欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: TSA1001CFT
廠商: STMICROELECTRONICS
元件分類: ADC
英文描述: 1-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP48
封裝: 7 X 7 MM, PLASTIC, TQFP-48
文件頁數: 5/20頁
文件大小: 218K
代理商: TSA1001CFT
TSA1001
13/20
NO
T
FOR
NEW
DESI
G
N
The timing diagram summarizes this operating cy-
cle.
Out of Range (OR)
This function is implemented on the output stage
in order to set up an "Out of Range" flag whenever
the digital data are over the full scale range.
Typically, there is a detection of all the data being
at í0í or all the data being at í1í. This ends up with
an output signal OR which is in low level state
(VOL) when the data stay within the range, or in
high level state (VOH) when the data is out of the
range.
Data Ready (DR)
The Data Ready output is an image of the clock
being synchronized on the output data (D0 to D9).
This is a very helpful signal that simplifies the syn-
chronization of the measurement equipment or
the controlling DSP.
As digital output, DR goes in high impedance state
when OEB is asserted to High level as described
in the timing diagram.
REFERENCES AND COMMON MODE
CONNECTION
VREFM must be always connected externally.
Internal reference and common mode
In the default configuration, the ADC operates with
its own reference and common mode voltages
generated by its internal bandgap. VREFM pin is
connected externally to the Analog Ground while
VREFP (respectively INCM) is set to its internal
voltage of 1.03V (respectively 0.57V). It is
recommended to decouple the VREFP in order to
minimize low and high frequency noise (refer to
Figure 1)
Figure 1 : Internal reference and common mode
setting
External reference and common mode
Each of the voltages VREFM, VREFP and INCM
can be fixed externally to better fit to the
application needs (Refer to Table íOPERATING
CONDITIONSí page 2 for min/max values).
The VREFP, VREFM voltages set the analog
dynamic at the input of the converter that has a full
scale amplitude of 2*(VREFP-VREFM).
In case of analog dynamic lower than 2Vpp, the
best linearity
and
distortion
performance
is
achieved while increasing the VREFM voltage
instead of lowering the VREFP one.
The INCM is the mid voltage of the analog input
signal.
It is possible to use an external reference voltage
device for specific applications requiring even
better
linearity,
accuracy
or
enhanced
temperature
behavior.
Using
the
STMicroelectronics TS821 or TS4041-1.2 Vref
leads to optimum performances when configured
as shown on Figure 2.
Figure 2 : External reference setting
At 15Msps sampling frequency, 1MHz input
frequency
and
-1dBFS
amplitude
signal,
performances can be improved up to 2dBc on
SFDR and 0.3dB on SINAD. At 25Msps sampling
frequency, 1MHz input frequency and -1dBFS
amplitude signal, performances can be improved
up to 1dBc on SFDR and 0.5dB on SINAD.
This
can
be
very
helpful
for
example
for
multichannel application to keep a good matching
among the sampling frequency range.
TSA1001
VIN
VINB
VREFM
1.03V
VREFP
330pF
4.7uF
10nF
INCM
330pF
4.7uF
10nF
0.57V
1k
TSA1001
VIN
VINB
VREFM
VREFP
external
reference
VCCA
330pF
4.7uF
10nF
TS821
TS4041
相關PDF資料
PDF描述
TSA1001IFT 1-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP48
TSA1001CF 1-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP48
TSA1002CFT 1-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP48
TSA1002CF 1-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP48
TSA1002IF 1-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP48
相關代理商/技術參數
參數描述
TSA1001IF 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:10-BIT, 25MSPS, 35mW A/D CONVERTER
TSA1001IFT 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:10-BIT, 25MSPS, 35mW A/D CONVERTER
TSA1002 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:10-BIT, 50MSPS, 50mW A/D CONVERTER
TSA1002_04 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:10-BIT, 50MSPS, 50mW A/D CONVERTER
TSA1002CF 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:10-BIT, 50MSPS, 50mW A/D CONVERTER
主站蜘蛛池模板: 瑞金市| 德格县| 清流县| 和顺县| 尉氏县| 寿宁县| 延津县| 高要市| 固镇县| 方山县| 德令哈市| 萨嘎县| 正安县| 浙江省| 重庆市| 德化县| 远安县| 肥乡县| 高青县| 太保市| 通榆县| 噶尔县| 锦屏县| 镇安县| 岳普湖县| 丰城市| 安远县| 肃宁县| 阜南县| 普兰店市| 阜阳市| 乡宁县| 乌鲁木齐县| 尖扎县| 维西| 郓城县| 库伦旗| 松阳县| 湖州市| 泾阳县| 左贡县|