- 您現在的位置：買賣IC網 > PDF目錄365985 > TSOP2856QJ TRANSISTOR-STAGE OUTPUT PHOTO IC PDF資料下載
參數資料
| 型號： | TSOP2856QJ |
| 英文描述： | TRANSISTOR-STAGE OUTPUT PHOTO IC |
| 中文描述： | 晶體管階段的輸出相片集成電路 |
| 文件頁數： | 3/7頁 |
| 文件大小： | 145K |
| 代理商： | TSOP2856QJ |
TSOP22..KU1
Vishay Semiconductors
3 (7)
www.vishay.com
Document Number 82172
Rev. 1, 19–Nov–01
Suitable Data Format
The circuit of the TSOP22..KU1 is designed in that
way that unexpected output pulses due to noise or
disturbance signals are avoided. A bandpassfilter, an
integrator stage and an automatic gain control are
used to suppress such disturbances.
The distinguishing mark between data signal and
disturbance signal are carrier frequency, burst length
and duty cycle.
The data signal should fullfill the following condition:
Carrier frequency should be close to center
frequency of the bandpass (e.g. 38 kHz).
Burst length should be 10 cycles/burst or longer.
After each burst which is between 10 cycles and
70 cycles a gap time of at least 14 cycles is
neccessary.
For each burst which is longer than 1.8 ms a
corresponding gap time is necessary at some
time in the data stream. This gap time should be at
least 4 times longer than the burst.
Up to 800 short bursts per second can be
received continuously.
Some examples for suitable data format are:
NEC Code, Toshiba Micom Format, Sharp Code,
RC5 Code, RC6 Code, R–2000 Code.
When a disturbance signal is applied to the
TSOP22..KU1 it can still receive the data signal.
However the sensitivity is reduced to that level that no
unexpected pulses will occure.
Some examples for such disturbance signals which
are suppressed by the TSOP22..KU1 are:
DC light (e.g. from tungsten bulb or sunlight)
Continuous signal at 38 kHz or at any other
frequency
Signals from fluorescent lamps with electronic
ballast with low modulation
(see Figure A or Figure B).
0
5
10
15
20
time [ms]
Figure A: IR Signal from Fluorescent Lamp with low Modulation
0
5
10
15
20
time [s]
Figure B: IR Signal from Fluorescent Lamp with high Modulation
相關PDF資料 |
PDF描述 |
|---|---|
| TSOP2233KU1 | TRANSISTOR-STAGE OUTPUT PHOTO IC |
| TSOP2233LL1 | TRANSISTOR-STAGE OUTPUT PHOTO IC |
| TSOP2236KU1 | TRANSISTOR-STAGE OUTPUT PHOTO IC |
| TSOP2236LL1 | TRANSISTOR-STAGE OUTPUT PHOTO IC |
| TSOP2237KU1 | TRANSISTOR-STAGE OUTPUT PHOTO IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSOP31130 | 制造商:Vishay Semiconductors 功能描述:3V IR RECEIVER 30KHZ SIDE VIEW - Tape and Reel 制造商:Vishay Semiconductors 功能描述:IC IR RCVR MOD SIDE VIEW |
| TSOP31136 | 制造商:Vishay Semiconductors 功能描述:3V IR RECEIVER 36KHZ SIDE VIEW - Rail/Tube 制造商:Vishay Semiconductors 功能描述:IC IR RCVR MOD SIDE VIEW |
| TSOP31138 | 制造商:Vishay Semiconductors 功能描述:IR REMOTE RCVR 38KHZ 35M - Rail/Tube 制造商:Vishay Intertechnologies 功能描述:IR RECEIVER LEADED AGC1 38KH 制造商:Vishay Intertechnologies 功能描述:IR RECEIVER, LEADED AGC1, 38KHZ 制造商:Vishay Intertechnologies 功能描述:IR RECEIVER, LEADED AGC1, 38KHZ; Carrier Frequency:38kHz; Transmission Range:45m; Directivity:45; Supply Voltage Min:2.5V; Supply Voltage Max:5.5V; Supply Current:350A; Opto Case Style:Through Hole; Operating Temperature Min:-25C;;RoHS Compliant: Yes |
| TSOP31156 | 制造商:Vishay Semiconductors 功能描述:3V IR RECEIVER 56KHZ SIDE VIEW - Rail/Tube 制造商:Vishay Semiconductors 功能描述:IC IR RCVR MOD SIDE VIEW |
| TSOP31230 | 功能描述:紅外接收機 2.5-5.5V 30kHz 45Deg RoHS:否 制造商:Vishay Semiconductors 載頻:20 kHz to 60 kHz 傳輸距離:5 m 顯示角:+/- 50 deg 高電平脈沖寬度: 低電平脈沖寬度: 最小高電平輸出電壓: 輸出電流:5 mA 工作電壓:2.5 V to 5.5 V 電源電流:0.9 mA 功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 25 C 封裝 / 箱體: 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。