- 您現在的位置：買賣IC網 > PDF目錄373994 > ADL5519-EVALZ (Analog Devices, Inc.) 1 MHz to 10 GHz, 50 dB Dual Log Detector/Controller PDF資料下載
參數資料
| 型號： | ADL5519-EVALZ |
| 廠商： | Analog Devices, Inc. |
| 英文描述： | 1 MHz to 10 GHz, 50 dB Dual Log Detector/Controller |
| 中文描述： | 1兆赫至10 GHz，50分貝雙數檢波器/控制器 |
| 文件頁數： | 20/27頁 |
| 文件大?。?/td> | 479K |
| 代理商： | ADL5519-EVALZ |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
Preliminary Technical Data
ADL5519
TEMPERATURE COMPENSATION ADJUSTMENT
The ADL5519 has a highly stable measurement output with
respect to temperature. However, when the RF inputs exceed a
frequency of 600 MHz, the output temperature drift must be
compensated for using ADJ[A, B] for optimal performance.
Proprietary techniques are used to compensate for the temper-
ature drift. The absolute value of compensation varies with
frequency and circuit board material. Table 4 shows
recommended voltages for ADJ[A, B] to maintain a
temperature drift error of typically ±0.5 dB or better over the
entire rated temperature range with the recommended baluns.
Table 4: Recommended ADJ[A,B] Voltage Levels
Frequency
Recommended ADJ[A,B] Voltage
50 MHz
TBD
100 MHz
TBD
900 MHz
TBD
1.8 GHz
TBD
1.9 GHz
TBD
2.2 GHz
TBD
3.6 GHz
TBD
5.3 GHZ
TBD
5.8 GHz
TBD
8 GHz
TBD
Rev. PrB | Page 20 of 27
Compensating the device for temperature drift using ADJ[A, B]
allows for great flexibility. If the user requires minimum temper-
ature drift at a given input power or subset of the dynamic range,
the ADJ[A, B] voltage can be swept while monitoring OUT[A, B]
over temperature. Figure 22 shows the result of such an exercise.
The value of ADJ[A, B] where the output has minimum
movement (approximately 0.77 V for the example in Figure 22)
is the recommended voltage for ADJ[A, B] to achieve minimum
temperature drift at a given power and frequency.
Figure 22. OUTA vs. ADJA over Temp. Pin = 30 dBm, 1.9 GHz
The ADJ[A, B] input has high input impedance. The input can
be conveniently driven from an attenuated value of VREF using
a resistor divider, if desired.
Figure 23 shows a simplified schematic representation of the
ADJ[A, B] interface.
COMR
COMR
I
COMP
ADJ[A,B]
V
TADJ
VREF
ADL5519
Figure 23. ADJ[A, B] Interface Simplified Schematic
DEVICE CALIBRATION AND ERROR CALCULATION
The measured transfer function of the ADL5519 at 2.14 GHz is
shown in Figure 24. The figure shows plots of both output
voltage vs. input power and calculated error vs. input power. As
the input power varies from 50 dBm to 0 dBm, the output
voltage varies from 0.4 V to about 2.8 V.
Figure 24. Transfer Function at 2.14 GHz.
Because slope and intercept vary from device to device, board-
level calibration must be performed to achieve high accuracy.
The equation for output voltage can be written as
V
OUT
=
Slope
× (
P
IN
Intercept
)
Where
Slope
is the change in output voltage divided by the
change in power (dB), and
Intercept
is the calculated power at
which the output voltage would be 0 V. (Note that
Intercept
is a
theoretical value; the output voltage can never achieve 0 V).
In general, the calibration is performed by applying two known
signal levels to the ADL5519’s input and measuring the
corresponding output voltages. The calibration points are
generally chosen to be within the linear-in-dB operating range
of the device (see the Specifications section for more details).
Calculation of the slope and intercept is done using the
equations:
Slope
= (
V
OUT1
V
OUT2
)/(
P
IN1
P
IN2
)
Intercept
=
P
IN1
(
V
OUT1
/
Slope
)
相關PDF資料 |
PDF描述 |
|---|---|
| ADL5521-EVALZ | 400 MHz - 4 GHz Low Noise Amplifier |
| ADL5521 | 400 MHz - 4 GHz Low Noise Amplifier |
| ADL5521ACPZ-R7 | 400 MHz - 4 GHz Low Noise Amplifier |
| ADL5521ACPZ-WP | 400 MHz - 4 GHz Low Noise Amplifier |
| ADL5523-EVALZ | 400 MHz - 4 GHz Low Noise Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADL5519XCPZ | 制造商:Analog Devices 功能描述:PREPRODUCTION DEVICES ADL5519 - Trays |
| ADL5521 | 制造商:AD 制造商全稱:Analog Devices 功能描述:400 MHz - 4000 MHz Low Noise Amplifier |
| ADL5521_08 | 制造商:AD 制造商全稱:Analog Devices 功能描述:400 MHz - 4000 MHz Low Noise Amplifier |
| ADL5521ACPZ | 制造商:Analog Devices 功能描述:SINGLE LNA WITH LOW GAIN - Rail/Tube |
| ADL5521ACPZ-R7 | 功能描述:IC AMP LNA 4GHZ LOW NOISE 8LFCSP RoHS:是 類別:RF/IF 和 RFID >> RF 放大器 系列:- 標準包裝:3,000 系列:- 頻率:100MHz ~ 6GHz P1dB:9.14dBm（8.2mW） 增益:15.7dB 噪音數據:1.3dB RF 型:CDMA，TDMA，PCS 電源電壓:2.7 V ~ 5 V 電流 - 電源:60mA 測試頻率:2GHz 封裝/外殼:0505（1412 公制） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。