欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: AD9883AKST-140
廠商: ANALOG DEVICES INC
元件分類: 消費家電
英文描述: 110 MSPS/140 MSPS Analog Interface for Flat Panel Displays
中文描述: SPECIALTY CONSUMER CIRCUIT, PQFP80
封裝: PLASTIC, MS-026BEC, LQFP-80
文件頁數: 11/28頁
文件大小: 229K
代理商: AD9883AKST-140
REV. B
AD9883A
–11–
GAIN
1.0
0.
0
00H
FFH
I
0.5
OFFSET = 00H
OFFSET = 3FH
OFFSET = 7FH
OFFSET = 00H
OFFSET = 7FH
OFFSET = 3FH
Figure 2. Gain and Offset Control
Gain and Offset Control
The AD9883A can accommodate input signals with inputs
ranging from 0.5 V to 1.0 V full scale. The full-scale range is set
in three 8-bit registers (Red Gain, Green Gain, and Blue Gain).
Note that
increasing
the gain setting results in an image with
less
contrast.
The offset control shifts the entire input range, resulting in a
change in image brightness. Three 7-bit registers (Red Offset,
Green Offset, Blue Offset) provide independent settings for
each channel. The offset controls provide a
±
63 LSB adjust-
ment range. This range is connected with the full-scale range, so
if the input range is doubled (from 0.5 V to 1.0 V) then the offset
step size is also doubled (from 2 mV per step to 4 mV per step).
Figure 2 illustrates the interaction of gain and offset controls.
The magnitude of an LSB in offset adjustment is proportional
to the full-scale range, so changing the full-scale range also
changes the offset. The change is minimal if the offset setting is
near midscale. When changing the offset, the full-scale
range
is
not affected, but the full-scale
level
is shifted by the same amount
as the zero scale level.
Sync-on-Green
The Sync-on-Green input operates in two steps. First, it sets a
baseline clamp level off of the incoming video signal with a
negative peak detector. Second, it sets the sync trigger level to a
programmable level (typically 150 mV) above the negative peak.
The Sync-on-Green input must be ac-coupled to the Green
analog input through its own capacitor, as shown in Figure 3.
The value of the capacitor must be 1 nF
±
20%. If Sync-on-Green
is not used, this connection is not required. Note that the Sync-
on-Green signal is always negative polarity.
R
AIN
B
AIN
G
AIN
SOG
47nF
47nF
47nF
1nF
Figure 3. Typical Clamp Configuration
Clock Generation
A phase locked loop (PLL) is employed to generate the pixel
clock. In this PLL, the Hsync input provides a reference fre-
quency. A voltage controlled oscillator (VCO) generates a much
higher pixel clock frequency. This pixel clock is divided by the
PLL divide value (registers 01H and 02H) and phase compared
with the Hsync input. Any error is used to shift the VCO fre-
quency and maintain lock between the two signals.
The stability of this clock is a very important element in provid-
ing the clearest and most stable image. During each pixel time,
there is a period during which the signal is slewing from the old
pixel amplitude and settling at its new value. Then there is a
time when the input voltage is stable, before the signal must
slew to a new value (Figure 4). The ratio of the slewing time to
the stable time is a function of the bandwidth of the graphics
DAC and the bandwidth of the transmission system (cable and
termination). It is also a function of the overall pixel rate. Clearly,
if the dynamic characteristics of the system remain fixed, the
slewing and settling time is likewise fixed. This time must be
subtracted from the total pixel period, leaving the stable period.
At higher pixel frequencies, the total cycle time is shorter, and the
stable pixel time becomes shorter as well.
PIXEL CLOCK
INVALID SAMPLE TIMES
Figure 4. Pixel Sampling Times
Any jitter in the clock reduces the precision with which the
sampling time can be determined, and must also be subtracted
from the stable pixel time.
Considerable care has been taken in the design of the AD9883A’s
clock generation circuit to minimize jitter. As indicated in
Figure 5, the clock jitter of the AD9883A is less than 5% of the
total pixel time in all operating modes, making the reduction in
the valid sampling time due to jitter negligible.
FREQUENCY – MHz
14
12
00
P
10
8
6
4
2
31.5
36.0 36.0 50.0 56.25
75.0 85.5
110.0
Figure 5. Pixel Clock Jitter vs. Frequency
相關PDF資料
PDF描述
AD9883A 110 MSPS/140 MSPS Analog Interface for Flat Panel Displays
AD9883ABST-RL110 110 MSPS/140 MSPS Analog Interface for Flat Panel Displays
AD9883ABST-110 110 MSPS/140 MSPS Analog Interface for Flat Panel Displays
AD9883ABST-140 110 MSPS/140 MSPS Analog Interface for Flat Panel Displays
AD9883AKSTZ-110 110 MSPS/140 MSPS Analog Interface for Flat Panel Displays
相關代理商/技術參數
參數描述
AD9883AKSTZ-110 功能描述:IC FLAT PANEL INTERFACE 80-LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 專用 系列:- 特色產品:NXP - I2C Interface 標準包裝:1 系列:- 應用:2 通道 I²C 多路復用器 接口:I²C,SM 總線 電源電壓:2.3 V ~ 5.5 V 封裝/外殼:16-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:16-TSSOP 包裝:剪切帶 (CT) 安裝類型:表面貼裝 產品目錄頁面:825 (CN2011-ZH PDF) 其它名稱:568-1854-1
AD9883AKSTZ-110 制造商:Analog Devices 功能描述:IC ANALOG INTERFACE
AD9883AKSTZ-140 功能描述:IC FLAT PANEL INTERFACE 80-LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 專用 系列:- 特色產品:NXP - I2C Interface 標準包裝:1 系列:- 應用:2 通道 I²C 多路復用器 接口:I²C,SM 總線 電源電壓:2.3 V ~ 5.5 V 封裝/外殼:16-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:16-TSSOP 包裝:剪切帶 (CT) 安裝類型:表面貼裝 產品目錄頁面:825 (CN2011-ZH PDF) 其它名稱:568-1854-1
AD9883AKSTZ-RL110 功能描述:IC INTERFACE FLAT 110MHZ 80LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 專用 系列:- 標準包裝:3,000 系列:- 應用:PDA,便攜式音頻/視頻,智能電話 接口:I²C,2 線串口 電源電壓:1.65 V ~ 3.6 V 封裝/外殼:24-WQFN 裸露焊盤 供應商設備封裝:24-QFN 裸露焊盤(4x4) 包裝:帶卷 (TR) 安裝類型:表面貼裝 產品目錄頁面:1015 (CN2011-ZH PDF) 其它名稱:296-25223-2
AD9883KST-110 制造商:Rochester Electronics LLC 功能描述:110MHZ ANALOG INTERFACE F - Bulk
主站蜘蛛池模板: 乐山市| 邹城市| 九龙坡区| 甘洛县| 鞍山市| 金乡县| 芜湖县| 梁山县| 江安县| 灌阳县| 松滋市| 永修县| 榆林市| 肥西县| 綦江县| 革吉县| 明光市| 靖西县| 石林| 荥阳市| 泾阳县| 西贡区| 邮箱| 大田县| 益阳市| 始兴县| 花莲市| 伊金霍洛旗| 松阳县| 永春县| 朝阳市| 靖江市| 农安县| 城固县| 汕头市| 大宁县| 文化| 丰顺县| 松原市| 昭平县| 牙克石市|