- 您現在的位置：買賣IC網 > PDF目錄382718 > UC1633QTR 8-bit MCU for automotive with Flash or ROM, 10-bit ADC, 5 timers, SPI, LINSCI", active CAN PDF資料下載
參數資料
| 型號： | UC1633QTR |
| 英文描述： | 8-bit MCU for automotive with Flash or ROM, 10-bit ADC, 5 timers, SPI, LINSCI", active CAN |
| 中文描述： | 鎖相環 |
| 文件頁數： | 5/8頁 |
| 文件大小： | 588K |
| 代理商： | UC1633QTR |
Phase Detector Operation
The phase detector on these devices is a digital circuit
that responds to the rising edges of the detector’s two in-
puts. The phase detector output has three states: a high,
5V state, a low, 0V state, and a middle, 2.5V state. In the
high and low states the output impedance of the detector
is low and the middle state output impedence is high, typi-
cally 6.0k
. When there is any static frequency difference
between the inputs, the detector output is fixed at its high
level if the +input (the sense amplifier signal) is greater in
frequency, and fixed at its low level if the -input (the refer-
ence frequency signal) is greater in frequency.
When the frequencies of the two inputs to the detector
are equal, the phase detector switches between its middle
state and either the high or low states, depending on the
relative phase of the two signals. If the +input is leading in
phase then, during each period of the input frequency, the
detector output will be high for a time equal to the time dif-
ference between the rising edges of the inputs, and will
be at its middle level for the remainder of the period. If the
phase relationship is reversed, then the detector will go
low for a time proportional to the phase difference of the
inputs. The resulting gain of the phase detector. k, is
5V/4
π
radians or about 0.4V/radian. The dynamic range of
the detector is
±
2
π
radians.
The operation of the phase detector is illustrated in the
figures below. The upper figure shows typical voltage
waveforms seen at the detector output for leading and
lagging phase conditions. The lower figure is a state dia-
gram of the phase detector logic. In this figure, the circles
represent the 10 possible states of the logic, and the con-
necting arrows represent the transition events/paths to
and from these states. Transition arrows that have a clock-
wise rotation are the result of a rising edge on the +input,
and conversely, those with counter-clockwise rotation are
tied to the rising edge of the -input signal.
The normal operational states of the logic are 6 and 7 for
positive phase error, 1 and 2 for a negative phase error.
States 8 and 9 occur during positive frequency error, 3
and 4 during negative frequency error. States 5 and 10
occur only as the inputs cross over from the frequency er-
ror to a normal phase error only condition. The level of the
phase detector output is determined by the logic state as
defined in the state diagram figure. The lock indicator out-
put is high, off, when the detector is in states 1, 2, 6, or 7.
UC1633
UC2633
UC3633
Typical Phase Detector Output Waveforms
Phase Detector State Diagram
APPLICATION AND OPERATION INFORMATION
5
Powered by ICminer.com Electronic-Library Service CopyRight 2003
相關PDF資料 |
PDF描述 |
|---|---|
| UC2633Q | Analog Phase-Locked Loop |
| UC2633QTR | Iso high side smart power solid state relay |
| UC3633J | DMOS driver for bipolar stepper motor |
| UC3633Q | Analog Phase-Locked Loop |
| UC3633QTR | Stepper motor driver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| UC1634 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Phase Locked Frequency Controller |
| UC1634J | 制造商:Texas Instruments 功能描述:2-PHASE BRUSHLESS DC MOTOR CNTRLR 16CDIP - Rail/Tube |
| UC1634J883B | 制造商:Texas Instruments 功能描述:FREQUENCY CONTROLLER - Rail/Tube |
| UC1634L | 制造商:Texas Instruments 功能描述:FREQUENCY CONTROLLER - Rail/Tube |
| UC1634L883B | 制造商:Texas Instruments 功能描述:FREQUENCY CONTROLLER - Rail/Tube |
發布緊急采購，3分鐘左右您將得到回復。