- 您現在的位置：買賣IC網 > PDF目錄382685 > TRU2500-L Telecomm/Datacomm PDF資料下載
參數資料
| 型號： | TRU2500-L |
| 元件分類： | 通信、網絡模塊及開發工具 |
| 英文描述： | Telecomm/Datacomm |
| 中文描述： | 電信/數據通信 |
| 文件頁數： | 8/12頁 |
| 文件大小： | 825K |
| 代理商： | TRU2500-L |
Vectron International 166 Glover Avenue, Norwalk, CT 06856 Tel: 1-88-VECTRON-1 Fax: 1-888-FAX-VECTRON
Several parameters may be measured on a clock
recovery device to characterize its response to initial
start up and transient input data bursts. In convention-
al Phase Locked Loop designs an internal VCO func-
tions as a clock source which must be synchronized
by the loop to the input data rate. The time needed to
synchronize the internal clock and provide error free
data retiming after a long period without input data
transitions is the acquisition time. The response time
to shorter time intervals with no data transitions is
sometimes referred to input blanking. A third measure
of the retiming function is the maximum run length of
ones or zeros with no errors.
A clock recovery device will provide error free perfor-
mance up to a specified maximum number of consec-
utive ones or zeros. In a PLL design, synchronization
is lost briefly and errors occur for a short interval until
synchronization is reestablished. As the run length
increases the PLL drifts further from lock and the
error interval becomes longer. Eventually a limit is
reached where the device is starting from a maximum
frequency offset and the recovery time is the acquisi-
tion time. A PLL will output a frequency with consider-
able error with no data input.
Passive filter based clock recovery depends on the
selectivity or Q of the filter along with the gain of
associated amplifiers to build up a clock signal
derived directly from the input data. Evaluation of the
TRU-2500 shows that the clock signal reaches full
amplitude in about 350ns with a random data input.
Further evaluation shows that error free data is avail-
able at the output after a 250ns interval, less than
1000 data transitions. This interval may be shortened
through the use of a preamble. This acquisition time
is three orders of magnitude shorter than a compara-
ble PLL based design. A plot comparing the recovery
time for input blanking is shown in figure 9.
The SAW filter based TRU-2500 also provides a sta-
ble output clock for a comparable time period of at
least 250ns after input data is stopped. 250ns corre-
spond to 625 bit intervals at 2.5Gbit/s. Evaluation
shows the typical TRU-2500 can run error free with
up to 650 zeros or ones imbedded in a 2e13 random
data pattern.
0
200
1000
100
10
1
0.1
400
600
800
1000
1200
TRU-2500
Input Blanking (us)
R
8
相關PDF資料 |
PDF描述 |
|---|---|
| TRU600A-SERIES | Peripheral IC |
| TRW2307 | Bipolar NPN UHF/Microwave Transisitor |
| TRX-IS | CALIBRATOR MULTIFUNCTION |
| TS182H | SACK TRUCK HEAVY DUTY FOLDIN |
| TS3767 | TRANSISTOR | BJT | PNP | 300V V(BR)CEO | 300MA I(C) | TO-126VAR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TRU3 | 制造商:Ssac 功能描述:Electromechanical Relay SPDT 10A 19V to 30VDC 19V to 264VAC Plug-In |
| TRU5336 | 制造商: 功能描述: 制造商:undefined 功能描述: |
| TRU-600 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TRU-600 |
| TRU6810SL | 制造商:TRU 功能描述: |
| TRU-7002-0001-01 | 制造商:TRU 功能描述:RF COAXIAL PANEL MOUNT CONNECTOR |
發布緊急采購，3分鐘左右您將得到回復。