- 您現在的位置：買賣IC網 > PDF目錄98290 > TS555CPT (STMICROELECTRONICS) PULSE; RECTANGULAR, 2 MHz, TIMER, PDSO8 PDF資料下載
參數資料
| 型號： | TS555CPT |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 模擬波形發生器 |
| 英文描述： | PULSE; RECTANGULAR, 2 MHz, TIMER, PDSO8 |
| 封裝： | TSSOP-8 |
| 文件頁數： | 4/20頁 |
| 文件大小： | 232K |
| 代理商： | TS555CPT |
Application information
TS555
12/20
4
Application information
4.1
Monostable operation
In monostable mode, the timer operates like a one-shot generator. The external capacitor is
initially held discharged by a transistor inside the timer, as shown in Figure 4.
Figure 4.
Application schematic
The circuit triggers on a negative-going input signal when the level reaches 1/3 VCC. Once
triggered, the circuit remains in this state until the set time has elapsed, even if it is triggered
again during this interval. The duration of the output HIGH state is given by t = 1.1 R x C.
Since the charge rate and threshold level of the comparator are both directly proportional to
the supply voltage, the timing interval is independent of the supply. Applying a negative
pulse simultaneously to the Reset terminal (pin 4) and the Trigger terminal (pin 2) during the
timing cycle discharges the external capacitor and causes the cycle to start over. The timing
cycle then starts on the positive edge of the reset pulse. While the reset pulse is applied, the
output is driven to the LOW state.
When a negative trigger pulse is applied to pin 2, the flip-flop is set, releasing the short
circuit across the external capacitor and driving the output HIGH. The voltage across the
capacitor increases exponentially with the time constant
τ = R x C.
When the voltage across the capacitor equals 2/3 VCC, the comparator resets the flip-flop
which then discharges the capacitor rapidly and drives the output to its LOW state. Figure 5
shows the actual waveforms generated in this mode of operation.
When Reset is not used, it should be tied high to avoid any false triggering.
Figure 5.
Timing diagram
VCC
Reset
Trigger
Out
3
2
4
8
7
6
5
1
TS555
R
C
Control Voltage
0.01 F
μ
CAPACITOR VOLTAGE = 2.0V/div
Ω
μ
t = 0.1 ms / div
INPUT = 2.0V/div
OUTPUT VOLTAGE = 5.0V/div
R = 9.1k , C = 0.01 F , R = 1.0k
L
相關PDF資料 |
PDF描述 |
|---|---|
| TS555IN | PULSE; RECTANGULAR, 2 MHz, TIMER, PDIP8 |
| TS555IDT | PULSE; RECTANGULAR, 2 MHz, TIMER, PDSO8 |
| TS5A2066YEPR | DUAL 1-CHANNEL, SGL POLE SGL THROW SWITCH, BGA8 |
| TS5A21366RSER | DUAL 1-CHANNEL, SGL POLE SGL THROW SWITCH, PQCC8 |
| TS5A22366YFCR | DUAL 1-CHANNEL, SGL POLE DOUBLE THROW SWITCH, BGA12 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TS555I | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:LOW POWER SINGLE CMOS TIMER |
| TS555ID | 功能描述:計時器和支持產品 Low Power Single BULK RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel |
| TS555IDT | 功能描述:計時器和支持產品 Low Power Single RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel |
| TS555IDT-CUT TAPE | 制造商:ST 功能描述:TS555 Series 16 V 2.7 MHz Surface Mount Low Power Single CMOS Timer - SOIC-8 |
| TS555IDTTR | 功能描述:555 Type, Timer/Oscillator (Single) IC 2.7MHz 8-SOIC (0.154", 3.90mm Width) 制造商:stmicroelectronics 系列:- 包裝:剪切帶（CT） 零件狀態:在售 類型:555 型，計時器/振蕩器（單路） 計數:- 頻率:2.7MHz 電壓 - 電源:2 V ~ 16 V 電流 - 電源:65μA 工作溫度:-40°C ~ 125°C 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商器件封裝:8-SO 安裝類型:表面貼裝 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。