- 您現在的位置：買賣IC網 > PDF目錄98290 > TS4962MEIJT (STMICROELECTRONICS) 3 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA9 PDF資料下載
參數資料
| 型號： | TS4962MEIJT |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 3 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA9 |
| 封裝： | ROHS COMPLIANT, FCP-9 |
| 文件頁數： | 24/41頁 |
| 文件大?。?/td> | 1104K |
| 代理商： | TS4962MEIJT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁
Application information
TS4962M
30/41
5.5
Decoupling of the circuit
A power supply capacitor, referred to as CS, is needed to correctly bypass the TS4962M.
The TS4962M has a typical switching frequency at 250kHz and output fall and rise time
about 5ns. Due to these very fast transients, careful decoupling is mandatory.
A 1F ceramic capacitor is enough, but it must be located very close to the TS4962M in
order to avoid any extra parasitic inductance created an overly long track wire. In relation
with dI/dt, this parasitic inductance introduces an overvoltage that decreases the global
efficiency and, if it is too high, may cause a breakdown of the device.
In addition, even if a ceramic capacitor has an adequate high frequency ESR value, its
current capability is also important. A 0603 size is a good compromise, particularly when a
4
Ω load is used.
Another important parameter is the rated voltage of the capacitor. A 1F/6.3V capacitor
used at 5V, loses about 50% of its value. In fact, with a 5V power supply voltage, the
decoupling value is about 0.5F instead of 1F. As CS has particular influence on the
THD+N in the medium-high frequency region, this capacitor variation becomes decisive. In
addition, less decoupling means higher overshoots, which can be problematic if they reach
the power supply AMR value (6V).
5.6
Wake-up time (tWU)
When the standby is released to set the device ON, there is a wait of about 5ms. The
TS4962M has an internal digital delay that mutes the outputs and releases them after this
time in order to avoid any pop noise.
5.7
Shutdown time (tSTBY)
When the standby command is set, the time required to put the two output stages into high
impedance and to put the internal circuitry in shutdown mode, is about 5ms. This time is
used to decrease the gain and avoid any pop noise during shutdown.
5.8
Consumption in shutdown mode
Between the shutdown pin and GND there is an internal 300k
Ω resistor. This resistor forces
the TS4962M to be in standby mode when the standby input pin is left floating.
However, this resistor also introduces additional power consumption if the shutdown pin
voltage is not 0V.
For example, with a 0.4V standby voltage pin, Table 2: Operating conditions on page 3,
shows that you must add 0.4V/300k
Ω= 1.3A in typical (0.4V/273kΩ=1.46A in maximum)
to the shutdown current specified in Table 4 on page 5.
5.9
Single-ended input configuration
It is possible to use the TS4962M in a single-ended input configuration. However, input
coupling capacitors are needed in this configuration. The schematic in Figure 61 shows a
single-ended input typical application.
相關PDF資料 |
PDF描述 |
|---|---|
| TS4972IJT | 1.2 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA8 |
| TS4972EIJT | 1.2 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA8 |
| TS4973IJT | 1.2 W, 1 CHANNEL, AUDIO AMPLIFIER, BGA9 |
| TS4973EIJT | 1.2 W, 1 CHANNEL, AUDIO AMPLIFIER, BGA9 |
| TS4973EKIJT | 1.2 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA9 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TS4962MEIKJT | 功能描述:3 W FILTER-FREE CLASS D AUDIO PO 制造商:stmicroelectronics 系列:- 包裝:剪切帶（CT） 零件狀態:在售 類型:D 類 輸出類型:1-通道（單聲道） 不同負載時的最大輸出功率 x 通道數:2.8W x 1 @ 4 歐姆 電壓 - 電源:2.4 V ~ 5.5 V 特性:消除爆音，差分輸入，待機，熱保護 工作溫度:-40°C ~ 85°C（TA） 供應商器件封裝:9-覆晶 封裝/外殼:9-UFBGA 標準包裝:1 |
| TS4972 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:1.2W AUDIO POWER AMPLIFIER WITH STANDBY MODE ACTIVE HIGH |
| TS4972_04 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:1.2W Audio Power Amplifier with Standby Mode Active High |
| TS4972EIJT | 功能描述:音頻放大器 1.2W audio power amp W/Standby RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TS4972EIJT1 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:1.2W Audio Power Amplifier with Standby Mode Active High |
發布緊急采購，3分鐘左右您將得到回復。