- 您現在的位置：買賣IC網 > PDF目錄382686 > TS5A2053YEPR (Texas Instruments, Inc.) SINGLE-CHANNEL 10-OHM SPDT ANALOG SWITCH WITH ENABLE PDF資料下載
參數資料
| 型號： | TS5A2053YEPR |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | SINGLE-CHANNEL 10-OHM SPDT ANALOG SWITCH WITH ENABLE |
| 中文描述： | 單通道10 - Ohm的單刀雙擲模擬開關，具備啟動 |
| 文件頁數： | 14/23頁 |
| 文件大?。?/td> | 310K |
| 代理商： | TS5A2053YEPR |
SCDS183 – JANUARY 2005
www.ti.com
14
PIN DESCRIPTION
PIN
NUMBER
NAME
DESCRIPTION
1
COM
Common
2
EN
Chip enable (active low)
3
GND
Digital ground
4
GND
Digital ground
5
IN
Digital control to connect COM to NC or NO
6
NO
Normally open
7
NC
Normally close
8
V+
Power supply
PARAMETER DESCRIPTION
SYMBOL
VCOM
VNC
VNO
ron
ron
ron(flat)
INC(OFF)
INO(OFF)
DESCRIPTION
Voltage at COM
Voltage at NC
Voltage at NO
Resistance between COM and NC or COM and NO ports when the channel is ON
Difference of ron between channels in a specific device
Difference between the maximum and minimum value of ron in a channel over the specified range of conditions
Leakage current measured at the NC port, with the corresponding channel (NC to COM) in the OFF state
Leakage current measured at the NO port, with the corresponding channel (NO to COM) in the OFF state
INC(ON)
Leakage current measured at the NC port, with the corresponding channel (NC to COM) in the ON state and the output (COM)
open
INO(ON)
Leakage current measured at the NO port, with the corresponding channel (NO to COM) in the ON state and the output (COM)
open
ICOM(OFF)
Leakage current measured at the COM port, with the corresponding channel (COM to NO or COM to NC) in the OFF state and
the output (NC or NO) open
ICOM(ON)
Leakage current measured at the COM port, with the corresponding channel (COM to NO or COM to NC) in the ON state and
the output (NC or NO) open
VIH
VIL
VI
IIH, IIL
Minimum input voltage for logic high for the control input (IN, EN)
Maximum input voltage for logic low for the control input (IN, EN)
Voltage at the control input (IN, EN)
Leakage current measured at the control input (IN, EN)
tON
Turn-on time for the switch. This parameter is measured under the specified range of conditions and by the propagation delay
between the digital control (IN) signal and analog output (COM, NC, or NO) signal when the switch is turning ON.
tOFF
Turn-off time for the switch. This parameter is measured under the specified range of conditions and by the propagation delay
between the digital control (IN) signal and analog output (COM, NC, or NO) signal when the switch is turning OFF.
QC
Charge injection is a measurement of unwanted signal coupling from the control (IN) input to the analog (NC, NO, or COM)
output. This is measured in coulomb (C) and measured by the total charge induced due to switching of the control input.
Charge injection, QC = CL
×
VCOM, CL is the load capacitance and
VCOM is the change in analog output voltage.
相關PDF資料 |
PDF描述 |
|---|---|
| TS5A2053YZPR | SINGLE-CHANNEL 10-OHM SPDT ANALOG SWITCH WITH ENABLE |
| TS5A3154YEAR | 0.9-W SPDT ANALOG SWITCH 5-V/3.3-V SINGLE-CHANNEL 2:1 MULTIPLEXER/DEMULTIPLEXER |
| TS5A3154YZAR | 0.9-W SPDT ANALOG SWITCH 5-V/3.3-V SINGLE-CHANNEL 2:1 MULTIPLEXER/DEMULTIPLEXER |
| TS5A3154YEPR | Fasteners, Screws; Leaded Process Compatible:No; Peak Reflow Compatible (260 C):No |
| TS5A3154DCTRE6 | 0.9-W SPDT ANALOG SWITCH 5-V/3.3-V SINGLE-CHANNEL 2:1 MULTIPLEXER/DEMULTIPLEXER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TS5A2053YZPR | 制造商:TI 制造商全稱:Texas Instruments 功能描述:SINGLE-CHANNEL 10-R SPDT ANALOG SWITCH WITH ENABLE |
| TS5A2066 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:DUAL-CHANNEL 10-Ω SPST ANALOG SWITCH |
| TS5A2066_10 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:DUAL-CHANNEL 10-?? SPST ANALOG SWITCH |
| TS5A2066DCTR | 功能描述:模擬開關 IC Dual-Ch 10-Ohm SPST Ana Sw RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16 |
| TS5A2066DCTR | 制造商:Texas Instruments 功能描述:IC DUAL 10R SPST ANLG SW SM8 |
發布緊急采購，3分鐘左右您將得到回復。