欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: TRC1300DR
廠商: TEXAS INSTRUMENTS INC
元件分類: 搖控器
英文描述: RF, REMOTE CONTROL SUPPORT CIRCUIT, PDSO14
封裝: PLASTIC, SO-14
文件頁數: 10/27頁
文件大小: 358K
代理商: TRC1300DR
TRC1300, TRC1315
MARCSTAR
I E/D
REMOTE CONTROL ENCODER/DECODERS
SLWS011D – AUGUST 1996 – REVISED JANUARY 1997
18
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
PRINCIPLES OF OPERATION
amplifier/comparator (continued)
The amplifier/comparator is implemented with advanced switched-capacitor technology. This is done for two
primary reasons. First, since the TRC1300 and TRC1315 devices are variable frequency, the values of R1, C1,
R2, and C2 must change depending on the received data rate. Since they are a switched-capacitor design, the
filter characteristics scale depending on the oscillator in the decoder device, which must match the encoder
oscillator frequency. With this scheme, the amplifier/comparator section functions at all received code data
rates. The second reason for using switched-capacitor filters is the increased accuracy and precise filter
response that they provide.
programming mode
The MARCSTAR I E/D devices have been designed so that no programming station is required to load the
security codes into the EEPROM memory. When the device is configured as an encoder, it generates a 40-bit
security code and stores it in EEPROM memory. When configured as a decoder, the device learns the security
code from up to four different encoders.
EEPROM stored-code format
The EEPROM memory contains four banks that are used for 40 bits of security code for each of the four channels
and an additional 32 bits (eight bits per channel) for error detection. The total EEPROM memory is 192 bits.
When configured as a decoder, these EEPROM banks store up to four learned 40-bit security codes; when
configured as an encoder, only the first bank of 40 bits is used for the security code.
programming — encoder
When a MARCSTAR I E/D device is configured as an encoder and placed in the programming mode, it
generates a 40-bit security code and stores it in the first 40-bit EEPROM memory bank. The remaining three
40-bit memory banks are unused. An LED connected to the LED terminal is required to verify a proper write
sequence to EEPROM. The LED anode should be connected to the positive supply and the cathode should be
connected to the LED terminal of the MARCSTAR I E/D through a current-limiting resistor.
The procedure for programming a MARCSTAR I E/D device configured as an encoder is described in the
following steps:
1.
Connect the proper RC combination to the OSCR and OSCC terminals to set the frequency of the
internal oscillator.
2.
Connect GND and then apply VCC.
3.
Apply a logic high to PROG (the PROG terminal is internally pulled down and debounced). The device
assumes the program mode. The LED lights, the device generates a new 40-bit security code internally,
it loads the first memory bank with that code, and then extinguishes the LED.
4.
The MARCSTAR I E/D encoder is now programmed with a new 40-bit security code. Each time step 3 is
repeated, a new 40-bit security code is generated and then loaded into the first EEPROM memory
location, overwriting the previous security code.
相關PDF資料
PDF描述
TRC1300D RF, REMOTE CONTROL SUPPORT CIRCUIT, PDSO14
TRC1315N RF, REMOTE CONTROL SUPPORT CIRCUIT, PDIP16
TRC1315DR RF, REMOTE CONTROL SUPPORT CIRCUIT, PDSO14
TRC1315D RF, REMOTE CONTROL SUPPORT CIRCUIT, PDSO14
TRF7960RHBR SPECIALTY CONSUMER CIRCUIT, PQCC32
相關代理商/技術參數
參數描述
TRC1300N 制造商:Rochester Electronics LLC 功能描述:- Bulk
TRC1315 制造商:TI 制造商全稱:Texas Instruments 功能描述:MARCSTAR I E/D REMOTE CONTROL ENCODER/DECODERS
TRC1315D 制造商:Rochester Electronics LLC 功能描述:- Bulk
TRC1315N 制造商:Rochester Electronics LLC 功能描述:- Bulk
TRC1331S-501 功能描述:LED TRIPLE 1.1W COOL WHITE 30DEG RoHS:是 類別:光電元件 >> LED - 高亮度電源模塊 系列:1W-型 標準包裝:36 系列:5027 TFFC STAR K2 顏色:暖白色 配置:星形 在特定電流下的光通量 - 測試:75lm 電流 - 測試:350mA 電流 - 最大:1.5A 帶連接器:無 驅動器電路:無 波長:- 電壓:-
主站蜘蛛池模板: 黄平县| 黔西| 水富县| 重庆市| 驻马店市| 定边县| 呼图壁县| 鱼台县| 温宿县| 宜州市| 沁源县| 遵化市| 黄冈市| 长丰县| 蓬安县| 定安县| 尼勒克县| 沙湾县| 绥化市| 都兰县| 大竹县| 宝丰县| 泽库县| 手游| 济南市| 盐津县| 鹤峰县| 阿鲁科尔沁旗| 丰城市| 隆德县| 调兵山市| 宜都市| 灵武市| 乳源| 江都市| 聂荣县| 西昌市| 呼玛县| 萨嘎县| 汤原县| 临洮县|