- 您現在的位置：買賣IC網 > PDF目錄373924 > AD7891 (Analog Devices, Inc.) 14-Bit 50 kSPS ADC Ser. Out, 1.8V Operation 8-MSOP PDF資料下載
參數資料
| 型號： | AD7891 |
| 廠商： | Analog Devices, Inc. |
| 英文描述： | 14-Bit 50 kSPS ADC Ser. Out, 1.8V Operation 8-MSOP |
| 中文描述： | LC2MOS 8通道，12位高速數據采集系統 |
| 文件頁數： | 15/20頁 |
| 文件大小： | 173K |
| 代理商： | AD7891 |
AD7891
–15–
REV. A
As in the 8X51 circuit above, the way that the 68HC11 is in-
formed that a conversion is completed is not shown in the dia-
gram. The
EOC
line can be used to inform the 68HC11 that a
conversion is complete by using it as an interrupt signal. The
interrupt service routine reads in the result of the conversion. If
a software conversion start is used, the 68HC11 can wait for
2.0
μ
s (AD7891-2) or 2.2
μ
s (AD7891-1) before reading from
the AD7891.
68HC11*
DATA OUT
AD7891*
*ADDITIONAL PINS OMITTED FOR CLARITY
SCLK
DATA IN
RFS
TFS
PC7
PC6
SCK
MOSI
MOSO
Figure 8. AD7891 to 68HC11 Interface
AD7891 to ADSP-21xx Serial Interface
An interface between the AD7891 and the ADSP-21xx is shown
in Figure 9. In the interface shown either SPORT0 or SPORT1
can be used to transfer data to the AD7891. When reading from
the part, the SPORT must be set up with a serial word length of
16 bits. When writing to the AD7891, a serial word length of 6
bits or more can be used. Other setups for the serial interface on
the ADSP-21xx internal SCLK, alternate framing mode and
active low framing signal. Normally the
EOC
line from the
AD7891 would be connected to the
IRQ2
line of the ADSP-
21xx to interrupt the DSP at the end of a conversion (not shown
in diagram).
ADSP-21xx*
DATA OUT
AD7891*
*ADDITIONAL PINS OMITTED FOR CLARITY
SCLK
DATA IN
RFS
TFS
RFS
TFS
SCLK
DT
DR
Figure 9. AD7891 to ADSP-2101 Serial Interface
AD7891 to DSP5600x Serial Interface
Figure 10 shows a serial interface between the AD7891 and the
DSP5600x series of DSPs. When reading from the AD7891, the
DSP5600x should be set up for 16-bit data transfers, MSB first,
normal mode synchronous operation, internally generated word
frame sync and gated clock. When writing to the AD7891, 8-bit
or 16-bit data transfers can be used. The frame sync signal from
the DSP5600x must be inverted before being applied to the
RFS
and
TFS
inputs of the AD7891 as shown in Figure 10.
To monitor the conversion time of the AD7891, a scheme such
as outlined in previous interfaces with
EOC
can be used. This
can be implemented by connecting the
EOC
line directly to the
IRQA
input of the DSP5600x.
DSP56000/
DSP56002*
DATA OUT
AD7891*
*ADDITIONAL PINS OMITTED FOR CLARITY
SCLK
DATA IN
RFS
TFS
FST (SC2)
SCK
STD
SRD
Figure 10. AD7891 to DSP5600x Serial Interface
AD7891 to TMS320xxx Serial Interface
The AD7891 can be interfaced to the serial port of TMS320xxx
DSPs as shown in Figure 11. External timing generation cir-
cuitry is necessary to generate the serial clock and syncs neces-
sary for the interface.
TMS32020/
TMS320C25/
TMS320C5X/
TMS320C3X*
DATA OUT
AD7891*
*ADDITIONAL PINS OMITTED FOR CLARITY
SCLK
DATA IN
RFS
TFS
FSX
CLKX
DX
DR
CLKR
FSR
TIMING
GENERATION
CIRCUITRY
Figure 11. AD7891 to TMSxxx Serial Interface
相關PDF資料 |
PDF描述 |
|---|---|
| AD7891AP-2 | LC2MOS 8-Channel, 12-Bit High Speed Data Acquisition System |
| AD7891AS-2 | LC2MOS 8-Channel, 12-Bit High Speed Data Acquisition System |
| AD7892AR-2 | LC2MOS Single Supply, 12-Bit 600 kSPS ADC |
| AD7892SQ-1 | LC2MOS Single Supply, 12-Bit 600 kSPS ADC |
| AD7892 | LC2MOS Single Supply, 12-Bit 600 kSPS ADC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7891AP1 | 制造商:Analog Devices 功能描述: |
| AD7891AP-1 | 功能描述:IC DAS 12BIT 8CH 44-PLCC RoHS:否 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
| AD7891AP-1REEL | 功能描述:IC DAS 12BIT 8CH 44-PLCC RoHS:否 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
| AD7891AP2 | 制造商:Analog Devices 功能描述: |
| AD7891AP-2 | 功能描述:IC DAS 12BIT 8CH 44-PLCC RoHS:否 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
發布緊急采購，3分鐘左右您將得到回復。