欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: 71M6542F-IGTR/F
廠商: MAXIM INTEGRATED PRODUCTS INC
元件分類: 模擬信號調理
英文描述: SPECIALTY ANALOG CIRCUIT, PQFP100
封裝: LEAD FREE, LQFP-100
文件頁數: 148/165頁
文件大小: 2208K
代理商: 71M6542F-IGTR/F
v1.1
2008–2011 Teridian Semiconductor Corporation
83
3.2.1
BRN Mode
In BRN mode, most non-metering digital functions are active (as shown in Table 67) including ICE, UART,
EEPROM, LCD and RTC. In BRN mode, the PLL continues to function at the same frequency as MSN
mode. It is up to the MPU to scale down the PLL (using PLL_FAST, I/O RAM 0x2200[4]) or the MPU
frequency (using MPU_DIV[2:0], I/O RAM 0x2200[2:0]) in order to save power.
From BRN mode, the MPU can choose to enter LCD or SLP modes. When system power is restored
while the 71M654x is in BRN mode, the part automatically transitions to MSN mode.
The recommended minimum power configuration for BRN mode is as follows:
RCE0 = 0x00 (I/O RAM 0x2709[7:0]) - remote sensors disabled
LCD_BAT = 1 (I/O RAM 0x2402[7]) - LCD powered from VBAT
LCD_VMODE[1:0] = 0 (I/O RAM 0x2401[7:6]) - 5V LCD boost disabled
CE6 = 0x00 (I/O RAM 0x2106) - CE, RTM and CHOP are disabled
MUX_DIV[3:0] = 0 (I/O RAM 0x2100[7:4]) - the ADC multiplexer is disabled
ADC_E = 0 (I/O RAM 0x2704[4]) - ADC disabled
VREF_CAL = 0 (I/O RAM 0x2704[7]) – Vref not driven out
VREF_DIS = 1 (I/O RAM 0x2704[6]) - Vref disabled
PRE_E = 0 (I/O RAM 0x2704[5] - pre-amp disabled
BCURR = 0 (I/O RAM 0x2704[3]) - battery 100A current load OFF
TMUX[5:0] = 0x0E (I/O RAM 0x2502[5:0]) – TMUXOUT output set to a dc value
TMUX2[4:0] = 0x0E (I/O RAM 0x2503[4:0]) – TMUXOUT2 output set to a dc value
CKGN = 0x24 (I/O RAM 0x2200) - PLL set slow, MPU_DIV[2:0] (I/O RAM 0x2200[2:0]) set to maximum
TEMP_PER[2:0] = 6 (I/O RAM 0x28A0[2:0]) - temp measurement set to automatic every 512 s
TEMP_BSEL = 1 (I/O RAM 0x28A0[7]) - temperature sensor monitors VBAT
PCON = 1 (SFR 0x87) - at the end of the main BRN loop, halt the MPU and wait for an interrupt
The baud rate registers are adjusted as desired
All unused interrupts are disabled
3.2.2
LCD Mode
LCD mode may be commanded by the MPU at any time by setting the LCD_ONLY control bit (I/O RAM
0x28B2[6]). However, it is recommended that the LCD_ONLY control bit be set by the MPU only after the
71M654x has entered BRN mode. For example, if the 71M654x is in MSN mode when LCD_ONLY is set,
the duration of LCD mode is very brief and the 71M654x immediately 'wakes'.
In LCD mode, V3P3D is disabled, thus removing all current leakage from the VBAT pin. Before asserting
LCD_ONLY mode, it is recommended that the MPU minimize PLL current by reducing the output
frequency of the PLL to 6.2 MHz (i.e., write PLL_FAST = 0, I/O RAM 0x2200[4]). The LCD boost system
requires a clock from the PLL for its operation. Thus, if the LCD boost system is enabled (i.e.,
LCD_VMODE[1:0] = 10, I/O RAM 0x2401[7:6]), then the PLL is automatically kept active during LCD
mode, otherwise the PLL is de-activated.
In LCD mode, the data contained in the LCD_SEG registers is displayed using the segment driver pins.
Up to two LCD segments connected to the pins SEGDIO22 and SEGDIO23 can be made to blink without
the involvement of the MPU, which is disabled in LCD mode. To minimize battery power consumption,
only segments that are used should be enabled.
After the transition from LCD mode to MSN or BRN mode, the PC (Program Counter) is at 0x0000, the
XRAM is in an undefined state, and configuration I/O RAM bits are reset (see Table 76 for I/O RAM state
upon wake). The data stored in non-volatile I/O RAM locations is preserved in LCD mode (the shaded
locations in Table 76 are non-volatile).
相關PDF資料
PDF描述
71M6541D-IGT/F SPECIALTY ANALOG CIRCUIT, PQFP64
71M6542G-IGT/F SPECIALTY ANALOG CIRCUIT, PQFP100
71M6541G-IGT/F SPECIALTY ANALOG CIRCUIT, PQFP64
71M6541F-IGT/F SPECIALTY ANALOG CIRCUIT, PQFP64
71M6543F-IGT/F SPECIALTY ANALOG CIRCUIT, PQFP100
相關代理商/技術參數
參數描述
71M6542FT-IGT/F 制造商:Maxim Integrated Products 功能描述:1-PHASE SOC 128KB WITH PREC TEMP SENSOR - Rail/Tube
71M6542FT-IGTR/F 制造商:Maxim Integrated Products 功能描述:1-PHASE SOC, 64KB FLASH, PRES TEMP SENSOR - Tape and Reel
71M6542G 制造商:未知廠家 制造商全稱:未知廠家 功能描述:71M6541D/71M6541F/71M6541G/71M6542F/71M6542G 是 TeridianTM 的第4 代高集成度單相電表SoC
71M6542G-IGT/F 功能描述:計量片上系統 - SoC 1-Phase Metering SOC with 128KB Flash RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 處理器系列:71M6511 類型:Metering SoC 最大時鐘頻率:70 Hz 程序存儲器大小:64 KB 數據 RAM 大小:7 KB 接口類型:UART 可編程輸入/輸出端數量:12 片上 ADC: 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-64 封裝:Reel
71M6542G-IGTR/F 制造商:Maxim Integrated Products 功能描述:- Tape and Reel
主站蜘蛛池模板: 澎湖县| 吐鲁番市| 宽城| 墨玉县| 迭部县| 罗甸县| 库尔勒市| 合山市| 平远县| 晋城| 静宁县| 安阳市| 枣阳市| 塔城市| 田阳县| 阿巴嘎旗| 特克斯县| 临邑县| 兴仁县| 阿尔山市| 逊克县| 石渠县| 大姚县| 成安县| 锡林郭勒盟| 永康市| 将乐县| 临武县| 浦北县| 抚松县| 宜兴市| 镇江市| 唐山市| 漳浦县| 乌兰察布市| 永定县| 台江县| 上高县| 凤山市| 固始县| 呼伦贝尔市|