- 您現在的位置：買賣IC網 > PDF目錄382684 > TPS79328YEQ (Texas Instruments, Inc.) ULTRALOW-NOISE, HIGH PSRR, FAST RF 200-mA LOW-DROPOUT LINEAR REGULATORS IN NANOSTAR? WAFER CHIP SCALE AND SOT23 PDF資料下載
參數資料
| 型號： | TPS79328YEQ |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | ULTRALOW-NOISE, HIGH PSRR, FAST RF 200-mA LOW-DROPOUT LINEAR REGULATORS IN NANOSTAR? WAFER CHIP SCALE AND SOT23 |
| 中文描述： | 超低噪聲，高PSRR，快速射頻200毫安低壓降線性穩壓器呢？NANOSTAR晶圓級和SOT23 |
| 文件頁數： | 9/18頁 |
| 文件大小： | 456K |
| 代理商： | TPS79328YEQ |
www.ti.com
APPLICATION INFORMATION
V
IN
V
OUT
TPS793xx
GND
EN
NR
IN
OUT
V
IN
V
OUT
0.1
μ
F
0.01
μ
F
2.2
μ
F
External Capacitor Requirements
A 0.1-μF or larger ceramic input bypass capacitor, connected between IN and GND and located close to the
TPS793xx, is required for stability and improves transient response, noise rejection, and ripple rejection. A
higher-value input capacitor may be necessary if large, fast-rise-time load transients are anticipated or the device
is located several inches from the power source.
Board Layout Recommendation to Improve PSRR and Noise Performance
To improve ac measurements like PSRR, output noise, and transient response, it is recommended that the board
be designed with separate ground planes for V
IN
and V
OUT
, with each ground plane connected only at the GND
pin of the device. In addition, the ground connection for the bypass capacitor should connect directly to the GND
pin of the device.
TPS79301, TPS79318
TPS79325, TPS79328, TPS793285
TPS79330, TPS79333, TPS793475
SLVS348H–JULY 2001–REVISED OCTOBER 2004
The TPS793xx family of low-dropout (LDO) regulators has been optimized for use in noise-sensitive
battery-operated equipment. The device features extremely low dropout voltages, high PSRR, ultralow output
noise, low quiescent current (170 μA typically), and enable-input to reduce supply currents to less than 1 μA
when the regulator is turned off.
A typical application circuit is shown in Figure 22.
Figure 22. Typical Application Circuit
Like most low dropout regulators, the TPS793xx requires an output capacitor connected between OUT and GND
to stabilize the internal control loop. The minimum recommended capacitance is 2.2 μF. Any 2.2-μF or larger
ceramic capacitor is suitable, provided the capacitance does not vary significantly over temperature. If load
current is not expected to exceed 100 mA, a 1.0-μF ceramic capacitor can be used.
The internal voltage reference is a key source of noise in an LDO regulator. The TPS793xx has an NR pin which
is connected to the voltage reference through a 250-k
internal resistor. The 250-k
internal resistor, in
conjunction with an external bypass capacitor connected to the NR pin, creates a low pass filter to reduce the
voltage reference noise and, therefore, the noise at the regulator output. In order for the regulator to operate
properly, the current flow out of the NR pin must be at a minimum, because any leakage current creates an IR
drop across the internal resistor thus creating an output error. Therefore, the bypass capacitor must have
minimal leakage current. The bypass capacitor should be no more than 0.1-μF to ensure that it is fully charged
during the quickstart time provided by the internal switch shown in the Functional Block Diagrams
As an example, the TPS79328 exhibits only 32 μV
RMS
of output voltage noise using a 0.1-μF ceramic bypass
capacitor and a 2.2-μF ceramic output capacitor. Note that the output starts up slower as the bypass capacitance
increases due to the RC time constant at the NR pin that is created by the internal 250-k
resistor and external
capacitor.
9
相關PDF資料 |
PDF描述 |
|---|---|
| TPS79330YEQ | ULTRALOW-NOISE, HIGH PSRR, FAST RF 200-mA LOW-DROPOUT LINEAR REGULATORS IN NANOSTAR? WAFER CHIP SCALE AND SOT23 |
| TPS79330YEQT | ULTRALOW-NOISE, HIGH PSRR, FAST RF 200-mA LOW-DROPOUT LINEAR REGULATORS IN NANOSTAR? WAFER CHIP SCALE AND SOT23 |
| TPS793285YEQR | ULTRALOW-NOISE, HIGH PSRR, FAST RF 200-mA LOW-DROPOUT LINEAR REGULATORS IN NANOSTAR? WAFER CHIP SCALE AND SOT23 |
| TPS79325YEQ | ULTRALOW-NOISE, HIGH PSRR, FAST RF 200-mA LOW-DROPOUT LINEAR REGULATORS IN NANOSTAR? WAFER CHIP SCALE AND SOT23 |
| TPS793285YEQ | ULTRALOW-NOISE, HIGH PSRR, FAST RF 200-mA LOW-DROPOUT LINEAR REGULATORS IN NANOSTAR? WAFER CHIP SCALE AND SOT23 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS79328YEQEVM | 功能描述:電源管理IC開發工具 TPS79328Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS79328YEQR | 功能描述:低壓差穩壓器 - LDO High PSRR Fast RF High-Enable 200mA RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TPS79328YEQT | 功能描述:低壓差穩壓器 - LDO High PSRR Fast RF High-Enable 200mA RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TPS79328YZQR | 功能描述:低壓差穩壓器 - LDO High PSRR Fast RF High-Enable 200mA RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TPS79328YZQT | 功能描述:低壓差穩壓器 - LDO High PSRR Fast RF High-Enable 200mA RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
發布緊急采購，3分鐘左右您將得到回復。