- 您現在的位置：買賣IC網 > Datasheet目錄57 > TSL208R (AMS-TAOS USA Inc)IC LINEAR SENSOR ARRAY 512X1 Datasheet資料下載
參數資料
| 型號： | TSL208R |
| 廠商： | AMS-TAOS USA Inc |
| 文件頁數： | 9/11頁 |
| 文件大小： | 580K |
| 描述： | IC LINEAR SENSOR ARRAY 512X1 |
| 標準包裝： | 40 |
| 系列： | * |
| 其它名稱： | TSL208-R |
TSL208R
512 y 1 LINEAR SENSOR ARRAY
TAOS031G AUGUST 2011
8
r
r
Copyright E 2011, TAOS Inc.
The LUMENOLOGY r Company
www.taosinc.com
APPLICATION INFORMATION
It is good practice on initial power up to run the clock (n+1) times after the first SI pulse to clock out indeterminate
data from power up. After that, the SI pulse is valid from the time following (n+1) clocks. The output will go into
a high-impedance state after the n+1 high clock edge. It is good practice to leave the clock in a low state when
inactive because the SI pulse required to start a new cycle is a low-to-high transition.
The integration time chosen is valid as long as it falls in the range between the minimum and maximum limits
for integration time. If the amount of light incident on the array during a given integration period produces a
saturated output (Max Voltage output), then the data is not accurate. If this occurs, the integration period should
be reduced until the analog output voltage for each pixel falls below the saturation level. The goal of reducing
the period of time the light sampling window is active is to lower the output voltage level to prevent saturation.
However, the integration time must still be greater than or equal to the minimum integration period.
If the light intensity produces an output below desired signal levels, the output voltage level can be increased
by increasing the integration period provided that the maximum integration time is not exceeded. The maximum
integration time is limited by the length of time the integrating capacitors on the pixels can hold their accumulated
charge. The maximum integration time should not exceed 100 ms for accurate measurements.
Although the linear array is capable of running over a wide range of operating frequencies up to a maximum
of 5 MHz, the speed of the A/D converter used in the application is likely to be the limiter for the maximum clock
frequency. The voltage output is available for the whole period of the clock, so the setup and hold times required
for the analog-to-digital conversion must be less than the clock period.
相關PDF資料 |
PDF描述 |
|---|---|
| TSL210 | IC LINEAR SENSOR ARRAY 640X1 |
| TSL230BRD-TR | IC LIGHT TO FREQUENCY CONV 8SOIC |
| TSL235RSM-LF | IC LIGHT TO FREQUENCY CONV 3SMD |
| TSL237SM-LF | IC LIGHT TO FREQUENCY CONV 3SMD |
| TSL237T | IC LIGHT TO FREQUENCY CONV 4-TMB |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSL210 | 功能描述:光頻率和光電壓 Linear Array 200 DPI RoHS:否 制造商:ams 峰值波長:1000 nm 工作電源電壓:5 V 最大工作溫度:+ 85 C 最小工作溫度:- 25 C 安裝風格: 封裝 / 箱體: |
| TSL213 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| TSL213A | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| TSL214 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| TSL215 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:128 】 1 INTEGRATED OPTO SENSOR |
發布緊急采購，3分鐘左右您將得到回復。