欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: ADCMP580
廠商: Analog Devices, Inc.
英文描述: Ultrafast SiGe Voltage Comparators
中文描述: 超高速電壓比較器硅鍺
文件頁數: 12/16頁
文件大小: 284K
代理商: ADCMP580
ADCMP580/ADCMP581/ADCMP582
OPTIMIZING HIGH SPEED PERFORMANCE
As with any high speed comparator, proper design and layout
techniques are essential to obtaining the specified performance.
Stray capacitance, inductance, inductive power, and ground
impedances or other layout issues can severely limit performance
and can cause oscillation. Discontinuities along input and output
transmission lines can also severely limit the specified pulse
width dispersion performance.
Rev. 0 | Page 12 of 16
For applications in a 50 Ω environment, input and output
matching have a significant impact on data-dependent (or
deterministic) jitter (DJ) and pulse width dispersion
performance. The ADCMP58x family of comparators provides
internal 50 Ω termination resistors for both V
P
and V
N
inputs.
The return side for each termination is pinned out separately
with the V
TP
and V
TN
pins, respectively. If a 50 Ω termination
is desired at one or both of the V
P
/V
N
inputs, the V
TP
and V
TN
pins can be connected (or disconnected) to (from) the desired
termination potential as appropriate. The termination potential
should be carefully bypassed using ceramic capacitors as dis-
cussed previously to prevent undesired aberrations on the input
signal due to parasitic inductance in the termination return
path. If a 50 Ω termination is not desired, either one or both
of the V
TP
/V
TN
termination pins can be left disconnected. In this
case, the open pins should be left floating with no external pull
downs or bypassing capacitors.
For applications that require high speed operation but do not
have on-chip 50 Ω termination resistors, some reflections
should be expected, because the comparator inputs can no
longer provide matched impedance to the input trace leading
up to the device. It then becomes important to back-match the
drive source impedance to the input transmission path leading
to the input to minimize multiple reflections. For applications
in which the comparator is less than 1 cm from the driving
signal source, the source impedance should be minimized. High
source impedance in combination with parasitic input capaci-
tance of the comparator could cause undesirable degradation
in bandwidth at the input, thus degrading the overall response.
It is therefore recommended that the drive source impedance
should be no more than 50 Ω for best high speed performance.
COMPARATOR PROPAGATION
DELAY DISPERSION
The ADCMP58x family of comparators has been specifically
designed to reduce propagation delay dispersion over a wide
input overdrive range of 5 mV to 500 mV. Propagation delay
dispersion is a change in propagation delays, which results
from a change in the degree of overdrive or slew rate (how far
or fast the input signal exceeds the switching threshold). The
overall result is a higher degree of timing accuracy.
Propagation delay dispersion is a specification that becomes
important in critical timing applications, such as data commu-
nication, automatic test and measurement, instrumentation,
and event-driven applications, such as pulse spectroscopy,
nuclear instrumentation, and medical imaging. Dispersion
is defined as the variation in the overall propagation delay as
the input overdrive conditions are changed (see Figure 26 and
Figure 27). For the ADCMP58x family of comparators, disper-
sion is typically <25 ps, as the overdrive varies from 5 mV to
500 mV, and the input slew rate varies from 1 V/ns to 10 V/ns.
This specification applies for both positive and negative signals,
because the ADCMP58x family of comparators has almost
equal delays for positive- and negative-going inputs.
Q/Q OUTPUT
INPUT VOLTAGE
500mV OVERDRIVE
5mV OVERDRIVE
DISPERSION
V
N
± V
OS
0
Figure 26. Propagation Delay—Overdrive Dispersion
Q/Q OUTPUT
INPUT VOLTAGE
10V/ns
1V/ns
DISPERSION
V
N
± V
OS
0
Figure 27. Propagation Delay—Slew Rate Dispersion
相關PDF資料
PDF描述
ADCMP580_05 Ultrafast SiGe Voltage Comparators
ADCMP580BCP-R2 Ultrafast SiGe Voltage Comparators
ADCMP580BCP-RL7 Ultrafast SiGe Voltage Comparators
ADCMP580BCP-WP Ultrafast SiGe Voltage Comparators
ADCMP581 Ultrafast SiGe Voltage Comparators
相關代理商/技術參數
參數描述
ADCMP580_05 制造商:AD 制造商全稱:Analog Devices 功能描述:Ultrafast SiGe Voltage Comparators
ADCMP580_07 制造商:AD 制造商全稱:Analog Devices 功能描述:Ultrafast SiGe Voltage Comparators
ADCMP580BCP 制造商:AD 制造商全稱:Analog Devices 功能描述:Ultrafast SiGe Voltage Comparator
ADCMP580BCP-R2 制造商:Analog Devices 功能描述:Comparator Single ±5.5V 16-Pin LFCSP EP T/R
ADCMP580BCP-RL7 制造商:Analog Devices 功能描述:Comparator Single ±5.5V 16-Pin LFCSP EP T/R
主站蜘蛛池模板: 南丹县| 上饶县| 公主岭市| 永安市| 会泽县| 喜德县| 隆子县| 安乡县| 迁西县| 承德市| 扬州市| 江川县| 久治县| 林周县| 长阳| 长春市| 五原县| 竹山县| 衢州市| 如东县| 枝江市| 河池市| 上思县| 太白县| 墨玉县| 揭西县| 广水市| 射洪县| 利川市| 抚松县| 扎赉特旗| 虎林市| 新化县| 富裕县| 大田县| 墨玉县| 清水县| 汽车| 丹东市| 贵溪市| 涿州市|