- 您現在的位置：買賣IC網 > Datasheet目錄47 > XRP7714ILB-0X14-F (Exar Corporation)IC REG 5OUT BCK/LINEAR 40TQFN Datasheet資料下載
參數資料
| 型號： | XRP7714ILB-0X14-F |
| 廠商： | Exar Corporation |
| 文件頁數： | 15/29頁 |
| 文件大小： | 1009K |
| 描述： | IC REG 5OUT BCK/LINEAR 40TQFN |
| 標準包裝： | 490 |
| 系列： | PowerXR |
| 拓撲： | 降壓（降壓）同步（4），線性（LDO）（1） |
| 功能： | 任何功能 |
| 輸出數： | 5 |
| 頻率 - 開關： | 1.5MHz |
| 電壓/電流 - 輸出 1： | 控制器 |
| 電壓/電流 - 輸出 2： | 控制器 |
| 電壓/電流 - 輸出 3： | 控制器 |
| 帶 LED 驅動器： | 無 |
| 帶監控器： | 無 |
| 帶序列發生器： | 是 |
| 電源電壓： | 4.75 V ~ 25 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 40-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 40-TQFN（6x6） |
| 包裝： | 托盤 |
| 其它名稱： | 1016-1700 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
X
X
R
R
P
P
7
7
7
7
1
1
4
4
Q
Q
u
u
a
a
d
d
C
C
h
h
a
a
n
n
n
n
e
e
l
l
D
D
i
i
g
g
i
i
t
t
a
a
l
l
P
P
W
W
M
M
S
S
t
t
e
e
p
p
D
D
o
o
w
w
n
n
C
C
o
o
n
n
t
t
r
r
o
o
l
l
l
l
e
e
r
r
?2011 Exar Corporation
15/29
Rev. 1.1.6
FAULT HANDLING
While the chip is operating there are four different types of fault handling:
" Under Voltage Lockout (UVLO) monitors the input voltage to the chip, and the chip will
shutdown all channels if the voltage drops to critical levels.
" Over Temperature Protection (OTP) monitors the temperature of the chip, and the chip
will shutdown all channels if the temperature rises to critical levels.
" Over Voltage Protection (OVP) monitors the voltage of channel and will shutdown the
channel if it surpasses its voltage threshold.
" Over Current Protection (OCP) monitors the current of a channel, and will shutdown the
channel if it surpasses its current threshold. The channel will be automatically restarted
after a 200ms delay.
Under Voltage Lockout (UVLO)
There are two locations where the under voltage can be sensed: VIN1 and VIN2. The
SET_UVLO_WARN_VINx register that sets the under voltage warning set point condition at 100mV
increments. When the warning threshold is reached, the Host is informed via a GPIO or by reading
the READ_WARN_FLAG register.
The SET_UVLO_TARG_VINx register that controls the under voltage fault set point condition at
100mV increments. This fault condition will be indicated in the READ_FAULT_WARN register.
When an under voltage fault condition occurs (either on VIN1 or VIN2), the fault flag register is set
and all of the XRP7714 outputs are shut down. The measured input voltages can be read back
using the READ_VIN1 or READ_VIN2 register, and both registers have a resolution of 100mV per
LSB. When the UVLO condition clears (voltage rises above the UVLO Warning Threshold), the chip
can be configured to automatically restart.
VIN1
This is a multi-function pin that provides power to both the Standby Linear Regulator and internal
linear regulators to generate VCCA, VDD, and the Standby LDO (LDOUT).
It is also used as a UVLO detection pin. If Vin1 falls below its user programmed limit, all channels
are shut down.
VIN2
VIN2 is required to be tied to VIN1 pin. It can be used as a UVLO detection pin. If VIN2 falls below
its user programmed limit, all channels are shut down.
Temperature Monitoring and Over Temperature Protection (OTP)
" Reading the junction temperature
This register allows the user to read back the temperature of the IC. The temperature is expressed
in Kelvin with a maximum range of 520K, a minimum of 200K, and an LSB of 5 degrees K. The
temperature can be accessed by reading the READ_VTJ register.
" Over Temperature Warning
There are also warning and fault flags that get set in the READ_OVV_UVLO_OVT_FLAG register.
The warning threshold is configurable to 5 or 10 Degrees C below the fault threshold. When the
junction temperature reaches 5 or 10 Degrees C below the user defined set point, the over-
temperature warning bit [OTPW] gets set in the READ_OVV_UVLO_OVT_FLAG register to warn the
user that the IC might go into an over temperature condition (and shutdown all of the regulators).
相關PDF資料 |
PDF描述 |
|---|---|
| XRP7740ILB-0X18-F | IC REG 5OUT BCK/LINEAR 40TQFN |
| XRP7740ILBTR-F | IC REG 5OUT BCK/LINEAR 40TQFN |
| ZDS1009TA | IC CURRENT MIRROR SOT223-8 |
| ZXCT1008FTA | IC CURRENT MONITOR 1% SOT23-3 |
| ZXCT1009T8TA | IC CURRENT MONITOR 1% SM8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRP7714ILB-0X18-F | 功能描述:電壓模式 PWM 控制器 4CH DIGITAL PWM CTRL I2C INTERFACE RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓撲結構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
| XRP7714ILB-0X1C-F | 功能描述:電壓模式 PWM 控制器 4CH DIGITAL PWM CTRL I2C INTERFACE RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓撲結構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
| XRP7714ILB-F | 功能描述:軟開關 PWM 控制器 4Ch Digital Pwr Cntr w/LDO prog. thru PC RoHS:否 制造商:Fairchild Semiconductor 輸出端數量: 輸出電流: 開關頻率: 工作電源電壓:30 V 電源電流: 最大工作溫度:+ 105 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| XRP7714ILBTR-0X10-F | 制造商:EXAR 制造商全稱:EXAR 功能描述:Quad Channel Digital PWM Step Down Controller |
| XRP7714ILBTR-0X14-F | 制造商:EXAR 制造商全稱:EXAR 功能描述:Quad Channel Digital PWM Step Down Controller |
發布緊急采購，3分鐘左右您將得到回復。