTER | 1.12 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS65150PWPR | 3-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO24 |
| TPS65161APWP | 5.5 A SWITCHING REGULATOR, 900 kHz SWITCHING FREQ-MAX, PDSO28 |
| TPS65161PWPRG4 | 4.2 A SWITCHING REGULATOR, 900 kHz SWITCHING FREQ-MAX, PDSO28 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS65131RGET | 功能描述:DC/DC 開關控制器 Adj Dl Otp Switch Boost DC/DC RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| TPS65131RGET | 制造商:Texas Instruments 功能描述:IC CONV DC/DC POS/NEG 24-QFN |
| TPS65131RGET | 制造商:Texas Instruments 功能描述:DC/DC CONVERTER IC ((NW)) 制造商:Texas Instruments 功能描述:IC, DC/DC CONVERTER, VQFN-24 |
| TPS65131RGETG4 | 功能描述:DC/DC 開關控制器 Adj Dl Otp Switch Boost DC/DC RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| TPS65131TRGERQ1 | 制造商:Texas Instruments 功能描述:IC REG BST INV ADJ 2A DL 24VQFN 制造商:Texas Instruments 功能描述:TPS65131TRGERQ1 |
發布緊急采購，3分鐘左右您將得到回復。