欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: TSC2111IRGZR
廠商: TEXAS INSTRUMENTS INC
元件分類: 音頻/視頻放大
英文描述: 0.4 W, 1 CHANNEL, AUDIO AMPLIFIER, QCC48
封裝: PLASTIC, QFN-48
文件頁數: 11/99頁
文件大小: 1143K
代理商: TSC2111IRGZR
TSC2111
SLAS495A JUNE 2006 REVISED OCTOBER 2007
www.ti.com
19
OVERVIEW
The TSC2111 is a highly integrated stereo audio DAC and mono audio ADC with touch screen controller for
portable computing, communication and entertainment applications. A register-based architecture eases
integration with microprocessor-based systems through a standard SPI bus. All peripheral functions are
controlled through the registers and on-board state machines.
The TSC2111 consists of the following blocks:
D Audio Codec
D Headset and Button Detection
D Touch Screen Interface
D Battery Monitors
D Auxiliary Inputs
D Temperature Monitor
Communication to the TSC2111 is via a standard SPI serial interface. This interface requires that the Slave
Select signal (SS) be driven low to communicate with the TSC2111. Data is then shifted into or out of the
TSC2111 under control of the host microprocessor, which also provides the serial data clock.
Control of the TSC2111 and its functions is accomplished by writing to different registers in the TSC2111. A
simple command protocol is used to address the 16-bit registers. Registers control the operation of the SAR
ADC and audio codec.
OPERATION—AUDIO CODEC
AUDIO ANALOG I/O
The TSC2111 has stereo audio DAC and mono audio ADC. It supports a wide range of analog interface to
support different headsets and analog outputs. The TSC2111 has features to interface output drivers (8-
,
16-
, 32-) and Microphone PGA to Cell-phone. The TSC2111 also has a virtual ground (VGND) output, which
can be optionally used to connect to the ground terminal of a speaker of headphone to eliminate the ac-coupling
capacitor needed at the speaker or headphone output. A special circuit has also been included in the TSC2111
to insert a short keyclick sound into the stereo audio output, even when the audio DAC is powered down. They
keyclick sound is used to provide feedback to the used when a particular button is pressed or item is selected.
The specific sound of the keyclick can be adjusted by varying several register bits that control its frequency,
duration, and amplitude.
AUDIO DIGITAL I/O INTERFACE
Digital audio data samples can be transmitted between the TSC2111 and the CPU via the serial bus (BCLK,
WCLK, SDOUT, SDIN) that can be configured to transfer digital data in four different formats: Right justified
(RJF), Left justified (LJF), I2S and DSP. The four modes are MSB first and operate with variable word length
between 16/20/24/32 bits. The TSC2111’s audio codec can operate in master or slave mode, depending on the
setting of D11 at the register 06h of page 2. The word-select signal (WCLK) and bit clock signal (BCLK) are
configured as inputs when the bus is in slave mode (D11 = 0). They are configured as outputs when the bus
is in master mode (D11 = 1). Under master mode, both clocks start running when the I2S bus needs to be active
(one of the analog input/output paths has been configured and powered up). The WCLK is representative of
the sampling rate of the audio ADC/DAC and is synchronized with SDOUT. Although the SDOUT signal can
contain two channels of information (a left and right channel), the TSC2111 sends the same ADC data in both
channels.
D ADC/DAC Sampling Rate
The audio-control-1 register (Register 00H, Page 2) determines the sampling rates of DAC and ADC. The
sampling frequency is scaled down from the reference rate (Fsref). The reference rate is usually either 44.1
kHz or 48 kHz which can be selectable using bit D13 of the register Audio Control 3 (06H/Page2). The ADC
and DAC can operate with either common WCLK (equal sampling rates) or separate GPIO1 (For ADC) and
WCLK (For DAC) for unequal sampling rates. When the audio codec is powered up, it is by default configured
as an I2S slave with both the DAC and ADC operating at Fsref.
相關PDF資料
PDF描述
TSC2111IRGZT 0.4 W, 1 CHANNEL, AUDIO AMPLIFIER, QCC48
TSC2111IRGZRG4 0.4 W, 1 CHANNEL, AUDIO AMPLIFIER, QCC48
TSC2111IRGZTG4 0.4 W, 1 CHANNEL, AUDIO AMPLIFIER, QCC48
TSC2117IRGZR SPECIALTY CONSUMER CIRCUIT, QCC48
TSC2117IRGZT SPECIALTY CONSUMER CIRCUIT, QCC48
相關代理商/技術參數
參數描述
TSC2111IRGZRG4 功能描述:觸摸屏轉換器和控制器 SMART 4-Wire with Audio RoHS:否 制造商:Microchip Technology 類型:Resistive Touch Controllers 輸入類型:3 Key 數據速率:140 SPS 分辨率:10 bit 接口類型:4-Wire, 5-Wire, 8-Wire, I2C, SPI 電源電壓:2.5 V to 5.25 V 電源電流:17 mA 工作溫度:- 40 C to + 85 C 封裝 / 箱體:SSOP-20
TSC2111IRGZT 功能描述:觸摸屏轉換器和控制器 SMART 4-Wire with Audio RoHS:否 制造商:Microchip Technology 類型:Resistive Touch Controllers 輸入類型:3 Key 數據速率:140 SPS 分辨率:10 bit 接口類型:4-Wire, 5-Wire, 8-Wire, I2C, SPI 電源電壓:2.5 V to 5.25 V 電源電流:17 mA 工作溫度:- 40 C to + 85 C 封裝 / 箱體:SSOP-20
TSC2111IRGZTG4 功能描述:觸摸屏轉換器和控制器 SMART 4-Wire with Audio RoHS:否 制造商:Microchip Technology 類型:Resistive Touch Controllers 輸入類型:3 Key 數據速率:140 SPS 分辨率:10 bit 接口類型:4-Wire, 5-Wire, 8-Wire, I2C, SPI 電源電壓:2.5 V to 5.25 V 電源電流:17 mA 工作溫度:- 40 C to + 85 C 封裝 / 箱體:SSOP-20
TSC-2-1-15 制造商:Micrel Inc 功能描述:
TSC2117 制造商:TI 制造商全稱:Texas Instruments 功能描述:Low-Power Audio Codec With Embedded miniDSP, Stereo Class-D Speaker Amplifier, and Smart Four-Wire Touch-Screen Controller
主站蜘蛛池模板: 石渠县| 黑龙江省| 大安市| 六安市| 章丘市| 河北省| 鄂尔多斯市| 久治县| 武穴市| 沛县| 曲沃县| 馆陶县| 屏东市| 大理市| 丹巴县| 双牌县| 甘南县| 台湾省| 化州市| 五原县| 洪雅县| 通化市| 长阳| 衡东县| 昌平区| 荆州市| 新源县| 瓦房店市| 东乌珠穆沁旗| 康马县| 北票市| 祁门县| 犍为县| 云林县| 宁海县| 甘肃省| 吉林省| 定西市| 嵩明县| 阜城县| 达尔|