- 您現在的位置：買賣IC網 > PDF目錄98307 > TWL1103PBSR (TEXAS INSTRUMENTS INC) SPECIALTY CONSUMER CIRCUIT, PQFP32 PDF資料下載
參數資料
| 型號： | TWL1103PBSR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 消費家電 |
| 英文描述： | SPECIALTY CONSUMER CIRCUIT, PQFP32 |
| 封裝： | PLASTIC, QFP-32 |
| 文件頁數： | 27/32頁 |
| 文件大小： | 476K |
| 代理商： | TWL1103PBSR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁第30頁第31頁第32頁
TWL1103
VOICE-BAND AUDIO PROCESSOR (VBAP
)
SLWS108A – JULY 2000 – JANUARY 2001
4
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
functional description (continued)
analog modulator
The transmit channel modulator is a third-order sigma-delta design.
transmit filter and PGA
The transmit filter is a digital filter designed to meet CCITT G.714 requirements. The device operates in either
the 15-bit linear or 8-bit companded
-law or A-law mode that is selectable through the I2C interface. The
transmit PGA defaults to 0 dB.
sidetone
A portion of the transmitted audio is attenuated and fed back to the receive channel through the sidetone path.
The sidetone path defaults to –12 dB. The sidetone path can be enabled by writing to the power control register.
receive volume control
The receive volume control block acts as an attenuator with a range of –18 dB to 0 dB in 2 dB steps for control
of the receive channel volume. The receive volume control gain defaults to 0 dB.
receive filter and PGA
The receive filter is a digital filter that meets CCITT G.714 requirements with a high-pass filter that is selectable
through the I2C interface. The device operates in either the 15-bit linear or 8-bit
-law or A-law companded
mode, which is selectable through the I2C interface. The gain defaults to –1 dB representing a 3-dBm0 level
for a 32-
load impedance and the corresponding digital full scale PCMI code. The gain may be set to –2 dB
for the respective 3-dBm0 level for a 16-
load impedance.
digital modulator and filter
The second-order digital modulator and filter convert the received digital PCM data to the analog output required
by the earphone interface.
earphone amplifiers
The analog signal can be routed to either of two earphone amplifiers, one with differential output (EAR1ON and
EAR1OP) and one with single-ended output (EAR2O). Clicks and pops are suppressed for EAR1 differential
output only.
tone generator
The tone generator provides generation of standard DTMF tones and single tone frequencies which are output
to the following devices: 1) The buzzer driver, as a pulse density modulation (PDM) signal 2) The receive path
digital/analog converter (DAC) for outputting through the earphone. There are 255 possible single tones. The
tone integer value is determined by the following formula:
Round (Tone Freq (Hz)/7.8135 Hz)
The value is loaded into one of two 8-bit registers, the high-tone register (04), or the low-tone register (05). The
tone output is 2 dB higher when applied to the high-tone register (04). When generating DTMF tones, the high
DTMF tone must be applied to the high-tone register and the low frequency tone to the low-tone register.
相關PDF資料 |
PDF描述 |
|---|---|
| TWL1103GQER | SPECIALTY CONSUMER CIRCUIT, PBGA80 |
| TWL1103TPBSQ1 | SPECIALTY CONSUMER CIRCUIT, PQFP32 |
| TWL1103TPBSRQ1 | SPECIALTY CONSUMER CIRCUIT, PQFP32 |
| TWL1106PWR | SPECIALTY CONSUMER CIRCUIT, PDSO20 |
| TWL1106PW | SPECIALTY CONSUMER CIRCUIT, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TWL1103TPBSQ1 | 功能描述:音頻 DSP Auto Cat Voice-Band Audio Processor RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| TWL1103TPBSRQ1 | 功能描述:音頻 DSP Auto Cat Voice-Band Audio Processor RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| TWL1103T-Q1 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Automotive Catalog Voice-Band Audio Processor (VBAP) |
| TWL1106 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:VOICE-BAND AUDIO PROCESSOR (VBAPa?￠) |
| TWL1106PWR | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。