- 您現在的位置：買賣IC網 > PDF目錄373945 > AD8351ARM (ANALOG DEVICES INC) Low Distortion Differential RF/IF Amplifier PDF資料下載
參數資料
| 型號： | AD8351ARM |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 消費家電 |
| 英文描述： | Low Distortion Differential RF/IF Amplifier |
| 中文描述： | SPECIALTY CONSUMER CIRCUIT, PDSO10 |
| 封裝： | MO-187BA, MSOP-10 |
| 文件頁數： | 15/16頁 |
| 文件大小： | 465K |
| 代理商： | AD8351ARM |
REV. B
AD8351
–15–
Table III. Evaluation Board Configuration Options
Component
Function
Default Condition
P1-1, P1-2,
VPOS, AGND
P1-3
Supply and Ground Pins.
Not Applicable
Common-Mode Offset Pin. Allows for monitoring or adjustment of the
output common-mode voltage.
Device Enable. Configured such that switch W1 disables the device when
Pin 1 is set to ground. Device can be disabled remotely using Pin 4 of
header P1.
Input Interface. R3 and R12 are used to ground one side of the differential
drive interface for single-ended applications. T1 is a 1-to-1 impedance ratio R3 = Open (Size 0603)
balun used to transform a single-ended input into a balanced differential
signal. R2 and R4 are used to provide a differential 50
input termination. (Size 0603)
R5 and R8 can be increased to reduce gain peaking when driving from a high
C4 = C5 = 10 0 nF (Size 0603)
source impedance. The 50
termination provides an insertion loss of 6 dB. T1 = Macom
TM
ETC1-1-13
C4 and C5 are used to provide ac coupling.
Output Interface. R13 and R14 are used to ground one side of the differential
output interface for single-ended applications. T2 is a 1-to-1 impedance ratio
balun used to transform a balanced differential signal into a single-ended
signal. R9, R10, and R11 are provided for generic placement of matching
components. R15 and R16 allow additional output series resistance when
driving capacitive loads. The evaluation board is configured to provide a
150
to 50
impedance transformation with an insertion loss of 9.9 dB.
C4 through C7 are used to provide ac coupling.
Gain Setting Resistor. Resistor R1 is used to set the gain of the device.
Refer to TPC 2 when selecting gain resistor. When R1 is 100
, the
overall system gain of the evaluation board will be approximately –6 dB.
Power Supply Decoupling. The supply decoupling consists of a 100 nF
capacitor to ground.
Common-Mode Offset Adjustment. Used to trim common-mode output
level. By applying a voltage to Pin 3 of header P1, the output common-
mode voltage can be directly adjusted. Typically decoupled to ground
using a 0.1
μ
F capacitor.
Calibration Networks. Calibration path provided to allow for compensation
of the insertion loss of the baluns and the reactance of the coupling capacitors.
Not Applicable
W1, R7, P1-4, R17, R18
W1 = Installed
R7 = 0
(Size 0603)
R17 = R18 = 0
(Size 0603)
R2 = R4 = 24.9
(Size 0805)
R2, R3, R4, R5, R8, R12,
T1, C4, C5
R5 = R8 = R12 = 0
R9, R10, R11, R13, R14,
R15, R16, T2, C4, C5,
C6, C7
R9 = R10 = 61.9
(Size 0603)
R11 = 61.9
(Size 0603)
R13 = Open (Size 0603)
R14 = 0
(Size 0603)
R15 = R16 = 0
(Size 0402)
C4 = C5 = 100 nF (Size 0603)
C6 = C7 = 100 nF (Size 0603)
T2 = Macom ETC1-1-13
R1 = 100
(Size 0603)
R1
C2
C2 = 100 nF (Size 0805)
R6, C3, P1-3
R6 = 0
(Size 0603)
C3 = 0.1
μ
F (Size 0805)
T3, T4, C9, C10
T3 = T4 = Macom
ETC1-1-13
C9 = C10 = 100 nF
(Size 0603)
相關PDF資料 |
PDF描述 |
|---|---|
| AD8351ARM-R2 | Low Distortion Differential RF/IF Amplifier |
| AD8351ARM-REEL7 | Low Distortion Differential RF/IF Amplifier |
| AD8354 | 100 MHz-2.7 GHz RF Gain Block |
| AD8354ACP-R2 | 100 MHz-2.7 GHz RF Gain Block |
| AD8354-EVAL | 100 MHz-2.7 GHz RF Gain Block |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8351ARM-R2 | 制造商:Analog Devices 功能描述:RF Amp Chip Single GP 5.5V 10-Pin MSOP T/R 制造商:Analog Devices 功能描述:RF AMP CHIP SGL GP 5.5V 10MSOP - Tape and Reel 制造商:Rochester Electronics LLC 功能描述:MINISO IF SAMPLING ADC DRIVER - Bulk |
| AD8351ARM-REEL7 | 功能描述:IC DIFF AMP RF/IF LD 10-MSOP T/R RoHS:否 類別:RF/IF 和 RFID >> RF 放大器 系列:- 標準包裝:3,000 系列:- 頻率:100MHz ~ 6GHz P1dB:9.14dBm（8.2mW） 增益:15.7dB 噪音數據:1.3dB RF 型:CDMA，TDMA，PCS 電源電壓:2.7 V ~ 5 V 電流 - 電源:60mA 測試頻率:2GHz 封裝/外殼:0505（1412 公制） 包裝:帶卷 (TR) |
| AD8351ARMZ | 功能描述:IC DIFF AMP RF/IF LOWDIST 10MSOP RoHS:是 類別:RF/IF 和 RFID >> RF 放大器 系列:- 標準包裝:3,000 系列:- 頻率:100MHz ~ 6GHz P1dB:9.14dBm（8.2mW） 增益:15.7dB 噪音數據:1.3dB RF 型:CDMA，TDMA，PCS 電源電壓:2.7 V ~ 5 V 電流 - 電源:60mA 測試頻率:2GHz 封裝/外殼:0505（1412 公制） 包裝:帶卷 (TR) |
| AD8351ARMZ-REEL7 | 功能描述:IC DIFF AMP RF/IF LD 10MSOP RoHS:是 類別:RF/IF 和 RFID >> RF 放大器 系列:- 標準包裝:3,000 系列:- 頻率:100MHz ~ 6GHz P1dB:9.14dBm（8.2mW） 增益:15.7dB 噪音數據:1.3dB RF 型:CDMA，TDMA，PCS 電源電壓:2.7 V ~ 5 V 電流 - 電源:60mA 測試頻率:2GHz 封裝/外殼:0505（1412 公制） 包裝:帶卷 (TR) |
| AD8351-EVAL | 制造商:Analog Devices 功能描述:MINISO IF SAMPLING ADC DRIVER - Bulk |
發布緊急采購，3分鐘左右您將得到回復。