- 您現在的位置：買賣IC網 > PDF目錄382716 > UBA2051T (NXP SEMICONDUCTORS) One-chip telephone ICs with speech, dialler and ringer functions PDF資料下載
參數資料
| 型號： | UBA2051T |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 無繩電話/電話 |
| 英文描述： | One-chip telephone ICs with speech, dialler and ringer functions |
| 中文描述： | TELEPHONE MULTIFUNCTION CKT, PDSO28 |
| 封裝： | PLASTIC, SOT-136, SO-28 |
| 文件頁數： | 12/52頁 |
| 文件大小： | 292K |
| 代理商： | UBA2051T |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁
2000 May 19
12
Philips Semiconductors
Product specification
One-chip telephone ICs with speech,
dialler and ringer functions
UBA2050(A); UBA2051(A;C)
T
RANSMIT STAGES
Microphone signal amplification (pins MIC+ and MIC
)
The UBA205xx has symmetrical microphone inputs. The
input impedance between pins MIC+ and MIC
is 64 k
(2
×
32 k
).
In speech mode, the voltage gain from pins MIC+ and
MIC
to pin LN is set at 44.2 dB at 600
line load.
Microphone arrangements are illustrated in Fig.12.
Automatic gain control is provided on this amplifier for line
loss compensation.
handbook, full pagewidth
MGT052
GND
VCC
(1)
MIC
MIC
+
MIC
MIC
+
MIC
MIC
+
(2)
Fig.12 Microphone arrangements.
a. Magnetic or dynamic microphone.
b. Electret microphone.
c. Piezoelectric microphone.
(1) This resistor may be connected to reduce the terminating impedance.
(2) Extra decoupling capacitor for the microphone supply.
DTMF amplification (pin DTMF)
When the DTMF amplifier is enabled, dialling tones may
be sent on the line. These tones are generated at
pin MDY/TONE and their amplitude can be adjusted by
means of an attenuator and filter network (see Fig.35)
before being applied to the DTMF amplifier at pin DTMF.
Thesetonesarealsosenttothereceiveoutput RXatalow
level (confidence tone).
The UBA205xx has an asymmetrical DTMF input. The
input impedance between pins DTMF and GND is 20 k
.
The voltage gain from pin DTMF to pin LN is set at 26 dB
at 600
line load. The DC voltage between pins DTMF
and GND is 0 V. So, when an external attenuator/filter
network is used, there is no need for a second decoupling
capacitor.
The automatic gain control has no effect on the DTMF
amplifier.
R
ECEIVE STAGES
The receive part consists of a receive amplifier and an
earpiece amplifier.
Receive amplifier (pins IR and RX)
The receive amplifier transfers the received signal from
input IR to output RX. The input impedance between
pins IR and GND is 20 k
.
The voltage gain from pin IR to pin RX is fixed at 33.4 dB.
The RX output is intended to drive high ohmic (real) loads.
Automatic gain control is provided on the receive amplifier.
相關PDF資料 |
PDF描述 |
|---|---|
| UBA2070 | 8-bit MCU for automotive with 16 to 60 Kbyte Flash, ADC, CSS, 5 timers, SPI, SCI, I2C interface |
| UBB1000 | 8-bit MCU for automotive with 16 to 60 Kbyte Flash, ADC, CSS, 5 timers, SPI, SCI, I2C interface |
| UBC41 | DUODIODE TRIODE |
| UBT430 | 8-bit MCU with Flash or ROM, 10-bit ADC, 5 timers, SPI, 2x LINSCI" |
| UC.AB.1001 | 8-bit MCU with Flash or ROM, 10-bit ADC, 5 timers, SPI, 2x LINSCI" |
相關代理商/技術參數 |
參數描述 |
|---|---|
| UBA2070 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:600 V CCFL ballast driver IC |
| UBA2070P | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:600 V CCFL ballast driver IC |
| UBA2070P/N1,112 | 功能描述:顯示驅動器和控制器 CCFL RoHS:否 制造商:Panasonic Electronic Components 工作電源電壓:2.7 V to 5.5 V 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:QFN-44 封裝:Reel |
| UBA2070T | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:600 V CCFL ballast driver IC |
| UBA2070T/N1,518 | 功能描述:顯示驅動器和控制器 IC CCFL DRIVER RoHS:否 制造商:Panasonic Electronic Components 工作電源電壓:2.7 V to 5.5 V 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:QFN-44 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。