欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: TS8388BMFS9QB2ZB9
廠商: E2V TECHNOLOGIES PLC
元件分類: ADC
英文描述: 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, CQFP68
封裝: CERAMIC, QFP-68
文件頁數: 24/43頁
文件大小: 825K
代理商: TS8388BMFS9QB2ZB9
TS8388BFS
30
/42
Preliminary Beta Site
7.4.
CLOCK INPUTS (CLK) (CLKB)
The TS8388BFS can be clocked at full speed without noticeable performance degradation in either differential or single ended configuration.
This is explained by the fact the ADC uses a differential preamplifier stage for the clock buffer, which has been designed in order to be entered
either in differential or single–ended mode.
7.4.1.
SINGLE ENDED CLOCK INPUT (GROUND COMMON MODE)
Although the clock inputs were intended to be driven differentially with nominal -0.8V / -1.8V ECL levels, the TS8388BFS clock buffer can
manage a single–ended sinewave clock signal centered around 0 Volt. This is the most convenient clock input configuration as it does not
require the use of a power splitter.
No performance degradation ( e.g. : due to timing jitter) is observed in this particular single–ended configuration up to 1.2GSPS Nyquist
conditions ( Fin = 600 MHz ).
This is true so long as the inverted phase clock input pin is 50 ohms terminated very closely to one of the neighbouring shield ground pin, which
constitutes the local Ground reference for the inphase clock input.
Thus the TS8388BFS differential clock input buffer will fully reject the local ground noise ( and any capacitively and inductively coupled noise) as
common mode effects.
Moreover, a very low phase noise sinewave generator must be used for enhanced jitter performance.
The typical inphase clock input amplitude is 1 Volt peak to peak, centered on 0 Volt (ground) common mode.
This corresponds to a typical clock input power level of 4 dBm into the 50 ohms termination resistor.
Do not exceed 10 dBm to avoid saturation of the preamplifier input transistors.
The inverted phase clock input is grounded through the 50 ohms termination resistor.
Single ended Clock input (Ground common mode)
VCLK common mode = 0 Volt
VCLKB=0 Volt
4 dBm typical clock input power level
(into 50 ohms termination resistor)
[V]
t
VCLK
VCLKB = ( 0 V )
-0.5V
+0.5V
CLK or CLKB
50
(external)
50
reverse termination
1M
0.4 pF
CLK or CLKB double pad (pins 37, 38 or 39, 40)
Note 1 : Do not exceed 10 dBm into the 50 ohms termination resistor for single clock input power level.
7.4.2.
DIFFERENTIAL ECL CLOCK INPUT
The clock inputs can be driven differentially with nominal -0.8V / -1.8V ECL levels.
In this mode, a low phase noise sinewave generator can be used to drive the clock inputs, followed by a power splitter (hybrid junction) in order
to obtain 180 degrees out of phase sinewave signals. Biasing tees can be used for offseting the common mode voltage to ECL levels.
Note : As the biasing tees propagation times are not matching, a tunable delay line is required in order to ensure the signals to be 180 degrees
out of phase especially at fast clock rates in the GSPS range.
Differential Clock inputs (ECL Levels)
-0.8V
[mV]
t
-1.8V
VCLKB
VCLK
Common mode = -1.3 V
CLK or CLKB
50
reverse termination
1M
0.4 pF
-2V
50
(external)
CLK or CLKB double pad (pins 37, 38 or 39, 40)
相關PDF資料
PDF描述
TS8388BMFS9QB3ZB9 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, CQFP68
TS8388BMFS9QC3ZB9 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, CQFP68
TS8388BCFS9NB3ZB9 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, CQFP68
TS8388BCFS9NC1ZB9 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, CQFP68
TS8388BCFS9QC1ZB9 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, CQFP68
相關代理商/技術參數
參數描述
TS8388BMFSB/Q 制造商:e2v technologies 功能描述:ADC 8-BIT 1 GSPS - Trays
TS8388BVF 制造商:e2v technologies 功能描述:ADC 8-BIT 1 GSPS - Trays
TS8388BVFS 制造商:e2v technologies 功能描述:ADC 8-BIT 1 GSPS - Trays
TS8388BVGL 制造商:e2v technologies 功能描述:ADC 8-BIT 1 GSPS - Trays
TS8388BVGL (+LID) 制造商:e2v technologies 功能描述:ADC 8-BIT 1 GSPS - Trays
主站蜘蛛池模板: 南雄市| 平阳县| 武乡县| 鲁山县| 磴口县| 泰来县| 花莲市| 滦南县| 尼木县| 建始县| 望都县| 延边| 长沙县| 玛曲县| 毕节市| 开平市| 调兵山市| 任丘市| 巩义市| 白沙| 沂南县| 昌邑市| 延吉市| 南宫市| 苗栗市| 依安县| 八宿县| 桃江县| 石景山区| 安仁县| 南丰县| 浮梁县| 封开县| 开原市| 伊金霍洛旗| 桐城市| 政和县| 米脂县| 山阴县| 明星| 香河县|