- 您現在的位置：買賣IC網 > PDF目錄98304 > TUA6024-S (INFINEON TECHNOLOGIES AG) 2-BAND, VIDEO TUNER, PDSO28 PDF資料下載
參數資料
| 型號： | TUA6024-S |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 元件分類： | 調諧器 |
| 英文描述： | 2-BAND, VIDEO TUNER, PDSO28 |
| 封裝： | 1 MM HEIGHT, PLASTIC, TSSOP-28 |
| 文件頁數： | 8/34頁 |
| 文件大小： | 631K |
| 代理商： | TUA6024-S |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
Functional Description
3 - 9
TUA6024
Wireless Components
Specification, December 1999
By means of control bit CP the pump current can be switched between two val-
ues by software. This programmability permits alteration of the control response
of the PLL in the locked-in state. In this way different VCO gains can be com-
pensated, for example.
The software-switched ports PLOW, PMID and PHIGH are general-purpose
open-collector outputs. The test bit T1 = 1, switches the test signals fref
(i.e.fXTAL / 64) and fdiv (divided input signal) to PLOW and PMID respectively.
The lock detector resets the lock flag FL if the width of the charge pump current
pulses is wider than the period of the crystal oscillator (i.e. 250 ns). Hence, if FL
= 1, the maximum deviation of the input frequency from the programmed fre-
quency is given by
f = ± I
P (KVCO / fXTAL) (C1+C2) / (C1C2)
where IP is the charge pump current, KVCO the VCO gain, fXTAL the crystal oscil-
lator frequency and C1, C2 the capacitances in the loop filter (see Figure 4-1 Evalu-
maximum of 16
s for FL to be reset after the loop has lost lock state.
Once FL has been reset, it is set only if the charge pump pulse width is less than
250 ns for eight consecutive fref periods. Therefore it takes between 128 and
144
s for FL to be set after the loop regains lock.
3.4.3
I2C-Bus Interface
Data is exchanged between the processor and the PLL via the I2C bus. The
clock is generated by the processor (input SCL), while pin SDA functions as an
input or output depending on the direction of the data (open collector, external
pull-up resistor). Both inputs have hysteresis and a low-pass characteristic,
which enhance the noise immunity of the I2C bus.
The data from the processor pass through an I2C bus controller. Depending on
their function the data are subsequently stored in registers. If the bus is free,
both lines will be in the marking state (SDA, SCL are HIGH). Each telegram
begins with the start condition and ends with the stop condition. Start condition:
SDA goes LOW, while SCL remains HIGH. Stop condition: SDA goes HIGH
while SCL remains HIGH. All further information transfer takes place during
SCL = LOW, and the data is forwarded to the control logic on the positive clock
edge.
The table ”Bit Allocation” (see Table 5-4 Bit Allocation Read / Write on page 10) should be
referred to the following description. All telegrams are transmitted byte-by-byte,
followed by a ninth clock pulse, during which the control logic returns the SDA
line to LOW (acknowledge condition). The first byte is comprised of seven
address bits. These are used by the processor to select the PLL from several
peripheral components (chip select). The LSB bit (R/W) determines whether
data are written into (R/W = 0) or read from (R/W = 1) the PLL.
相關PDF資料 |
PDF描述 |
|---|---|
| TUA6026K | 2-BAND, VIDEO TUNER, PDSO28 |
| TUA6026S | 2-BAND, VIDEO TUNER, PDSO28 |
| TUA6026-K | 2-BAND, VIDEO TUNER, PDSO28 |
| TUA6026-S | 2-BAND, VIDEO TUNER, PDSO28 |
| TUA6028XS | 2-BAND, VIDEO TUNER, PDSO28 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TUA6030 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:3-Band TV Tuner IC |
| TUA6032 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:3-Band TV Tuner IC |
| TUA6034 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:3-Band Digital TV / Set-Top-Box Tuner IC TAIFUN |
| TUA6034_06 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:3-Band Digital TV / Set-Top-Box Tuner IC TAIFUN |
| TUA6034DEMOBOARD | 制造商:Infineon Technologies AG 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。