
2
Absolute Maximum Ratings (TA = +25°C)
Thermal Information
Supply Voltage between VS+ and VS- . . . . . . . . . . . . . . . . . . . 13.2V
Pin Voltages . . . . . . . . . . . . . . . . . . . . . . . . . VS- -0.5V to VS+ +0.5V
Maximum Continuous Output Current . . . . . . . . . . . . . . . . . . . 20mA
Thermal Resistance (Typical)
θJA (°C/W) θJC (°C/W)
Flat Pack Package (Notes
1, 2) . . . . . .
165
60
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . -65°C to +150°C
Ambient Operating Temperature . . . . . . . . . . . . . . . -55°C to +125°C
Operating Junction Temperature . . . . . . . . . . . . . . . . . . . . . . +150°C
Power Dissipation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21.8mW
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
1.
θ
JA is measured with the component mounted on a low effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
2. For
θJC, the “case temp” location is the center of the exposed metal pad on the package underside.
IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typical values are for information purposes only. Unless otherwise noted, all tests
are at the specified temperature and are pulsed tests, therefore: TJ = TC = TA
Electrical Specifications
VS+ = +5V, VS- = -5V, RL = 150Ω, TA = +25°C unless otherwise specified.
PARAMETER
DESCRIPTION
CONDITIONS
MIN
TYP
MAX
UNIT
AC PERFORMANCE
BW
-3dB Bandwidth
AV = +1
250
MHz
AV = -1
380
MHz
AV = +2
350
MHz
BW1
0.1dB Bandwidth
20
MHz
SR
Slew Rate
VO = -2.5V to +2.5V, AV = +2
4500
V/s
tS
0.1% Settling Time
VOUT = -2.5V to +2.5V, AV = 2
16
ns
eN
Input Voltage Noise
2.8
nV/
√Hz
iN+
IN+ Input Current Noise
6pA/
√Hz
dG
Differential Gain Error (Note
3)AV = +2
0.02
%
dP
Differential Phase Error (Note
3)AV = +2
0.04
°
DC PERFORMANCE
RF, RG
Internal RF and RG
325
Ω
INPUT CHARACTERISTICS
RIN
Input Resistance
at IN+2
M
Ω
CIN
Input Capacitance
1pF
ENABLE
tEN
Enable Time
280
ns
tDIS
Disable Time
400
ns
NOTE:
3. Standard NTSC test, AC signal amplitude = 286mVP-P, f = 3.58MHz
5962-0625501QHC