- 您現在的位置：買賣IC網 > PDF目錄98302 > TSC2111IRGZRG4 (TEXAS INSTRUMENTS INC) 0.4 W, 1 CHANNEL, AUDIO AMPLIFIER, QCC48 PDF資料下載
參數資料
| 型號： | TSC2111IRGZRG4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 0.4 W, 1 CHANNEL, AUDIO AMPLIFIER, QCC48 |
| 封裝： | PLASTIC, QFN-48 |
| 文件頁數： | 17/99頁 |
| 文件大小： | 1143K |
| 代理商： | TSC2111IRGZRG4 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁
TSC2111
SLAS495A JUNE 2006 REVISED OCTOBER 2007
www.ti.com
24
Table 2. Fsref = 48 kHz
MCLK (MHz)
P
J
D
ACHIEVED FSREF
% ERROR
2.048
1
48
0
48000.00
0.0000
3.072
1
32
0
48000.00
0.0000
4.096
1
24
0
48000.00
0.0000
6.144
1
16
0
48000.00
0.0000
8.192
1
12
0
48000.00
0.0000
12.0
1
8
1920
48000.00
0.0000
13.0
1
7
5618
47999.71
0.0006
16.0
1
6
1440
48000.00
0.0000
19.2
1
5
1200
48000.00
0.0000
19.68
1
4
9951
47999.79
0.0004
48.0
4
8
1920
48000.00
0.0000
To externally observe the PLL function, the GPIO2 pin can be set up as the clock monitor (set D2 = 1, register
22h, page 2). Note that besides setting up the PLL and GPIO2, the audio ADC or DAC must be enabled for
the PLL output to appear at the GPIO2.
Example 1:
D Start from power up (with the proper sequence)
D Make sure MCLK is provided and /PWR_DWN and /RESET are both high
D Set and enable PLL
D Connect and power up (do not unmute anything) ADC or DAC or both, for instance:
Page2/Reg03h to C530h or C510h (default is C500h) to connect MICSEL to ADC
Page2/Reg05h to FDFCh (default is FFFCh) to power up ADC.
D Set Page2/Reg22h to 0004h to output PLL to GPIO2 pin.
MONO AUDIO ADC
Analog Front End
The analog front end of the audio ADC consists of an analog MUX and a programmable gain amplifier (PGA).
The MUX can connect either of the Headset Input (MICIN_HED), Handset Input (MICIN_HND), AUX1 and
AUX2 signal through the PGA to the ADC for audio recording. The Cell-phone Input (CP_IN) can also be
connected to ADC through a PGA at the same time. This enables recording of conversation during a cell-phone
call. The TSC2111 also has an option of choosing MICIN_HED/MICIN_HND and AUX1/AUX2 as differential
input pair. The TSC2111 also includes two microphone bias circuits which can source up to 5 mA of current,
and are programmable to a 2 V, 2.5 V or 3.3 V level for Headset and 2 V or 3.3 V level for handset.
Because of the oversampling nature of the audio ADC and the integrated digital decimation filtering,
requirements for analog anti-aliasing filtering are very relaxed. The TSC2111 integrates a second order analog
anti-aliasing filter with 20-dB attenuation at 1 MHz. This filter, combined with the digital decimal filter, provides
sufficient anti-aliasing filtering without requiring any external components.
The PGA, for microphone and AUX Inputs, allows analog gain control from 0 dB to 59.5 dB in steps of 0.5 dB.
The PGA gain changes are implemented with an internal soft-stepping. This soft-stepping ensures that volume
control changes occur smoothly with no audible artifacts. Upon reset, the PGA gain defaults to a mute condition,
and upon power down, the PGA soft-steps the volume to mute before shutting down. A read-only flag (D0
control register 04H/Page 2) is set whenever the gain applied by PGA equals the desired value set by the
register. The soft-stepping control can be disabled by programming D15=1 in register 1DH of Page 2. When
soft stepping is enabled and ADC power down register is written, MCLK should be running to ensure that
soft-stepping to mute has completed. MCLK can be shut down once Mic PGA power down flag is set.
The PGA, for Cell phone Input (CP_IN) allows gain control from –34.5 dB to 12 dB in steps of 0.5 dB. The PGA
gain changes are implemented with an internal softstepping. This soft-stepping ensures that volume control
changes occur smoothly with no audible artifacts. Upon reset, the PGA gain defaults to a mute condition, and
相關PDF資料 |
PDF描述 |
|---|---|
| TSC2111IRGZTG4 | 0.4 W, 1 CHANNEL, AUDIO AMPLIFIER, QCC48 |
| TSC2117IRGZR | SPECIALTY CONSUMER CIRCUIT, QCC48 |
| TSC2117IRGZT | SPECIALTY CONSUMER CIRCUIT, QCC48 |
| TSC2300IPAGG4 | SPECIALTY CONSUMER CIRCUIT, PQFP64 |
| TSC2300IPAGR | SPECIALTY CONSUMER CIRCUIT, PQFP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSC2111IRGZT | 功能描述:觸摸屏轉換器和控制器 SMART 4-Wire with Audio RoHS:否 制造商:Microchip Technology 類型:Resistive Touch Controllers 輸入類型:3 Key 數據速率:140 SPS 分辨率:10 bit 接口類型:4-Wire, 5-Wire, 8-Wire, I2C, SPI 電源電壓:2.5 V to 5.25 V 電源電流:17 mA 工作溫度:- 40 C to + 85 C 封裝 / 箱體:SSOP-20 |
| TSC2111IRGZTG4 | 功能描述:觸摸屏轉換器和控制器 SMART 4-Wire with Audio RoHS:否 制造商:Microchip Technology 類型:Resistive Touch Controllers 輸入類型:3 Key 數據速率:140 SPS 分辨率:10 bit 接口類型:4-Wire, 5-Wire, 8-Wire, I2C, SPI 電源電壓:2.5 V to 5.25 V 電源電流:17 mA 工作溫度:- 40 C to + 85 C 封裝 / 箱體:SSOP-20 |
| TSC-2-1-15 | 制造商:Micrel Inc 功能描述: |
| TSC2117 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Low-Power Audio Codec With Embedded miniDSP, Stereo Class-D Speaker Amplifier, and Smart Four-Wire Touch-Screen Controller |
| TSC2117EVM-K | 功能描述:音頻 IC 開發工具 TSC2117 Eval Mod RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
發布緊急采購，3分鐘左右您將得到回復。