欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: TPS77050DBV
廠商: Texas Instruments, Inc.
英文描述: ULTRA LOW-POWER 50-mA LOW-DROPOUT LINEAR REGULATORS
中文描述: 超低功耗50 mA的低壓降線性穩壓器
文件頁數: 12/16頁
文件大小: 230K
代理商: TPS77050DBV
TPS77001, TPS77012, TPS77015, TPS77018, TPS77025
TPS77027, TPS77028, TPS77030, TPS77033, TPS77050
ULTRA LOW-POWER 50-mA LOW-DROPOUT LINEAR REGULATORS
SLVS210C – JUNE 1999 – REVISED SEPTEMBER 1999
12
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
external capacitor requirements
Although not required, a 0.047-
μ
F or larger ceramic input bypass capacitor, connected between IN and GND
and located close to the TPS770xx, is recommended to improve transient response and noise rejection. A
higher-value electrolytic input capacitor may be necessary if large, fast-rise-time load transients are anticipated
and the device is located several inches from the power source.
Like all low dropout regulators, the TPS770xx requires an output capacitor connected between OUT and GND
to stabilize the internal control loop. The minimum recommended capacitance is 4.7
μ
F. The ESR (equivalent
series resistance) of the capacitor should be between 0.2
and 10
. to ensure stability. Capacitor values larger
than 4.7
μ
F are acceptable, and allow the use of smaller ESR values. Capacitances less than 4.7
μ
F are not
recommended because they require careful selection of ESR to ensure stability. Solid tantalum electrolytic,
aluminum electrolytic, and multilayer ceramic capacitors are all suitable, provided they meet the requirements
described above. Most of the commercially available 4.7
μ
F surface-mount solid tantalum capacitors, including
devices from Sprague, Kemet, and Nichico, meet the ESR requirements stated above. Multilayer ceramic
capacitors may have very small equivalent series resistances and may thus require the addition of a low value
series resistor to ensure stability.
CAPACITOR SELECTION
PART NO.
MFR.
VALUE
4.7
μ
F
10
μ
F
10
μ
F
4.7
μ
F
MAX ESR
1.5
1.5
1.3
0.6
SIZE (H
×
L
×
W)
1.9
×
3.5
×
2.8
1.3
×
7.0
×
2.7
2.5
×
7.6
×
2.5
2.6
×
6.0
×
3.2
T494B475K016AS
KEMET
195D106x0016x2T
SPRAGUE
695D106x003562T
SPRAGUE
TPSC475K035R0600
Size is in mm. ESR is maximum resistance in Ohms at 100 kHz and TA = 25
°
C. Contact manufacturer for minimum ESR values.
AVX
相關PDF資料
PDF描述
TPS77518-EP Military Enhanced Plastic Fast-Transient-Response 500-mA Low-Dropout Voltage Regulators
TPS77518-Q1 Automotive Catalog Fast Transient-Response 500-mA Low-Dropout Voltage Regulators
TPS77615PWPRG4 FAST-TRANSIENT-RESPONSE 500mA LOW-DROPOUT VOLTAGE REGULATORS
TPS77525PWPRG4 FAST-TRANSIENT-RESPONSE 500mA LOW-DROPOUT VOLTAGE REGULATORS
TPS775XX FAST-TRANSIENT-RESPONSE 500mA LOW-DROPOUT VOLTAGE REGULATORS
相關代理商/技術參數
參數描述
TPS77050DBVR 功能描述:低壓差穩壓器 - LDO 5.0V 50mA LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20
TPS77050DBVRG4 功能描述:低壓差穩壓器 - LDO Ultra Low-Power 50-mA LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20
TPS77050DBVT 功能描述:低壓差穩壓器 - LDO 5.0V 50mA LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20
TPS77050DBVTG4 功能描述:低壓差穩壓器 - LDO Ultra Low-Power 50-mA LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20
TPS77101DGK 功能描述:低壓差穩壓器 - LDO 150-mA LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20
主站蜘蛛池模板: 湟源县| 沅江市| 仲巴县| 桓台县| 玛纳斯县| 凤城市| 北流市| 平南县| 岗巴县| 汝南县| 黄梅县| 衡水市| 田阳县| 太仆寺旗| 崇礼县| 南江县| 周宁县| 高清| 霞浦县| 元朗区| 晋中市| 忻城县| 平利县| 河东区| 淳安县| 荆门市| 洛隆县| 山西省| 桦川县| 嘉定区| 嫩江县| 手游| 白水县| 西充县| 小金县| 梅河口市| 环江| 林周县| 勃利县| 延川县| 乌兰浩特市|