- 您現在的位置：買賣IC網 > PDF目錄98290 > TS4990EIKJT (STMICROELECTRONICS) 1.2 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA9 PDF資料下載
參數資料
| 型號： | TS4990EIKJT |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 1.2 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA9 |
| 封裝： | ROHS COMPLIANT, FCP-9 |
| 文件頁數： | 13/32頁 |
| 文件大小： | 797K |
| 代理商： | TS4990EIKJT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
Application information
TS4990
20/31
and the maximum value is obtained when:
and its value is:
Note:
This maximum value is only dependent on power supply voltage and load values.
The efficiency is the ratio between the output power and the power supply:
The maximum theoretical value is reached when VPEAK = VCC, so:
4.5
Decoupling of the circuit
Two capacitors are needed to correctly bypass the TS4990: a power supply bypass
capacitor Cs and a bias voltage bypass capacitor Cb.
Cs has particular influence on the THD+N in the high frequency region (above 7kHz) and an
indirect influence on power supply disturbances. With a value for Cs of 1F, you can expect
THD+N levels similar to those shown in the datasheet.
In the high frequency region, if Cs is lower than 1F, it increases THD+N and disturbances
on the power supply rail are less filtered.
On the other hand, if Cs is higher than 1F, those disturbances on the power supply rail are
more filtered.
Cb has an influence on THD+N at lower frequencies, but its function is critical to the final
result of PSRR (with input grounded and in the lower frequency region).
If Cb is lower than 1F, THD+N increases at lower frequencies and PSRR worsens.
If Cb is higher than 1F, the benefit on THD+N at lower frequencies is small, but the benefit
to PSRR is substantial.
Note that Cin has a non-negligible effect on PSRR at lower frequencies. The lower the value
of Cin, the higher the PSRR.
4.6
Wake-up time (tWU)
When the standby is released to put the device ON, the bypass capacitor Cb is not charged
immediately. Because Cb is directly linked to the bias of the amplifier, the bias will not work
properly until the Cb voltage is correct. The time to reach this voltage is called wake-up time
or tWU and specified in the electrical characteristics tables with Cb =1F.
wake-up time.
δP
diss
δP
out
------------------ = 0
P
diss
max
2V
CC
2
π
2
R
L
---------------
(W)
=
η=
P
out
P
supply
------------------- =
πV
PEAK
4V
CC
-----------------------
π
4
----- = 78.5%
相關PDF資料 |
PDF描述 |
|---|---|
| TS4990EKIJT | 1.2 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA9 |
| TS4990EIJT | 1.2 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA9 |
| TS4990IST | 1.2 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
| TS4990IQT | 1.2 W, 1 CHANNEL, AUDIO AMPLIFIER, DSO8 |
| TS4990IJT | 1.2 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA9 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TS4990EKIJT | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:1.2 W audio power amplifier with active low standby mode |
| TS4990ID | 功能描述:音頻放大器 1.2W audio Pwr amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TS4990IDT | 功能描述:音頻放大器 1.2W audio Pwr amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TS4990IJT | 制造商:ST 功能描述:1W AUDIO POWER AMPLIFIER WITH ACTIVE LOW STANDBY MODE |
| TS4990IQT | 功能描述:音頻放大器 1.2W audio pow. amp. RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。