- 您現在的位置：買賣IC網 > PDF目錄373995 > ADM1020AR-REEL7 (ANALOG DEVICES INC) 8-Lead, Low-Cost, System Temperature Monitor PDF資料下載
參數資料
| 型號： | ADM1020AR-REEL7 |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 模擬信號調理 |
| 英文描述： | 8-Lead, Low-Cost, System Temperature Monitor |
| 中文描述： | SPECIALTY ANALOG CIRCUIT, PDSO8 |
| 封裝： | SOIC-8 |
| 文件頁數： | 9/12頁 |
| 文件大小： | 132K |
| 代理商： | ADM1020AR-REEL7 |
REV. 0
ADM1020
–9–
In the case of the ADM1020, write operations contain ei-
ther one or two bytes, while read operations contain one
byte, and perform the following functions:
To write data to one of the device data registers or read data
from it, the Address Pointer Register must be set so that the
correct data register is addressed, then data can be written
into that register or read from it. The first byte of a write
operation always contains a valid address that is stored in
the Address Pointer Register. If data is to be written to the
device, then the write operation contains a second data byte
that is written to the register selected by the address pointer
register.
This is
illustrated in Figure 12a. The device address is sent over
the bus followed by R/
W
set to 0. This is followed by two data
bytes. The first data byte is the address of the internal data
register to be written to, which is stored in the Address Pointer
Register. The second data byte is the data to be written to the
internal data register.
When reading data from a register there are two possibilities:
1. If the ADM1020's Address Pointer Register value is un-
known or not the desired value, it is first necessary to set it
to the correct value before data can be read from the desired
data register. This is done by performing a write to the
ADM1020 as before, but only the data byte containing the
register read address is sent, as data is not to be written to
the register. This is shown in Figure 12b.
A read operation is then performed consisting of the serial bus
address, R/
W
bit set to 1, followed by the data byte read from
the data register. This is shown in Figure 12c.
2. If the Address Pointer Register is known to be already at the
desired address, data can be read from the corresponding
data register without first writing to the Address Pointer
Register, so Figure 12b can be omitted.
NOTES
1. Although it is possible to read a data byte from a data register
without first writing to the Address Pointer Register, if the
Address Pointer Register is already at the correct value, it is
not possible to write data to a register without writing to the
Address Pointer Register, because the first data byte of a
write is always written to the Address Pointer Register.
2. Don't forget that the ADM1020 registers have different ad-
dresses for read and write operations. The write address of a
register must be written to the address pointer if data is to be
written to that register, but it is not possible to read data
from that address. The read address of a register must be
written to the address pointer before data can be read from
that register.
R/
W
A6
SCLK
SDATA
A5
A4
A3
A2
A1
A0
D7
D6
D5
D4
D3
D2
D1
D0
ACK. BY
ADM1020
START BY
MASTER
1
9
1
ACK. BY
ADM1020
9
D7
D6
D5
D4
D3
D2
D1
D0
ACK. BY
ADM1020
STOP BY
MASTER
1
9
SCL (CONTINUED)
SDA (CONTINUED)
FRAME 1
SERIAL BUS ADDRESS BYTE
FRAME 3
DATA BYTE
FRAME 2
ADDRESS POINTER REGISTER BYTE
Figure 12a. Writing a Register Address to the Address Point Register, then Writing Data to the Selected Register
R/
W
A6
SCLK
SDATA
A5
A4
A3
A2
A1
A0
D7
D6
D5
D4
D3
D2
D1
D0
ACK. BY
ADM1020
STOP BY
MASTER
START BY
MASTER
1
9
1
ACK. BY
ADM1020
9
FRAME 1
SERIAL BUS ADDRESS BYTE
FRAME 2
ADDRESS POINTER REGISTER BYTE
Figure 12b. Writing to the Address Pointer Register Only
R/
W
A6
SCLK
SDATA
A5
A4
A3
A2
A1
A0
D7
D6
D5
D4
D3
D2
D1
D0
NO ACK.
BY MASTER
STOP BY
MASTER
START BY
MASTER
1
9
1
ACK. BY
ADM1020
9
FRAME 1
SERIAL BUS ADDRESS BYTE
FRAME 2
DATA BYTE FROM ADM1020
Figure 12c. Reading Data from a Previously Selected Register
相關PDF資料 |
PDF描述 |
|---|---|
| ADM1021A | Low-Cost Microprocessor System Temperature Monitor |
| ADM1021AARQ | Low-Cost Microprocessor System Temperature Monitor |
| ADM1021 | Low Cost Microprocessor System Temperature Monitor |
| ADM1021ARQ | Low Cost Microprocessor System Temperature Monitor |
| ADM1022 | Low-Cost PC Temperature Monitor and Fan Control ASIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADM1021 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Cost Microprocessor System Temperature Monitor |
| ADM102-11/12VDC | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| ADM102-11/24VDC | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| ADM102-11/48VDC | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| ADM1021A | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:Low Cost Microprocessor System Temperature Monitor Microcomputer |
發布緊急采購，3分鐘左右您將得到回復。