- 您現在的位置：買賣IC網 > PDF目錄97839 > 73S8014R-IL/F (MAXIM INTEGRATED PRODUCTS INC) SPECIALTY ANALOG CIRCUIT, PDSO20 PDF資料下載
參數資料
| 型號： | 73S8014R-IL/F |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 模擬信號調理 |
| 英文描述： | SPECIALTY ANALOG CIRCUIT, PDSO20 |
| 封裝： | ROHS COMPLIANT, SOP-20 |
| 文件頁數： | 1/29頁 |
| 文件大小： | 375K |
| 代理商： | 73S8014R-IL/F |
當前第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
73S8014R
Smart Card Interface
Simplifying System Integration
DATA SHEET
September 2008
Rev. 1.0
2008 Teridian Semiconductor Corporation
1
DESCRIPTION
The Teridian 73S8014R is a single smart card (ICC) interface
circuit, firmware compatible with 8024-type devices for
configurations where only asynchronous cards must be
supported. It is derived from the 73S8024RN industry-
standard electrical interface. The 73S8014R has been
optimized to match most of the typical Set-Top-Box / A/V
Conditional Access applications. Optimization essentially
involved a smaller pin-count, support for single I/O, and
maximum card current of 65mA (ISO-7816 / EMV
compliance).
The 73S8014R interfaces with the host processor through the
same bus (digital I/Os) as the 73S8024RN, which is
compatible with any other 8024-type IC. As a result, the
73S8014R is a very attractive cost-reduction path from
traditional 8024 ICs.
The 73S8014R has been designed to
provide full electrical compliance with ISO 7816-3 and EMV
4.0 specifications.
Interfacing with the system controller is done through a
control bus, composed of digital inputs to control the
interface, and one interrupt output to inform the system
controller of the card presence and faults.
The card clock can be generated by an on-chip oscillator
using an external crystal or by connection to an externally
supplied clock signal.
The 73S8014R incorporates an ISO 7816-3
activation/deactivation sequencer that controls the card
signals. Level-shifters drive the card signals with the
selected card voltage (3V or 5V), coming from an internal
Low Drop-Out (LDO) voltage regulator. This LDO regulator is
powered by a dedicated power supply input VPC. Digital
circuitry is powered separately by a digital power supply VDD.
With its embedded LDO regulator, the 73S8024RN is a
cost-effective solution for any application where a 5V
(typically -5% +10%) power supply is available.
Emergency card deactivation is initiated upon card extraction
or upon any fault detected by the protection circuitry. The
fault can be a card over-current, VCC undervoltage or power
supply fault (VDD). The card over-current circuitry is a true
current detection function, as opposed to VCC voltage drop
detection, as usually implemented in non-Teridian 8024
interface ICs.
The VDD voltage fault has a threshold voltage that can be
adjusted with an external resistor network. It allows
automated card deactivation at a customized VDD voltage
threshold value. It can be used, for instance, to match the
system controller operating voltage range.
APPLICATIONS
Set-Top-Box Conditional Access and Pay-per-View
General purpose smart card readers
ADVANTAGES
Same advantages as the Teridian 73S80xxR family:
VCC card generated by an LDO regulator
Very low power dissipation (saves up to 1/2W)
Fewer external components are required
Better noise performance
True card over-current detection
Firmware compatibility with all 8024 ICs
Small format 20SO package
FEATURES
Card Interface:
Complies with ISO 7816-3 and EMV 4.0
Supports 3V / 5V cards
ISO 7816-3 Activation / Deactivation sequencer
Automated deactivation upon hardware fault (i.e. upon
drop on VDD power supply or card overcurrent)
The VDD voltage supervisor threshold value (fault) can
be externally adjusted
Over-current detection 130mA max
Card CLK clock frequency up to 20MHz
System Controller Interface:
3 Digital inputs control the card activation /
deactivation, card reset and card voltage
2 Digital inputs control the card clock frequency
1 Digital output, interrupt to the system controller,
reports to the host the card presence and faults
Crystal oscillator or host clock, up to 27MHz
Regulator Power Supply:
4.75V to 5.5V
Digital Interfacing: 2.7V to 5.5V
6kV ESD protection on the card interface
Package: SO 20-pin
RoHS compliant (6/6) lead-free package
相關PDF資料 |
PDF描述 |
|---|---|
| 73S8014RT-ILR/F | SPECIALTY ANALOG CIRCUIT, PDSO20 |
| 73S8014RT-IL/F | SPECIALTY ANALOG CIRCUIT, PDSO20 |
| 73S8023C-IM/F | SPECIALTY ANALOG CIRCUIT, QCC32 |
| 73S8023C-IMR/F | SPECIALTY ANALOG CIRCUIT, QCC32 |
| 74HC4046AD/T3 | PLL FREQUENCY SYNTHESIZER, PDSO16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 73S8014R-ILR/F | 功能描述:輸入/輸出控制器接口集成電路 Smart Card Interface Comp w/8024 RoHS:否 制造商:Silicon Labs 產品: 輸入/輸出端數量: 工作電源電壓: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-64 封裝:Tray |
| 73S8014R-ILR/F1 | 功能描述:輸入/輸出控制器接口集成電路 RoHS:否 制造商:Silicon Labs 產品: 輸入/輸出端數量: 工作電源電壓: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-64 封裝:Tray |
| 73S8014R-ILR/F2 | 功能描述:輸入/輸出控制器接口集成電路 Smart Card Interface Comp w/8024 RoHS:否 制造商:Silicon Labs 產品: 輸入/輸出端數量: 工作電源電壓: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-64 封裝:Tray |
| 73S8014R-ILR/F3 | 功能描述:輸入/輸出控制器接口集成電路 RoHS:否 制造商:Silicon Labs 產品: 輸入/輸出端數量: 工作電源電壓: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-64 封裝:Tray |
| 73S8014RN | 制造商:TERIDIAN 制造商全稱:TERIDIAN 功能描述:Smart Card Interface |
發布緊急采購，3分鐘左右您將得到回復。